Taking an active, healthy leaf from a mature succulent plant and utilizing it to establish a new plant is known as “propagating with leaf cuttings.” Because the leaves of succulents with fleshy, plump leaves, like echeveria, are simple to snap off cleanly, this method of propagation works well with them.
While some leaves may simply pop off with a little tug, others could necessitate the use of a sharp knife. Take a healthy leaf from the plant’s base with clean hands or a sterile knife, making sure to remove the full, undamaged leaf.
When the leaf has calloused over, prepare a fresh planter with soil, wet it, and set the leaf on top of the soil for propagation. After the leaf has been removed, let it to heal in a warm environment with bright light for about four days to allow the “wound to callous over.
When the soil is dry, sprinkle your leaves with a spray bottle, and remember to keep them warm, with lots of strong light, but not in direct sunlight.
A succulent may take several months to grow large enough for repotting (the photographs above were taken after around 8 weeks), but you’ll know it’s time when the leaf ultimately goes brown and comes off, indicating that the succulent has gotten all of the nutrients from the leaf and no longer needs it.
How are succulent cuttings transplanted?
Agave, Yucca, Sansevieria, Haworthia, Aloe, Echeveria, and Sempervivum are just a few examples of succulents that grow in rosettes and are simple to split into new plants by cutting off tiny offsets coming from their base or from short rhizomes. The popular long-stemmed and branched succulents Aeonium, Crassula, Euphorbia, Hoya, Kalanchoe, Sedum, and Senecio can all be quickly obtained by growing succulents from cuttings.
It’s simple to grow succulents from stem cuttings. Cut the mature stems off at the tips or ends; the original plants’ bare stems will immediately produce new stems. Over the course of a few days, let the cut ends dry and heal.
Wait a few days to plant succulent cuttings in new soil, or water those you plant right away, before doing so. Succulent cuttings can be planted without them decaying by placing them in a well-drained rooting mix, which solves the problem. By adding coarse sand or perlite, any commercial cactus mix or decent potting soil may be made better drained; typically, a one-to-one ratio of potting soil and drainage material is good to start with.
Gather Your Succulents To Plant
For this video, we’ll be planting a variety of succulent species using both cuttings and discarded leaves. Gather together what you would like to plant. You can either utilize fallen leaves or cut cuttings from an established plant. If you can’t locate cuttings anywhere else, you can usually find them online and at most florists. Although these are also available on Amazon, I got mine from a vendor on Etsy.
Prepare your succulents for planting.
The most crucial step in this method is preparing your succulents. Make sure you have enough stem to plant in the ground so it can support the plant. Any excess leaves at the stem’s base should be removed. It’s good to leave approximately an inch of the stem exposed for larger cuttings, and you can use less for smaller cuttings.
After that, examine the base of your cutting. The plants ought to have a “callous” on them, which denotes that the plant’s base has dried out. You should wait a few days before planting freshly cut succulents because this forms a few days after the succulent is cut. By letting the cut end dry more quickly on a paper towel or paper bag, you can hasten this process.
Succulents are wonderful because you can also plant their leaves, so hold onto the ones you pulled off the stem. Verify your succulents for any bad components. Any area of the plant that is dark contains rot, which can spread to other areas and ultimately destroy the plant. Simply cutting it will allow you to get rid of the rotten parts.
Mix your soil.
If you aren’t using a pre-made succulent soil mix, you’ll need to prepare your soil so that it will drain effectively and support the growth of your succulent plants. To make the soil drain well, I combine one part potting soil with one part sand. In order to help larger plants become more firmly rooted in the ground, I also prefer to have a supply of tiny rocks nearby.
To fill a pot or tray, pour your soil mixture. I’m repurposing an old baking pan that I can’t bake in as a planting tray.
Plant!
We’ve reached the enjoyable part now! Make a little, inch-deep hole in the ground. After inserting your cutting, fill up the depression with soil.
Make careful to space your cuttings, if you’re planting more than one, roughly 2-3″ apart.
Ensure that your plants receive adequate water. Although succulents don’t often require much water, you may need to water them every 2-4 days while they are developing their roots, depending on how dry the soil becomes. It’s normal for the leaves to initially appear a little dried out because the plant is using its reserves of stored energy to develop new roots. New growth should begin to appear in around four weeks. Change to weekly watering or watering only when the soil is dry once the plants have set their roots and have started to grow.
Admire and Show Off Your Work!
Well done! Show off your incredible craftsmanship and green thumb to all of your friends! These plants will be prepared for repotting if you desire once they have developed roots and begun to grow, which should take around 3 to 6 weeks. They make wonderful Christmas gifts for friends and coworkers when planted in a tiny Mason jar or vibrant pot!
Prepare the Pot
Cuttings can be grown in a temporary pot while they develop roots, or you can just plant them in a permanent container. In either case, you’ll need a pot with a drainage hole that’s big enough to give each cutting 2 to 3 inches of space.
To shield your succulents from standing water and root rot, fill the container with a grittier, well-draining soil. Cactus/succulent potting soil is typically available at garden centers. Alternatively, you can create your own by mixing 3 parts potting soil with 2 parts coarse, salt-free sand and 1 part perlite or pumice.
Plant the Cuttings
Insert the cut end of a stem 1 to 2 inches into the ground. If the succulent has leaves, you might need to remove a few of them to reveal the stem’s base. The lowest leaves shouldn’t contact the soil; they should rest just above it. To help the cutting stand straight, softly compact the dirt around it.
Remove any necessary leaves from stemmed succulents to expose 1 to 2 inches of stem for planting.
Pick the Right Location
Choose an area with enough of airflow, bright indirect light (not direct outdoor sun), and succulents that are still young. Cuttings require sunshine to develop new roots, but direct sunlight might cause them to quickly dry up. On indoor succulents, good airflow helps avoid gnat and mealy insect infestations.
Water
Cuttings require constant hydration until they can form roots, unlike mature succulents. Water the soil just enough to prevent it from drying up, but not too much that there is standing water. Actual frequency varies depending on humidity and temperature but is often 2-4 times each week.
Care for Rooted Succulents
A very slight pull will reveal whether a cutting has roots after 4-6 weeks. Change to deeper, less frequent watering for succulents with roots. Water just once the soil is completely dry, which takes about 2-4 times each month. If necessary, repot the succulent and relocate it gradually to the right lighting. Don’t increase light exposure for 1-2 weeks to give the plant time to adjust. Maintain your succulent’s care, and in the upcoming months, keep an eye out for above-ground development.
Can you put succulent cuttings directly into the ground?
Aeoniums can grow enormous and get “weary,” and the best course of action is to remove them and transplant some cuttings. Make sure the offcuts from pruning succulents like aeoniums are long enough to allow them to stand upright when replanted.
- Starting with the tips, trim the stem, leaving at least 15–20 centimeters of stem.
- After removing the parent plant, set the cuttings aside. These plants have relatively shallow roots, making it simple to pull them out of the ground.
- About 20 cm of a trench should be dug, into which the cuttings should be placed and then backfilled to support them.
- In the summer, the cuttings can be planted straight in the ground. For about a week, don’t water the cuttings to let the base dry up. Before planting them during the cooler months, let them sit out of the ground for a week.
- The cuttings will begin to take root in about a month, and then the tops of the cuttings will begin to grow.
Leaf cuttings can be used to multiply Pachyveria. By removing a lower leaf, you can tell if the plant will grow from leaf cuttings. It might be able to produce new plants if it comes off without damaging anything. The leaf won’t grow if it breaks, creating a “fleshy cut.”
- Prepare a tray with a combination of succulent and cactus.
- Starting at the base and working outward, carefully remove the leaves while holding the rosette by the stem. You may also plant this rosette as a cutting, so leave a few leaves on it.
- Make sure there is enough of airflow around the leaves as you arrange them on top of the soil. Make sure the dish-side up is towards the bud (where the leaf joined the stem), which should be left above the soil.
- The bud end will begin to develop a small rosette cluster in two to three weeks. As the roots will grow from this end, make sure to maintain it close to the ground.
- The buds can be removed from the tray and placed in a container or planted directly into the ground after they are big enough to pluck out (and have many leaves).
How long does it take a cutting of a succulent to take root?
Succulents can be propagated in water, but doing so goes against the ideal growing circumstances for these plants. Start your leaves and cuttings in shallow planting trays or tiny containers packed with potting soil for the best outcomes. Succulents can be grown in individual containers without having to transplant them right away.
Follow these easy steps once planting day arrives and your leaf or stem cuttings have callused:
1. Get your planting trays or containers ready. Use a coarse, quick-draining potting mix made for succulents and cacti and gently moisten it. 2 Make planting holes with a little stick.
2. Add a little RootBoost Rooting Hormone to a serving dish. When pouring, only utilize what you’ll need and discard the remainder.
3. Cut one piece at a time. Wet the cutting stem or leaf base before dipping it into the dish of rooting hormone. Completely round the stem or leaf base. Get rid of any extra rooting powder by shaking.
4. Carefully tuck leaves or stems into the rooting powder so it doesn’t fall out. The potting mix should then be carefully pressed around the cuttings.
- Insert the base at an angle just below the soil line to accommodate leaves. Put curled leaves in an upwards-curving position. (On that side, the new tiny plant grows.)
- Insert the bottom half of the stem into the potting mix so that it covers at least two bare nodes when taking stem cuttings.
5. Wait until roots start to form before watering. Once the dirt has dried, give it a good watering before repeating the process. The majority of succulent leaf and stem cuttings should root in two to three weeks, while rooting times might vary greatly. The fastest-rooting cuttings are those from stem tips.
6. After the roots have taken hold, transplant your new succulents from trays to tiny containers. Use the same kind of potting soil as you did previously. Be careful not to disrupt young, delicate roots.
How can you root succulents the quickest?
So, you may be wondering how to quickly propagate succulents. I can relate to both the joy and frustration of watching a new plant develop.
Since I’ve been growing succulents for a few years, allow me to give you some advice on how to quickly propagate your succulents as well as some alternative techniques you can try.
Stem cuttings are the simplest and quickest method of propagating succulents. If the plant is a fresh cutting from the mother plant, it will already have a strong foundation from which to build its new root system. Another instance is when you cut off the succulent’s top portion because it has been stretched out significantly (etiolation), this stem will likewise give rise to numerous new plantlings (pups). Due to its existing root system, the plant will also have a great possibility of producing more offset and growing quickly.
Always check that the stem cuttings are a respectable size for the plant’s typical size.
According to my experience, I always want to make sure that the succulent has a lot of nodes where the leaves attach to the stem and a lot of leaves in its stem. Once the succulent is put in soil, these stem nodes will form roots, and the leaves will serve as the succulent’s water source until its root system matures.
Can you replace a succulent after cutting off the top?
Your succulent won’t appear as stretched out and leggy when you remove the top and transplant it in soil. Grab a good pair of gardening shears or a knife. Additionally, you should put on gloves. Succulents can irritate your skin since some have milky sap while others have thorns.
Succulent stems may be buried.
When cultivated in the right lighting conditions, succulents adore the sun and thrive. However, you’ve probably cultivated or observed a lanky, stretched-out succulent. In the area you have, these lanky or etiolated succulents aren’t getting the proper amount of light.
Not just succulent indoor plants experience this behavior. You may have seen how your plant stretches to reach as close to the sun as it can by bending toward it. As they extend toward the sun, succulents get taller and spread their leaves farther apart.
The compact shape of etiolated succulents won’t return, but you can give them a trim and grow additional succulents from the cuttings.
How to disassemble the plant and begin reproducing it in order to try again is demonstrated in this video by Laura from Garden Answer.
- Clear the foliage. Cut the roots and wholesome leaves from the succulent’s bottom half with pruners or by snapping them off. Get a break that is as spotless as you can to promote new growth. Get rid of your leaf if it tears. Up to a little bit after halfway up, remove leaves. To understand how to cut the stem and transplant it with the remaining rosette at the top, see to step three.
- Dry the leaves. After removal, let the leaves dry for a few days or until the raw ends have calloused.
- Replant the stem. New roots will be able to sprout if the stem is planted farther below where the leaves were removed. Simply clip the stem 1-2 inches from the plant’s base if it is too long for the pot. It’s alright if you have no stem at all. Simply bury the rosette in the ground to prevent it from falling out.
- Prepare to expand. A tray, saucer, or other container containing Espoma’s Organic Cactus mix should have dried leaves on top of it. Avoid burying leaves in the ground. Put the container in a location that will shield it from direct sunlight.
- Spray the ground until it is damp but not soaked. When the soil seems dry to the touch, rehydrate it.
- Wait. There will be new baby roots that appear in about a month.
- Replant. You can replant your propagated succulents once they have established roots. Put them on display in a recycled planter.
- The roots should be examined every six months to determine whether you need to transfer your plants to a larger pot. Espoma’s Cactus can be used to routinely feed your succulents. For optimal results, use liquid plant food.