Choose a suitable location on your succulent to make the cut. Make a quick, even cut through the succulent’s stem with your pruning shears to separate a cutting. Make sure that there is around 1 inch of stem exposed on the cutting before planting. The bottom leaves of the cutting might need to be removed for this.
Let the Cutting Callous
It is not possible to immediately put the cutting in the ground after it has been taken. Allow the “damaged” stem of the cutting to callous over for 24 hours by setting the cutting aside in a dry place. The stem should be healed and not seem to be “wet” in any regions after 24 hours. It’s now time to plant the cutting.
Plant the Cutting
Put a succulent mix or well-draining soil in a small terracotta or plastic planter. Make a tiny hole in the middle of the soil, and after placing the succulent cutting’s stem there carefully, firm the earth up around it. To prevent rot, make sure the cutting’s lowest leaf is perched just above the surrounding soil.
After planting, avoid watering the cutting. Give the newly planted succulent cutting two or three weeks in a spot with bright, indirect sun.
Begin Watering Once Roots Sprout
It’s crucial to hold off on watering a fresh succulent cutting until the roots have formed, unlike when propagating other plants. Since succulents don’t need much water to begin with, watering a cutting before it has roots might cause the cutting to decompose under the soil very rapidly. Succulent cuttings may go quite a while without water, so don’t worry!
Give the cutting’s top a little push to check for roots after letting it sit for two to three weeks. If there is any resistance, the cutting can now be watered because the roots have started to form. Once the cutting has grown roots, it might need to be watered more frequently than usual succulents until it becomes established. Make sure the top inch of the soil dries out between waterings to prevent overwatering.
Patience, Patience, Patience!
Be patient while you take care of your new plant because succulent cuttings grow slowly. But after a few months after planting, you should start to see fresh growth.
Growing succulent cuttings can be gradually put back into stronger lighting as they become older, eventually reaching the full sun conditions that most succulents enjoy. Remember that succulent cuttings are susceptible to death from excessive affection. Once the soil dries out, they simply require light watering because they thrive on neglect.
Can you just bury a succulent cutting in the ground?
What is there to love other than a succulent? Obviously, a full garden of succulents! Fortunately for us, it’s simple to propagate a variety of these resilient, vibrant plants at home. We can’t wait to see succulents growing all year long in containers around the house and garden; there are various easy ways to reproduce them.
Propagating by Division: Plants that have gotten too leggy perform best with this method, which produces new succulents from cuttings. Start by delicately removing any leaves that may be attached to the stem below the rosette; be sure to preserve the leaf’s base while you do so. After all the leaves have been eliminated, cut the rosette with shears, leaving a brief stem intact. The cuttings should be let to dry in an empty tray for a few days until the raw ends have calloused. The cuttings can then be rooted in either water or soil.
Soil: After the stems have calloused, set the cuttings on top of a shallow tray filled with well-draining cactus/succulent soil. From the base of the cuttings, roots and little plants will start to emerge in a few weeks. Once the roots start to show, water sparingly once a week; take care not to overwater. The parent leaf will eventually wither; carefully remove it while taking care not to harm the young roots. Your propagated succulents can be replanted once they have established roots. As soon as the plants are established, keep them out of direct sunlight.
Water: After the stem has calloused, place a cutting with the end barely visible above the water’s surface on the lip of a glass or jar filled with water. Pick a sunny location for your glass. The incision will eventually produce roots that extend toward the water. Once roots have sprouted, your new succulent can either be replanted in succulent potting soil or allowed to remain submerged in water as illustrated above.
Offsets are little plants that develop at the base of the main specimen, and many species of succulents, such as aloe, hens and chicks, and some cacti, will generate them. Check for root development after an offset has grown for two to three weeks before carefully twisting, cutting, or using a sharp knife to separate it from the main stem. Be cautious to prevent destroying any already-formed roots. Follow the directions above for propagating in soil or water, letting the offsets dry, establish roots, and then repot when they have had time to callus any exposed regions. Removing offsets has the added benefit of enhancing the health of your current succulents and redirecting energy into the growth of the primary plant.
What You’ll Need:
- slicing shears
- gardening mitts (for handling spiny varieties)
- a little trowel
- potting soil for cacti and succulents
- jars with sufficient drainage holes
Remove Some Leaves or Behead
Take a few leaves at random from your succulent plant, gently twisting each one off the stem without breaking it.
These can be cut off the bottom of the stem, which will be discarded, when it begins to grow lanky.
To remove a specific leaf from a plant, such as a Christmas cactus, you might need to use scissors.
If you’re “beheading,” cut the stem of the plant head cleanly with your scissors or clippers about an inch below the lower leaves.
Plant
When roots start to form, either choose a site in your garden that is ideal for planting or fill well-draining containers of your choosing with potting material.
Sunshine and well-drained soil are ideal for succulent growth. They get paler in the absence of sunlight, and they decompose in excess moisture.
When the sun is less powerful, such as in the early morning or late afternoon, plant in a sunny location.
To lift the cuttings above the edge of your container or garden surface, pile dirt higher. To stabilize the roots, gently tamp the earth down; do not water.
Water and Feed
It’s time to buy a succulent/cactus food at this stage, such as Miracle-Gro Succulent Plant Food, which is sold on Amazon. administer as directed by the manufacturer.
Succulents can also be propagated via cuttings that are placed on top of potting soil and allowed to callus off so they can root themselves in the soil.
Gather Your Succulents To Plant
For this video, we’ll be planting a variety of succulent species using both cuttings and discarded leaves. Amass the materials you want to plant. You can either utilize fallen leaves or cut cuttings from an established plant. If you can’t locate cuttings anywhere else, you can usually find them online and at most florists. Although these are also available on Amazon, I got mine from a vendor on Etsy.
Prepare your succulents for planting.
The most crucial step in this method is preparing your succulents. Make sure you have enough stem to plant in the ground so it can support the plant. Any excess leaves at the stem’s base should be removed. It’s good to leave approximately an inch of the stem exposed for larger cuttings, and you can use less for smaller cuttings.
After that, examine the base of your cutting. The plants ought to have a “callous” on them, which denotes that the plant’s base has dried out. You should wait a few days before planting freshly cut succulents because this forms a few days after the succulent is cut. By letting the cut end dry more quickly on a paper towel or paper bag, you can hasten this process.
Succulents are wonderful because you can also plant their leaves, so hold onto the ones you pulled off the stem. Verify your succulents for any bad components. Any area of the plant that is dark contains rot, which can spread to other areas and ultimately destroy the plant. Simply cutting it will allow you to get rid of the rotten parts.
Mix your soil.
If you aren’t using a pre-made succulent soil mix, you’ll need to prepare your soil so that it will drain effectively and support the growth of your succulent plants. To make the soil drain well, I combine one part potting soil with one part sand. In order to help larger plants become more firmly rooted in the ground, I also prefer to have a supply of tiny rocks nearby.
To fill a pot or tray, pour your soil mixture. I’m repurposing an old baking pan that I can’t bake in as a planting tray.
Plant!
We’ve reached the enjoyable part now! Make a little, inch-deep hole in the ground. After inserting your cutting, fill up the depression with soil.
Make careful to space your cuttings, if you’re planting more than one, roughly 2-3″ apart.
Ensure that your plants receive adequate water. Although succulents don’t often require much water, you may need to water them every 2-4 days while they are developing their roots, depending on how dry the soil becomes. It’s normal for the leaves to initially appear a little dried out because the plant is using its reserves of stored energy to develop new roots. New growth should begin to appear in around four weeks. Change to weekly watering or watering only when the soil is dry once the plants have set their roots and have started to grow.
Admire and Show Off Your Work!
Well done! Show off your incredible craftsmanship and green thumb to all of your friends! These plants will be prepared for repotting if you desire once they have developed roots and begun to grow, which should take around 3 to 6 weeks. They make wonderful Christmas gifts for friends and coworkers when planted in a tiny Mason jar or vibrant pot!
Succulents can you grow them in just soil?
Every soil mixture contains both organic and mineral components. Mineral matter, such as clay, silt, and sand, support soil drainage, whereas organic matter, such as humus and decomposing plant tissue, serves to retain moisture in the soil and give nutrients to the plant.
Because succulents can withstand drought and don’t require constant watering, their potting soil should be permeable, well-draining, and contain less organic matter than typical indoor soil mixtures. Ideal soil is a loose, granular mixture with a good amount of sand and perlite or pumice.
How frequently should I water cuttings of succulents?
Succulents may be multiplied, giving you more of what you love. In order to share succulents with friends or because your plants have grown lanky and unsightly, you may need to propagate succulents. Whatever your motivations, we have a tried-and-true method for propagating succulents successfully.
Easy Steps for Propagating a Succulent by Leaf Cutting
1. Cut the desired number of leaves off the stem of the succulent you want to multiply.
- Where the leaf meets the succulent stem, make a precise snap. Your propagation will go more quickly and easily as a result.
- For propagation, take many leaf cuttings (see #5).
2. Allow the succulent leaf’s broken end to callus over, mend, and/or dry out.
- While a week is a fantastic amount of time, you can get away with 2-3 days for small succulent leaves and 4-5 days for larger succulent leaves while you wait for the leaves to heal.
- The succulent leaves you want to multiply should be placed on a sunny window sill to dry. The sun’s rays expose the leaves, strengthening them with nutrients as well.
- When natural sunshine is unavailable, LED grow lights are a choice.
3. Place a succulent leaf directly on the soil in a container or on a tray of soil.
- You should touch the earth with the healed portion of the leaf you are propagating, but not bury it deeply. From there, the newly propagated succulent will grow, and in order to survive, it requires light and space to breathe.
- Although it would take a lot longer to spread, you could let the leaf develop without soil.
4. Provide water and light to your succulent leaf cuttings for successful propagation.
- Depending on the temperature and humidity in your home, water succulent leaf cuttings anywhere between two and four times per week. But don’t overwater. While keeping the soil from drying out, soil should be moist but not to the point of having any standing water.
- It’s ideal to have direct, bright light. Your leaf cuttings may become scorched by too much direct sunlight.
5. Produce several leaves.
- You’ll probably experience some casualties when propagating succulents. You have a better chance of successfully growing succulents if you follow the procedures of propagation with numerous leaf cuttings.
- Place a number of leaf cuttings on a tray or large pot filled with potting soil that is lightweight. Here, you can immediately see which leaf cuttings will begin to develop roots and young succulents and are good candidates for propagation and which leaves will begin to shrivel and turn black, making them unsuitable.
6. Be patient and give your leaf cuttings enough time to grow roots, produce offspring, and reproduce.
- Please take note that leaf cuttings that produce babies but no roots are preferable to leaf cuttings that produce babies but no roots.
- You can sigh with relief when you notice that the young succulents or pups are growing. When the pups or babies appear, you can tell that they are able to produce their own food through photosynthesis as well as their own leaf systems. A leaf cutting that only grows roots may never give birth to offspring or may take a very long time to do so.
- You can always pinch or clip off the mother plant leaf once the babies/pups have formed.
7. Plant your just multiplied succulents in pots.
- Allow your babies or puppies to establish strong roots so that you can repot them into any container you want. If you propagated them in your chosen pot, let them there to continue growing.
- While propagated succulents are still in their adolescent years, keep providing them with indirect strong light. Direct sunlight will be too harsh.
- Give your new succulents a nice soak once every two weeks to water them. Don’t overwater once more. Just keep in mind that succulents store water in their leaves and stems, and that too much water around their roots will result in death by root rot.
- Remove the leaf from the mother plant that was used to propagate the plant, if you haven’t done so before. It has probably already started to shrivel up. The mother leaf remnants will ultimately dry out and fall off if you cut it close to the new plant.
*Special remark Some succulents, such as hoya and kalanchoe, cannot be propagated via leaf cuttings but can instead be done using alternative techniques, such as stem cutting. Later, we’ll talk about those.
Folks, that’s all she wrote! Your succulents that you propagated should be well on their way to developing into mature plants. Good fortune!