How To Propagate Thanksgiving Cactus In Water

Water should be added to the jar, vase, or other small vessel that will be used as a rooting vessel.

Place the cutting into the water with the cut end down until two nodes are immersed. This is the best approach to root a Christmas cactus in water.

Leave the cutting in the jar, vase, or container for a few days so that the roots can form in bright, indirect sunlight (either indoors or outdoors). When roots have formed, wait for another 6 to 8 weeks or more while carefully monitoring the water level for the roots to extend as far as the cutting. If extra water is required, add it, making sure the two nodes are always submerged.

How are Thanksgiving cactus propagated?

The plants are simple to multiply and propagate. Cut a stem with four to five pieces and leaves off. After applying fungicide to the end, let it stand for a week in a dry area. Vermiculite or perlite combined with potting soil should be placed in a small clay pot. You can also use moist sand as an alternative.

Place the pot in bright but indirect light and press the calloused end into the mixture. Remove the plastic bag covering the cutting for an hour each day to let air to enter. The cutting will have taken root and you will have a brand-new plant in about 3 weeks.

Is it possible to grow cacti in water?

It’s time to get your cutting ready for planting in a pot once it has dried! Cactus propagation can potentially be done in water, just like with other houseplants, but it’s not a very usual procedure because they thrive in soil.

Your brand-new cutting will require excellent drainage to survive, much like other cacti (unless it’s a jungle cactus like the Christmas cactus). The roots of cacti have not developed to become used to extended wet periods. They enjoy a cool splash, but the soil shouldn’t be prone to being wet or humid afterward; instead, it should immediately dry out again.

It’s not too difficult to spot an excellent cactus soil because it will be grippy and contain little to no potting soil at all. You can either purchase a prepared cactus soil combination or create your own by mixing 1 part potting soil, 1 part perlite, and 1 part orchid bark (not too gritty) for your cutting.

As far as planters go, as long as they have proper drainage, you should be set to go. Standard plastic nursery containers are excellent, but some cactus growers like to use clay planters to provide even more drainage. Water can really evaporate through the walls of this substance since it is porous.

Advice: Visit the article on planting succulents indoors for further details on how to grow succulents like cacti.

How much time does the Christmas cactus take to root in water?

Your Christmas cactus will require some time to establish its roots. It won’t happen immediately!

It will take roughly two to three weeks to successfully root. It’s time to move your now-rooted cuttings into a container so your cactus can begin to grow once you see the roots beginning to sprout.

You want to keep your cutting moist but not drenched during the roots process. They require sunlight, but not too much.

It’s not difficult to propagate a Christmas cactus, but it can involve some trial and error. Try again if you don’t succeed the first time.

Do Thanksgiving cacti enjoy misting?

The Thanksgiving Cactus enjoys occasional mistings of water. These plants don’t require weekly watering, although sporadic watering and more regular misting are both highly beneficial to them.

Is it better to grow succulents in soil or water for reproduction?

Using water as a medium to root succulent cuttings is known as water propagation. This may contradict popular perceptions of succulents. The general consensus is that succulent plants dislike sitting in water and that doing so encourages root rot.

Therefore, water propagation may go against what we have learned to be true about nurturing and propagating succulents. However, lately I seem to be hearing more and more about water propagation.

According on what I have heard and read, some people believe water propagation to be simpler than more “standard” techniques like roots on dry medium or soil.

I’ve heard a lot of success tales from folks who used water propagation after trying succulent propagation unsuccessfully for a long time. In fact, some people solely reproduce succulent cuttings using water because they see quicker outcomes and more overall success.

According to one notion I’ve heard, succulent cuttings don’t rot in water since water isn’t the main source of rot. When succulent plants are left in moist soil, they are exposed to fungi and other pathogens that can cause illnesses and root rot in the plant. The plants do not decay when propagating in water because they are not exposed to the pathogens that are often found in the soil media.

The fact that the roots generated in water are different from those required for a plant to thrive in soil is another worry people have regarding water propagation. They need to create new roots that are better suited for thriving in soil after they are planted. Others who propagate in water, however, claim that the plants flourish when transferred from water to soil.

As someone who has had excellent success with “soil propagation,” I decided to conduct an experiment to find out how water propagates. To see what might happen, I tried soaking three stem cuttings in water. I picked two distinct plants that I had no trouble establishing in soil. I reasoned that picking a plant that is simple to grow would increase my chances of success. I used stem cuttings from the aeonium (blushing beauty) and the jade (crassula ovata) plants.

The water was placed in three Mason jars, which I covered with clear plastic and punctured in the middle of. I used drinking water that has been treated. Some individuals drink simple tap water. Others have reportedly used distilled water. I didn’t enrich the water with any nutrients. This is not required, based on what I’ve read.

The three stem cuttings were then placed on the jar’s rim with their tips resting directly on the water. When rooting in water, there are two main approaches that people take. One way is to sit the end of the cuts slightly above the surface of the water. The reason for this is because the cuttings will start looking for moisture and roots. Another approach is to actually let the cuts’ ends touch the water. Although both procedures appear to be effective, I opted for the second one.

I placed the cuttings in a well-lit spot and made an effort to ignore them for a few weeks. The cuts still look the same as I had left them when we returned from a family holiday two weeks later. No roots developed. I just left them alone and kind of forgot about them because the water didn’t seem to need to be refreshed or changed.

I was surprised to notice that the two jade cuttings had a lot of pink roots after another two weeks (a total of roughly four weeks).

Six weeks after the experiment’s start, the jade plants continued to grow more roots while the aeonium remained unchanged.

I took the roots cuttings out of the water and placed them on paper to dry for approximately a day after deciding that it was time to transplant them into soil after around 6 weeks. All three stem cuttings appeared healthy and were not rotting.

The next test will be to evaluate how these cuttings fare in soil after spending five weeks in water and developing water roots. After five weeks, the aeonium cutting hardly developed any roots, but I will still plant it in soil. Since I have grown several aeonium cuttings in soil before, I am almost convinced that this will flourish once planted.

I made a cactus mix and perlite mixture and put the potting mix in little pots. After that, the stem cuttings were placed inside the pot.

The same care is given to these potted cuttings as I do to my other stem cuttings. Keep them in a spot with plenty of light, but shield them from the hot afternoon heat or direct sunlight.

Increases in the quantity and quality of sunlight can be made once these plants are well-established and rooted.

Move to a more shady area if you see that they are getting sunburned. The plants can be moved around to observe where they thrive. After around three weeks, you can pull the stem out to see if the cuttings have rooted. The plant has rooted if it resists being pulled out of the ground and is challenging to do so.

Update:

Please click on to see how these plants are doing four months later “Click here to see updates and photographs for Does Water Propagation Work for Succulents?

A Step-by-Step Guide for How to Procreate in Water is Provided Below:

acquire a cutting. Snip a piece of a succulent plant’s stem. Leggy plants can be a fantastic source of stem cuttings. Leave the stem naked for at least two inches.

OR You can propagate plants by using leaves in place of a stem cutting, or by using both stems and leaves.

Pick healthy leafy plants. A healthy leaf is a better place to start if you want to succeed. Select leaves that are not ripped, torn, damaged, or irregularly shaped. Instead of dried and flat leaves, search for full, plump leaves.

Remove the leaves off the stem gently. Your thumb and forefinger should be used to carefully twist the leaves from the stem. Some leaves are loosely linked to the stem while others are securely attached.

To remove the entire leaf, gently wriggle it back and forth. The entire leaf, including the base where it connects to the stem, is what you desire. The leaf won’t survive if the base does not separate or if it sustains harm.

Launder the cuttings. Till the cut end has calloused or dried, let the cutting air dry for a few days.

Submerge in water. Select the ideal-sized cup for the clippings, then fill it with water. Place the cutting so that the stem or leaf’s tip is slightly visible above the water’s surface.

Another method is to let the cutting to touch the water at the end. From what I’ve heard, both approaches appear to be effective. (I chose to do the latter, where the cuts’ end was in the water.)

Plant the cuttings that have roots. After the cuttings have developed roots, let them dry for a few days. The roots cuttings can be planted in an appropriate potting mix once they have dried out.

occasionally use water. Compared to adult plants, baby plants require a bit more moisture. Spray the soil with a spray bottle sparingly once every few days or whenever it seems dry. Reduce watering to once a week after the plant has a stronger root system.

Keep away from the sun’s rays. When first planted in their own pot, shield young plants from direct sunshine to avoid sun damage. As a plant matures, gradually increase sunshine and sun exposure in accordance with the needs of the plant.

Some people opt to leave the rooted cuttings submerged in water rather than planting them as described in step 7 of the process. In water, the cuttings will perpetually live and thrive. Every few weeks or as needed, replace the water and add fresh, clean water.

Some individuals use hydroponics to grow succulents in water. They enjoy the way it seems and are very successful with them. They can be left with lots of light either inside or outside.

My opinions on the spread of water:

I don’t see the necessity to pursue water propagation since I have success with “soil” propagation. It does appear more simple, and I can understand why it could be appealing to others. Just submerge the plants or set them directly over water, then wait for the roots to form.

The aeonium cutting was the only plant that didn’t actually produce any roots at all when I attempted this procedure; it took approximately 4-5 weeks for roots to start to appear. Given that I only utilized stem cuttings and attempted two distinct plant species, I might have different outcomes with leaf cuttings or with other plant species. Additionally, the stem cuttings I left in water for five weeks were OK and didn’t rot or die.

Naturally, depending on the surroundings, the outcomes would definitely vary for others. Depending on the temperature, the type of plant, etc., some people have more success than others when it comes to soil propagation. I most certainly wouldn’t completely reject this approach and would encourage others to give it a shot, even if it’s only for fun or for those who haven’t had success with the “dry” approach.

According to what I have read and heard, many people prefer this technique because it is quicker and they have more success with it than with soil propagation. Therefore, this is definitely worth a shot if you want to experiment and try something new or if you’ve tried propagating repeatedly but without success. Please select “To learn about further succulent propagation techniques, read 4 Simple Ways to Propagate Succulents.

About

You’ve come to the correct location if, like me, you enjoy succulents. This website is a repository for the succulent-growing knowledge I’ve accumulated over the years and am still learning. Although I am by no means an expert on succulents and cacti, this website was created as a result of years of hard work, love, and many mistakes and learning opportunities.