Propagation of Monstera adansonii is not too difficult, like many other vining plants. Both water and soil can be used for this. It won’t grow as much as it would in soil, but you can leave it in water indefinitely if you like.
Monstera adansonii propagation in water
- Use clean scissors to make a cutting with a few leaves from the mother plant, cutting about 1/4 inch below a node, to propagate Monstera adansonii in water (this means the node is included on the cutting). The new roots will emerge from the nodes.
- Leave a few inches of stem bare by removing any bottom leaves.
- Make sure at least one node of the cutting is submerged in the water before placing it in the glass. Inspect the leaves to make sure none are submerged.
- The cutting should be placed where there is plenty of indirect light.
- Make careful to replace the water when it becomes murky and to top it off when you notice the level dropping.
- Within the first week or two, you should notice tiny roots emerging, but it can take a few weeks before you can plant your cutting into soil.
- Transfer the cutting to its permanent pot once the roots are a few inches long. According to my observations, the roots can be transmitted over a distance of two to three inches.
- After putting the cutting in its new pot, give it the same attention and watering that you typically would.
Monstera adansonii propagation in soil (method one)
Repeat the first step above in order to spread Monstera adansonii in soil. Here it is once more:
- Cut a few of leaves off the mother plant using clean scissors, about a quarter-inch below a node (this means the node is included on the cutting). The new roots will emerge from the nodes.
- Leave a few inches of stem bare by removing any bottom leaves.
- Now, bury at least one node of the cutting by placing it directly into moistened soil as opposed to submerging it in water. No leaves should be buried.
- As the roots grow, place the cutting in indirect light that is bright and maintain the soil moist but not damp.
- To further lock in the advantageous humidity, you can cover the top with a transparent plastic bag. Make careful to take the bag out once day to allow for fresh air.
- Be patient; it will take at least a few weeks before the cutting’s root system emerges and you see any new growth.
- You can test the cutting by giving it a very light tug a few weeks later. If you encounter resistance, the roots have established, and you can proceed as you would with any other plant.
Monstera adansonii propagation in soil (method two)
Another way to propagate Monstera adansonii (and other vining plants) is to lay the entire cutting on top of the soil with the nodes all pointing downward into the soil.
Instead of leaving the vine as one continuous vine, you can also break it into smaller portions and do this; just make sure each section has a node.
- If necessary, temporarily “fasten the vine or its portions to the ground using paper clips or bobby pins.
- As the roots grow, place the plant in indirect light that is bright and maintain the soil moist but not soggy.
This will also help the nodes that are in contact with the soil finally take root.
How long before planting should Monstera Adansonii roots be stored?
Without using soil or moss, water propagation enables you to grow new Monstera adansonii plants, making it simple and resource-efficient (besides water).
The cuttings can be susceptible to rot if not periodically examined, which is the sole drawback of this procedure.
Step-by-Step Instructions:
A healthy monstera adansonii stem with one to two nodes and one to two leaves is ideal.
The sharper the better, but between cuts, be sure to keep it clean and sanitized (isopropyl alcohol is the best). Any bacteria that is still on the blade can spread to the cutting, which will condemn you from the start.
Make sure that each node (the tiny brown bumps) is completely submerged in water. From here, roots will spread outward.
Any leaves that would be submerged should be cut off. Leaves should not be submerged since they will decay.
The cutting should be positioned in a warm, bright spot with lots of light and airflow.
If you can, replace the water once a week. For the first few weeks, it is crucial to give the roots new oxygen.
How Long Does it Take to Root in Water?
It is reasonable to conclude that you have successfully propagated a monstera adansonii in water if you have a few roots that are at least 4 inches long and perhaps a new leaf that has emerged after 4 to 6 weeks.
You’re free to transplant your cutting into the ground at this time because the root systems are ready.
Can a Monstera Adansonii Live in Water Forever?
A monstera adansonii can remain submerged for an unlimited period of time, but you must make sure it continues to receive enough sunlight and airflow.
This would not be a problem as long as your plant had plenty of room to produce new roots.
You will need to keep transplanting it into a bigger pot as the roots and new leaves continue to grow.
The Monstera adansonii, however, was kept in water for two years before being finally put in soil.
When can a Monstera cutting be transplanted?
After 3-5 weeks, the roots from your cuttings should start to grow. The new roots should be at least an inch long; this is the primary thing you want to check for. Your cutting is prepared to be planted into a pot once it develops several roots that size.
Can you immediately plant a Monstera cutting?
Stem cuttings are the preferred method of monstera propagation. Cuttings from Swiss cheese plants are simple to root. When using cuttings, you can either root them in water first or just bury them in the ground. Cuttings should be made immediately following a leaf node, with the bottom-most leaves removed.
Then, either partially bury the swiss cheese plant cuttings in the soil itself or root them in water for a few weeks before transplanting to a pot. There is no requirement for rooting hormone because they root so readily.
How do you sow Monstera seeds in soil?
Many people think that water propagation is the best or even the sole method for growing a new Monstera deliciosa from a cutting. However, a Monstera cutting can be grown in soil without first establishing the roots in water. Both approaches are effective, though many plant owners pick the approach they believe gives the most benefits.
It is simple to grow Monstera deliciosa from seed in soil. Simply take a healthy Monstera cutting with at least one node, and plant it into potting soil with good drainage. By using soil to root Monstera cuttings instead of water, the subsequent step of transferring the rooted cutting into soil is avoided.
People prefer to grow their plants in soil rather than water for a variety of reasons. Some people might discover that employing soil propagation is a simpler process or that their Monstera produces new growth more quickly. Some people have curious cats that won’t leave a water container alone. Additionally, some owners of indoor plants simply want to experiment with new methods of growing this well-liked plant.
How long before putting Monstera roots in soil should they be?
You should plan on giving your Monstera cutting around 6 weeks before planting it in soil so that roots can form.
In order to guarantee a strong root system has established for a better chance of survival, I often advise waiting at least 2-3 months.
However, as long as you change the water frequently, clean the roots, and transfer the cutting into a larger jar as it grows, a Monstera can survive in water for many months (if not years).
It is prepared to be put in soil when a lovely cluster of roots fills your container.
You can plant your Monstera cutting as long as it has five roots that are at least several inches long.
Keep the Roots Clean
Keep an eye on the roots as they grow every week, and don’t be hesitant to cut off any sections that seem unhealthy.
You can clip out roots that appear to be rotting as long as there are numerous healthy-looking roots (white, yellow, light green, and light brown).
These are typically distinguished from the others by being dark, mushy, or significantly more slimy.
How long before planting should roots be present?
Over the years, I’ve done a lot of propagation. I evaluated various root lengths for transfer to soil and developed this “green thumb” criterion for the greatest likelihood of success.
When may you plant a plant that was propagated?
The cutting is prepared for potting when the roots are at least 1-2 inches long. This plant is ready to be transplanted into a pot with potting soil because it has dense roots.
Which is preferable for Monstera propagation—soil or water?
Even while Monstera cuttings are generally fairly tolerant of the growing medium, location, and conditions, there are still a few things you may change to boost your chances of success or hasten your progress.
Time of year
It is not necessary to timing when you take a cutting, but keep in mind that winter, when plants are often dormant, may cause your cutting to start more slowly.
Time frame
The first thing to stress is the importance of patience. Some cuttings will immediately take root and quickly produce new leaves. Others may experience a protracted period of inactivity. Spring will frequently revive cuttings that had been dormant.
The best way to determine if your cutting is still in good shape while doing nothing is described below.
Light and warmth
Monstera cuttings thrive in warmth and light, and they will grow the quickest on a warm, sunny windowsill. It has been said that Monstera cuttings should be started with a heat pad, but in my experience, that is not true. A heat pad, however, could perhaps hasten the growth process.
Moisture
If they are in soil, they must also be maintained gently damp but not wet—wet feet are bad for them and will cause them to decay. Once a week, check their soil and, if it feels dry, give it a little water. It is not necessary to place a plastic bag over them, as is occasionally advised.
Size of cutting
More nodes and longer or larger stem sections tend to produce more new growth, including several new stems. Given that Monstera is a vine plant with a single long stem, this is significant. If your cutting produces leaf sprouts on several nodes, each of these will grow into a stem, resulting in bushier growth at a small size.
Growing medium
The benefit of propagating in water in a glass jar is that any new growth is visible right away. However, it is usually advisable to plant larger cuttings directly in the ground if they have leaves and aerial roots.
Water choice
You can use conventional tap water, but if it’s particularly hard, use caution and avoid using water that has been artificially softened. Both rainwater and distilled water are acceptable. If you submerge the majority of the stem part in water, leaves and roots will grow rather happily.
Soil mix
Use a light, freely draining potting compost when young plants and a more hummus-rich mixture as they mature.
Planting stems vertically with just the top inch above the soil is the simplest and most space-efficient approach to pot cuttings in soil.
I was concerned that for new leaves to grow, some stem nodes would need to be above the surface, but that wasn’t the case at all. Under the soil surface, new leaves began to emerge and easily pushed their way to the surface to spread out.
Potting up
If you have many stem cuttings that are housed in the same pot, you should separate them as soon as new growth appears. My own experiences indicate that, if handled correctly, Monstera are fairly resilient and don’t mind being disturbed.
You can bury the entire original stem cutting for a neater appearance rather than having to leave any of it above the soil line.