How To Propagate Ghost Succulent

The “Ghost Plant” can be mistaken for an Echeveria with ease. Despite its similarities, Ghost Plant is unique in its own right. In the spring, keep an eye out for little yellow blossoms.

Watering

The “soak and dry approach” of watering should be used on graptopetalum. Be sure that the soil is totally dry after watering to avoid root rot and pests.

Additionally, make sure to get our FREE watering cheat sheet to learn how to determine whether your succulents are receiving too much water (and how to save them if needed).

Leaves

Twist a leaf from the mother plant to create new Graptopetalum. You will have a lower likelihood of succeeding if any leaf fragments are left on the stem.

Place the leaf on well-draining soil after allowing it to dry out for a few days so the end calluses over. When the soil is entirely dry, water.

Ghost Plant is a simple plant for people just starting out with propagation because it will also shed leaves and spread on its own.

Cuttings

Use a clean, sharp knife or pair of scissors to cut a section of the plant right above a leaf on the stem in order to propagate Ghost plants from cuttings. Place it in well-draining soil after allowing it to air dry for a few days.

How is a Ghost plant stem multiplied?

Not only is the “Ghost Plant” Graptopetalum paraguayense hardy, but it is also incredibly simple to reproduce. Through stem cuttings, it is the simplest method. They can also be easily multiplied from leaf cuttings, however it takes longer than with stem cuttings. I always go with stem cuttings because I have a significantly greater success rate with them.

Graptopetalum Paraguayense Stem Cutting Propagation:

  • Take a stem cutting, and allow it to dry for about a day. Dry and callus or seal the cut ends. It is a good idea to take cuttings from plants that appear healthy and have full leaves rather than ones that are stressed or dry.
  • Dip the cut end in rooting hormone (optional). Although some individuals like utilizing rooting hormones to expedite the process and ensure success, I usually omit this step.
  • Insert the cuttings in a well-draining potting mix after the cut has healed and dried.
  • Avoid the sun’s direct rays. Every few days or whenever the soil becomes dry, water it.

The cuttings should be fully rooted after four to six weeks, and you will soon see new growth appearing from the top or sides of the stem.

Once the roots are established, reduce misting and proceed to normal watering, which should occur once a week or fewer. As the plant develops, increase the amount of sunshine.

Can cuttings be used to propagate succulents?

Aeoniums can grow enormous and get “weary,” and the best course of action is to remove them and transplant some cuttings. Make sure the offcuts from pruning succulents like aeoniums are long enough to allow them to stand upright when replanted.

  • Starting with the tips, trim the stem, leaving at least 15–20 centimeters of stem.
  • After removing the parent plant, set the cuttings aside. These plants have relatively shallow roots, making it simple to pull them out of the ground.
  • About 20 cm of a trench should be dug, into which the cuttings should be placed and then backfilled to support them.
  • In the summer, the cuttings can be planted straight in the ground. For about a week, don’t water the cuttings to let the base dry up. Before planting them during the cooler months, let them sit out of the ground for a week.
  • The cuttings will begin to take root in about a month, and then the tops of the cuttings will begin to grow.

Leaf cuttings can be used to multiply Pachyveria. By removing a lower leaf, you can tell if the plant will grow from leaf cuttings. It might be able to produce new plants if it comes off without damaging anything. The leaf won’t grow if it breaks, creating a “fleshy cut.”

  • Prepare a tray with a combination of succulent and cactus.
  • Starting at the base and working outward, carefully remove the leaves while holding the rosette by the stem. You may also plant this rosette as a cutting, so leave a few leaves on it.
  • Make sure there is enough of airflow around the leaves as you arrange them on top of the soil. Make sure the dish-side up is towards the bud (where the leaf joined the stem), which should be left above the soil.
  • The bud end will begin to develop a small rosette cluster in two to three weeks. As the roots will grow from this end, make sure to maintain it close to the ground.
  • The buds can be removed from the tray and placed in a container or planted directly into the ground after they are big enough to pluck out (and have many leaves).

Are ghost plants sun-loving?

These plants must be cultivated in soil that drains well due to Florida’s humid, wet climate. Succulents like the ghost plant are consequently frequently grown in rock gardens or in pots, both indoors and outdoors.

Make sure to pick a container with drainage holes and well-drained potting medium when placing your ghost plant in a container. For an interesting yet low-maintenance landscape, try combining ghost plants with other varieties of succulents.

Alternately, you might include your ghost plant in a rock garden. A rock garden is made by piling huge rocks, such as limestone, to form the base and then filling in the spaces with smaller rocks, gravel, and planting pockets of soil.

Because the ghost plant needs sunshine to grow, find a spot where it will get full or partial sun.

Keep it close to a south, east, or west window if grown indoors.

For a larger shape, some individuals choose to keep their ghost plants trimmed. Allowing it to become a little “leggy” will give it a new look and will allow the twisted stems to slowly climb out of the pot and cascade down. Between waterings, make sure the soil has nearly dried up entirely.

The ghost plant is extremely drought-tolerant, like the majority of succulents; if your plant starts dropping too many leaves, you may be overwatering. But naturally, leaves will fall off; this is how the plant expands. As leaves fall to the ground below and break off, the ghost plant reproduces itself. Give a fallen leaf some time to develop a callous above the break-off spot if you want to try growing ghost plant yourself. Because of this, ghost plants are some of the simplest succulents to grow, making them excellent gifts for friends and family.

How frequently should a ghost plant be watered?

The Ghost plant tends to grow in direct sunlight, which gives the leaves an almost transparent pink colour.

The ghost plant can take some shade, though it will give the leaves a blue-gray tint.

Watering

In the spring and summer, water a Ghost plant once a week once the top inch of soil has become dry.

To avoid overwatering, the plant should only receive water once every two to three weeks in the winter and once a week throughout the spring and summer’s vigorous growing seasons.

In order to prevent the leaves from scorching in the morning on a hot, bright day, water the soil directly around the base of the plant rather than directly on them.

Temperature

The ghost plant is a somewhat resilient succulent in terms of temperature range, and it will thrive at room temperature in your home.

They can endure low nighttime temperatures in a mountainous location in their native Mexico, where they thrive in hot, dry circumstances.

How often should a ghost cactus be watered?

It’s crucial that you wait a while before repotting your White Ghost. Keep it in its original pot for three to four months, ideally. If you received your White Ghost in the fall, the plant will be in a semi-dormant state throughout this time.

Lactea Euphorbia The cultivar variant of Euphorbia Lactea known as “White Ghost” is almost all white. It has tall, candelabra-shaped triangular stems with spiky borders. Deciduous leaves on the White Ghost deteriorate over time and fall off when no longer needed. It developed to flourish in arid, severe settings, making it a xerophytic plant.

The milky latex that all plants in the Euphorbiaceae family contain is dangerous and seeps out when they are cut. Euphorbia ‘White Ghost’ uses CAM (Crassulacean acid metabolism) instead of cells that contain chlorophyll to photosynthesize.

EXPOSURE TO FULL SUN OR AT LEAST A BRIGHT SUN-LIT AREA Euphorbia lactea ‘White Ghost’ requires full sun. The cells in ‘White Ghost’ Euphorbia don’t contain chlorophyll. The complex process of CAM photosynthesis is primarily powered by the sun’s energy.

HUMIDITY Euphorbia “White Ghost” does best in low humidity, but it may tolerate higher room humidity as long as it is not overwatered.

WATERING The Euphorbia lactea ‘White Ghost’ is very water-sensitive. If overwatered, it can and will die fast. It needs to be watered on average like a succulent. Typically, water should be applied when the top 3 inches of soil feel dry. In the winter, when it is semi-dormant and the top 5 to 6 inches feel dry, water it less frequently.

SOIL Always use a soil combination that drains effectively. You can either purchase pre-mixed soil or build your own by combining charcoal, perlite, and 1/3 each. This creates a fantastic, well-draining mix for all of your succulents, cacti, and euphorbias.

The stunningly gorgeous Euphorbia Lactea White Ghost is a favorite among collectors since it is unlike any other! You can enjoy its creamy white hue, pink undertones, and swirls of green and yellow for years to come if you take good care of it.

Can you plant a portion of cactus that has been chopped off?

A loved cactus plant might quickly lose a portion due to overly active kids, scavenging animals, an accidental bump, or an unplanned incident. You need not worry if it occurs to you because you are not required to discard the chopped piece.

Even if the main plant can still survive if a portion of its stem is lost, it may seem wasteful to toss the broken piece and ignore the rest.

Can you then cut a chunk off of a cactus and plant it? Yes is the clear-cut response. Cuttings can be used to grow a sizable number of cacti species. Hedgehog, prickly pear, and branching columnar cacti like the night-blooming cereus are a few of the common cactus species that are typically reproduced via cuttings.

Don’t discard the broken piece if your cactus accidently breaks off a portion of it. Instead, replant it from seed and let it grow.

How do you re-root a cactus fragment?

Large desert cactus, such as the prickly pear (Opuntia spp. ), can be rooted either indoors or outdoors in U.S. Department of Agriculture plant hardiness zones 3b through 11. Usually, smaller desert plants are rooted in flower pots. One-third to one-half of the pad or stem should be buried, bottom end down, in the potting media after making a small hole in it. Place in a warm environment with filtered light that is bright. Wait to water the plant until the roots start to form.

Can succulent cuttings be planted directly in the ground?

What is there to love other than a succulent? Obviously, a full garden of succulents! Fortunately for us, it’s simple to propagate a variety of these resilient, vibrant plants at home. We can’t wait to see succulents growing all year long in containers around the house and garden; there are various easy ways to reproduce them.

Propagating by Division: Plants that have gotten too leggy perform best with this method, which produces new succulents from cuttings. Start by delicately removing any leaves that may be attached to the stem below the rosette; be sure to preserve the leaf’s base while you do so. After all the leaves have been eliminated, cut the rosette with shears, leaving a brief stem intact. The cuttings should be let to dry in an empty tray for a few days until the raw ends have calloused. The cuttings can then be rooted in either water or soil.

Soil: After the stems have calloused, set the cuttings on top of a shallow tray filled with well-draining cactus/succulent soil. From the base of the cuttings, roots and little plants will start to emerge in a few weeks. Once the roots start to show, water sparingly once a week; take care not to overwater. The parent leaf will eventually wither; carefully remove it while taking care not to harm the young roots. Your propagated succulents can be replanted once they have established roots. As soon as the plants are established, keep them out of direct sunlight.

Water: After the stem has calloused, place a cutting with the end barely visible above the water’s surface on the lip of a glass or jar filled with water. Pick a sunny location for your glass. The incision will eventually produce roots that extend toward the water. Once roots have sprouted, your new succulent can either be replanted in succulent potting soil or allowed to remain submerged in water as illustrated above.

Offsets are little plants that develop at the base of the main specimen, and many species of succulents, such as aloe, hens and chicks, and some cacti, will generate them. Check for root growth after an offset has developed for two to three weeks before carefully twisting, cutting, or using a sharp knife to separate it from the main stem. Be cautious to prevent destroying any already-formed roots. Follow the directions above for propagating in soil or water, letting the offsets dry, establish roots, and then repot when they have had time to callus any exposed regions. Removing offsets has the added benefit of enhancing the health of your current succulents and redirecting energy into the growth of the primary plant.