Taking an active, healthy leaf from a mature succulent plant and utilizing it to establish a new plant is known as “propagating with leaf cuttings.” Because the leaves of succulents with fleshy, plump leaves, like echeveria, are simple to snap off cleanly, this method of propagation works well with them.
While some leaves may simply pop off with a little tug, others could necessitate the use of a sharp knife. Take a healthy leaf from the plant’s base with clean hands or a sterile knife, making sure to remove the full, undamaged leaf.
After being removed, allow the leaf to recover for about four days in a warm, well-lit place so that the wound can callus over. When the leaf has calloused, prepare a fresh planter with soil, fill it with water, and set the callused leaf on top of the soil for multiplication.
When the earth is dry, spritz your leaves with a spray bottle. Keep them warm, in a room with lots of light, but out of direct sunlight. They must be kept warm and moist.
Little roots and leaves will start to emerge after around three weeks! A succulent may need a few months to grow large enough to be replanted (photos above are after about 8 weeks). When the leaf eventually gets brown and falls off, you’ll know it’s time. This indicates that the succulent no longer requires the leaf because it has consumed all of its nutrients.
Gather Your Succulents To Plant
For this video, we’ll be planting a variety of succulent species using both cuttings and discarded leaves. Amass the materials you want to plant. You can either utilize fallen leaves or cut cuttings from an established plant. If you can’t locate cuttings anywhere else, you can usually find them online and at most florists. Although these are also available on Amazon, I got mine from a vendor on Etsy.
Prepare your succulents for planting.
The most crucial step in this method is preparing your succulents. Make sure you have enough stem to plant in the ground so it can support the plant. Any excess leaves at the stem’s base should be removed. It’s good to leave approximately an inch of the stem exposed for larger cuttings, and you can use less for smaller cuttings.
After that, examine the base of your cutting. The plants ought to have a “callous” on them, which denotes that the plant’s base has dried out. You should wait a few days before planting freshly cut succulents because this forms a few days after the succulent is cut. By letting the cut end dry more quickly on a paper towel or paper bag, you can hasten this process.
Succulents are wonderful because you can also plant their leaves, so hold onto the ones you pulled off the stem. Verify your succulents for any bad components. Any area of the plant that is dark contains rot, which can spread to other areas and ultimately destroy the plant. Simply cutting it will allow you to get rid of the rotten parts.
Mix your soil.
If you aren’t using a pre-made succulent soil mix, you’ll need to prepare your soil so that it will drain effectively and support the growth of your succulent plants. To make the soil drain well, I combine one part potting soil with one part sand. In order to help larger plants become more firmly rooted in the ground, I also prefer to have a supply of tiny rocks nearby.
To fill a pot or tray, pour your soil mixture. I’m repurposing an old baking pan that I can’t bake in as a planting tray.
Plant!
We’ve reached the enjoyable part now! Make a little, inch-deep hole in the ground. After inserting your cutting, fill up the depression with soil.
Make careful to space your cuttings, if you’re planting more than one, roughly 2-3″ apart.
Ensure that your plants receive adequate water. Although succulents don’t often require much water, you may need to water them every 2-4 days while they are developing their roots, depending on how dry the soil becomes. It’s normal for the leaves to initially appear a little dried out because the plant is using its reserves of stored energy to develop new roots. New growth should begin to appear in around four weeks. Change to weekly watering or watering only when the soil is dry once the plants have set their roots and have started to grow.
Admire and Show Off Your Work!
Well done! Show off your incredible craftsmanship and green thumb to all of your friends! These plants will be prepared for repotting if you desire once they have developed roots and begun to grow, which should take around 3 to 6 weeks. They make wonderful Christmas gifts for friends and coworkers when planted in a tiny Mason jar or vibrant pot!
Can you put succulent cuttings directly into the ground?
Aeoniums can grow enormous and get “weary,” and the best course of action is to remove them and transplant some cuttings. Make sure the offcuts from pruning succulents like aeoniums are long enough to allow them to stand upright when replanted.
- Starting with the tips, trim the stem, leaving at least 15–20 centimeters of stem.
- After removing the parent plant, set the cuttings aside. These plants have relatively shallow roots, making it simple to pull them out of the ground.
- About 20 cm of a trench should be dug, into which the cuttings should be placed and then backfilled to support them.
- In the summer, the cuttings can be planted straight in the ground. For about a week, don’t water the cuttings to let the base dry up. Before planting them during the cooler months, let them sit out of the ground for a week.
- The cuttings will begin to take root in about a month, and then the tops of the cuttings will begin to grow.
Leaf cuttings can be used to multiply Pachyveria. By removing a lower leaf, you can tell if the plant will grow from leaf cuttings. It might be able to produce new plants if it comes off without damaging anything. The leaf won’t grow if it breaks, creating a “fleshy cut.”
- Prepare a tray with a combination of succulent and cactus.
- Starting at the base and working outward, carefully remove the leaves while holding the rosette by the stem. You may also plant this rosette as a cutting, so leave a few leaves on it.
- Make sure there is enough of airflow around the leaves as you arrange them on top of the soil. Make sure the dish-side up is towards the bud (where the leaf joined the stem), which should be left above the soil.
- The bud end will begin to develop a small rosette cluster in two to three weeks. As the roots will grow from this end, make sure to maintain it close to the ground.
- The buds can be removed from the tray and placed in a container or planted directly into the ground after they are big enough to pluck out (and have many leaves).
What should you do if your succulents multiply?
As it is simpler than using leaves or stem cuttings, the majority of succulent parents prefer to propagate their offspring via offsets. Offsets make for incredibly simple and straightforward propagation, making it ideal for individuals who don’t want to wait for the plant to develop leaves. Succulents like the Haworthia are ideal for this technique.
It is strongly advised to hold off until the offsets are around half the size of the parent plant to make sure they have the nutrients they need to live after being cut off from the parent plant. In order to find the rooted offset from the parent plant, you might want to start by thinking about removing the plant from its container. This is also an opportunity to repot the plant and check the root structure. Then, just twist the offset to remove it from the mother succulent’s roots. If some roots are torn, it won’t matter because the offset will have an opportunity to build its own roots. After removing the offsets successfully, allow them to dry for one to one day. After they have dried out, put them in cactus soil that drains well and water them thoroughly.
Cutting off the offset’s stem or plucking offsets from the parent plant with roots are two ways to propagate from offsets. Therefore, scroll up to read our instructions on how to take a correct cutting if you want to try doing it using stem cuttings. Use only sterilized pruning implements at all times. Place your cuttings in a well-drained potting mix after allowing them to dry completely. Within a few weeks, roots ought to develop.
Maintaining the offsets is really easy. To prevent etiolation or sunburn, you should give them a few hours of morning sunlight or afternoon shade. One piece of advice is to only water them thoroughly when the soil is absolutely dry.
And voilà! That is how you successfully develop your own succulent garden and propagate your succulents. Not too difficult, am I right? To determine the ideal amount of light and water that works for your succulents and encourages new development, we suggest you to experiment with a variety of leaves and stem cuttings. Tell us how your propagation process is going!
Watch this little video to learn how to avoid four mistakes while cultivating succulents.
You may read more about propagating succulents in the following articles:
How can water from propagating succulents be transferred to the soil?
It is strongly advised to wait until the cutting has at least an inch-long root or the mother leaf has begun to dry up before leaving it to air-dry on a paper towel for approximately a day or two if you wish to transfer or transplant your succulents from water to soil. Remember that water roots are far more delicate than soil roots, so handle them carefully and acclimate them to soil gradually.
When the roots are completely dry, gently bury your succulent in unfertilized cactus soil and place it in a spot with only bright, indirect light. Giving your succulents direct sunlight at this time is not advised because they are still delicate.  
From this point on, it is advised to water your succulent on a regular basis. Every two weeks, a thorough soak would do.
Watch this video to learn about succulent water propagation:
See some of the most frequently asked questions about propagating succulents and cacti in this little video.
How should a propagated plant be planted?
The simplest method for growing plants with stems at the base.
- Plant should be taken out of container.
- Use a knife or your fingers to cut the plant into smaller pieces.
- Verify the roots of each division.
- In appropriate containers, replant.
How frequently do I need to water baby succulents?
Only water succulents when the soil has totally dried up. There isn’t a standard watering schedule that applies to all succulents in all environments.
Many indoor succulent growers discover that watering their plants every 14 to 21 days keeps them healthy. Use this timeline as a guide and make adjustments if necessary.
The earliest symptoms of underwatering on the leaves are the greatest time to water your succulents. To see what that looks like, have a look at the cheat sheet above.
The best course of action is to wait for a signal from your succulent before watering because most succulents are particularly susceptible to rot with regular watering.
And keep in mind how crucial it is to monitor your watering routine. I can’t tell you how many times I’ve assumed that I haven’t watered in a while, just to discover that it was only a few days ago thanks to my notes in the Succulent Tracker app (Apple | Android).
In this video, learn about a several factors that could influence how frequently you water your succulents:
How is a succulent puppy transplanted?
When a plant produces pups or offspring, it is essentially replicating itself. Succulents don’t always produce pups and offspring, but those that do essentially grow in numbers on their own. Among the numerous additional species that give birth to pups or offspring are hens and chicks, aloe, specific haworthia species, and cacti.
The pups and offshoots can be carefully removed, put in a suitable potting mix, and used to begin a new plant. By redirecting energy to the growth of the mother plant instead of supporting her pups, removing offshoots from the mother plant promotes its health.
Step 1
Look for plants that have pups or offspring. The young that develop from the mother plant are called pups and offshoots. Not every succulent plant gives birth to pups or offspring. Aloe, certain haworthia and cactus species, as well as many succulent species, do.
Step 2
Clean your knife. Make use of a clean, disinfected, sharp knife. Washing with warm, soapy water or wiping with rubbing alcohol will do this. To prevent spreading fungus or infections, be sure to clean the knife after each cutting by wiping it with alcohol.
Step 3
Locate pups or offspring that need to be removed. An offshoot or pup can be separated from the mother plant once it has reached a suitable size or begun to establish roots. When removing the pup, try to grab some roots. A pup without roots can be removed, but ones with roots that are already there will work much better. Without roots, pups or offshoots will ultimately establish roots on their own, but pups and offshoots with established roots stand a better chance of surviving on their own.
Step 4
Eliminate the branch. To gently remove the pup or branch from the mother plant, use a clean knife. Some pups or offspring are simpler to get rid of than others. The pup can occasionally be gently twisted off to separate them.
Sometimes you need to remove the pup using a sharp tool. By sliding the knife blade between the mother plant and the offshoot, carefully detach the baby plant from its mother plant. Sever the root that connects the pup to the parent plant before carefully pulling the two apart.
Insert the knife blade into the soil between the mother plant and the offshoot if you want to remove the pup while it’s still in the ground. To cut the connecting roots, slide the blade through the dirt. Then, using the sharp end of a small shovel, dig a few inches along the radial parameter after creating a 2-inch radius in the dirt around the base of the branch. By angling the spade underneath the offshoot, you can delicately pry it out of the ground to remove it.
Step 5
Set the pup down. The pup can be planted on its own after being removed. Prepare an appropriate, well-draining potting mixture, then add some of it to a tiny container. Put the pup or offspring in the ground. As soon as the plant is secure, lightly pack the earth around it.
Step 6
occasionally use water. More moisture is required by pups and offspring than by mature plants. Spray the soil with a spray bottle sparingly once every few days or whenever it seems dry. Reduce watering to once a week after the plant has a stronger root system.
Step 7
Keep away from the sun’s rays. When first planted in their own pot, shield young plants from direct sunshine to avoid sun damage. As a plant matures, gradually increase sunshine and sun exposure in accordance with the needs of the plant.