Taking an active, healthy leaf from a mature succulent plant and utilizing it to establish a new plant is known as “propagating with leaf cuttings.” Because the leaves of succulents with fleshy, plump leaves, like echeveria, are simple to snap off cleanly, this method of propagation works well with them.
While some leaves may simply pop off with a little tug, others could necessitate the use of a sharp knife. Take a healthy leaf from the plant’s base with clean hands or a sterile knife, making sure to remove the full, undamaged leaf.
After being removed, allow the leaf to recover for about four days in a warm, well-lit place so that the wound can callus over. When the leaf has calloused, prepare a fresh planter with soil, fill it with water, and set the callused leaf on top of the soil for multiplication.
When the earth is dry, spritz your leaves with a spray bottle. Keep them warm, in a room with lots of light, but out of direct sunlight. They must be kept warm and moist.
Little roots and leaves will start to emerge after around three weeks! A succulent may need a few months to grow large enough to be replanted (photos above are after about 8 weeks). When the leaf eventually gets brown and falls off, you’ll know it’s time. This indicates that the succulent no longer requires the leaf because it has consumed all of its nutrients.
Can a leaf be used to propagate succulents?
In the spring and summer, when leaves and stems are ready for active growth, it is simplest to propagate succulent leaves and cuttings. Most common succulents can be multiplied successfully from individual leaves or stem fragments.
- For succulents with fleshy leaves, like jade plants or echeveria and sempervivum rosettes, leaf propagation works well. The leaf must remain intact for the root to take. To loosen the leaf, gently bounce it back and forth while holding it between your forefinger and thumb. After that, carefully separate the leaf from the parent plant, keeping the base in tact.
- Succulents with distinct stems, including stacked crassulas and spreading or erect sedums, respond well to stem cuttings. Cutting succulents is analogous to propagating soft-stemmed plants. To cut stem tips, use a sharp knife, or take an entire stem to make many starts. Each cutting should be 2 to 3 inches long and have multiple leaves. Only the top two leaves should be kept.
After propagation, when can I plant succulents?
Succulents can also grow from solitary leaves. Succulent cultivars with fleshy, plump leaves that are simple to remove function well with this technique. Leaf propagation spares less of the “mother” plant and each leaf can create numerous little plants, even though it will take much longer to produce a full-sized plant. Getting a quality leaf cutting is crucial, much like with stem cuttings. Although they must split from the plant at the base of the stem, leaves can be wiggled off of a plant. Kremblas advises caution, saying, “Be sure to reach all the way down to where the leaf joins the stem, as a broken leaf will not propagate.” And make sure to select a leaf that is firm, plump, and limp-free.
Leaf cuttings should be allowed to callus and need partial sun to grow, just like stem cuttings. Leaf cuttings should be placed on top of a thin layer of succulent potting soil (not buried), and they should be misted with water to keep them wet. The leaf cuttings will start to grow little “pup” plants in about three weeks. The mother leaves will start to wilt and drop off after eight weeks, at which point your pups are ready to be planted.
What about propagating leaf cuttings?
Some soft succulents will re-root from leaves, though it is typically more difficult. Pick thick, healthy leaves that are close to the base. Take off the leaves and allow them to dry for 4 to 7 days inside or in the shade. once the calloused cut cease,
Plant the leaves cut side down, vertically, in a bed of loose soil. Watch for new growth over the next months and water as you would a stem cutting.
Can I plant cuttings outdoors?
Because of the more unpredictable climatic circumstances, repotting cuttings outside is difficult. You can try planting a clipping of a succulent outside during the growing season if you live in the appropriate hardiness zone. Choose a spot that gets some sun, either direct or indirect. Observe the aforementioned recommendations and pay close attention to moisture levels. Be mindful that not all cuttings will thrive.
Do I need to fertilize?
There is no need for fertilizer, and using too much will harm young or unrooted succulents. In the spring growing season, mature, rooted succulents may withstand low-nitrogen, slow-release fertilizer.
Can you put succulent cuttings directly into the ground?
Aeoniums can grow enormous and get “weary,” and the best course of action is to remove them and transplant some cuttings. Make sure the offcuts from pruning succulents like aeoniums are long enough to allow them to stand upright when replanted.
- Starting with the tips, trim the stem, leaving at least 15–20 centimeters of stem.
- After removing the parent plant, set the cuttings aside. These plants have relatively shallow roots, making it simple to pull them out of the ground.
- Dig a trench for the cuttings – around 20cm deep, place cuttings and backfill to support them up.
- In the summer, the cuttings can be planted straight in the ground. For about a week, don’t water the cuttings to let the base dry up. Before planting them during the cooler months, let them sit out of the ground for a week.
- The cuttings will begin to take root in about a month, and then the tops of the cuttings will begin to grow.
Leaf cuttings can be used to multiply Pachyveria. By removing a lower leaf, you can tell if the plant will grow from leaf cuttings. It might be able to produce new plants if it comes off without damaging anything. The leaf won’t grow if it breaks, creating a “fleshy cut.”
- Prepare a tray with a combination of succulent and cactus.
- Starting at the base and working outward, carefully remove the leaves while holding the rosette by the stem. You may also plant this rosette as a cutting, so leave a few leaves on it.
- Make sure there is enough of airflow around the leaves as you arrange them on top of the soil. Make sure the dish-side up is towards the bud (where the leaf joined the stem), which should be left above the soil.
- The bud end will begin to develop a small rosette cluster in two to three weeks. As the roots will grow from this end, make sure to maintain it close to the ground.
- The buds can be removed from the tray and placed in a container or planted directly into the ground after they are big enough to pluck out (and have many leaves).
How can you root succulents the quickest?
So, you may be wondering how to quickly propagate succulents. I can relate to both the joy and frustration of watching a new plant develop.
Since I’ve been growing succulents for a few years, allow me to give you some advice on how to quickly propagate your succulents as well as some alternative techniques you can try.
Stem cuttings are the simplest and quickest method of propagating succulents. If the plant is a fresh cutting from the mother plant, it will already have a strong foundation from which to build its new root system. Another instance is when you cut off the succulent’s top portion because it has been stretched out significantly (etiolation), this stem will likewise give rise to numerous new plantlings (pups). Due to its existing root system, the plant will also have a great possibility of producing more offset and growing quickly.
Always check that the stem cuttings are a respectable size for the plant’s typical size.
According to my experience, I always want to make sure that the succulent has a lot of nodes where the leaves attach to the stem and a lot of leaves in its stem. Once the succulent is put in soil, these stem nodes will form roots, and the leaves will serve as the succulent’s water source until its root system matures.
Can you replace a succulent after cutting the stem?
I make a lot of movies and posts about succulents because I have a lot of them in my yard. They are perennial gifts, so to speak. You can simply cut them to acquire more.
Because the vast majority of succulents spread in the same manner, I wanted to write one post that you could refer to whenever I write about a particular succulent. These are the two incredibly simple methods.
Let me demonstrate how to grow succulents:
I usually divide succulents using stem cuttings. Ensure the sharpness and cleanliness of your pruners. Simply trim the stems to the desired length, remove the bottom third of the leaves, and then wait 2 weeks to 4 months before planting them to heal off (the cut end of the stem will callus over).
I either plant them straight in the ground or in a pot with planting mix for succulents and cacti. I use one that is made nearby; it’s also good. Succulents require a loose mixture so that the water can drain completely and prevent rot.
I rarely use individual leaf cuttings to propagate succulents, but it’s still simple. Lay the leaf on top of the mixture after removing it from the stem, making sure to remove the entire leaf all the way to the stem. Off the cut end, there will be a new plantlet.
I suppose I could propagate succulents in my sleep because I do it so frequently! Although many succulents make excellent houseplants, mine all grow outside. If you have just one or two of these bizarre plants, you can easily grow more using these simple methods.
Aloe Vera must be multiplied by division, which involves removing the pups from the mother plant.
How can water from propagating succulents be transferred to the soil?
It is strongly advised to wait until the cutting has at least an inch-long root or the mother leaf has begun to dry up before leaving it to air-dry on a paper towel for approximately a day or two if you wish to transfer or transplant your succulents from water to soil. Remember that water roots are far more delicate than soil roots, so handle them carefully and acclimate them to soil gradually.
When the roots are completely dry, gently bury your succulent in unfertilized cactus soil and place it in a spot with only bright, indirect light. Giving your succulents direct sunlight at this time is not advised because they are still delicate.  
From this point on, it is advised to water your succulent on a regular basis. Every two weeks, a thorough soak would do.
Watch this video to learn about succulent water propagation:
Watch this little video to learn how to avoid four mistakes while cultivating succulents.
See some of the most frequently asked questions about propagating succulents and cacti in this little video.
How should a propagated plant be planted?
The simplest method for growing plants with stems at the base.
- Plant should be taken out of container.
- Use a knife or your fingers to cut the plant into smaller pieces.
- Verify the roots of each division.
- In appropriate containers, replant.
How frequently should I water cuttings of succulents?
Succulents may be multiplied, giving you more of what you love. In order to share succulents with friends or because your plants have grown lanky and unsightly, you may need to propagate succulents. Whatever your motivations, we have a tried-and-true method for propagating succulents successfully.
Easy Steps for Propagating a Succulent by Leaf Cutting
1. Cut the desired number of leaves off the stem of the succulent you want to multiply.
- Where the leaf meets the succulent stem, make a precise snap. Your propagation will go more quickly and easily as a result.
- For propagation, take many leaf cuttings (see #5).
2. Allow the succulent leaf’s broken end to callus over, mend, and/or dry out.
- While a week is a fantastic amount of time, you can get away with 2-3 days for small succulent leaves and 4-5 days for larger succulent leaves while you wait for the leaves to heal.
- The succulent leaves you want to multiply should be placed on a sunny window sill to dry. The sun’s rays expose the leaves, strengthening them with nutrients as well.
- When natural sunshine is unavailable, LED grow lights are a choice.
3. Place a succulent leaf directly on the soil in a container or on a tray of soil.
- You should touch the earth with the healed portion of the leaf you are propagating, but not bury it deeply. From there, the newly propagated succulent will grow, and in order to survive, it requires light and space to breathe.
- Although it would take a lot longer to spread, you could let the leaf develop without soil.
4. Provide water and light to your succulent leaf cuttings for successful propagation.
- Depending on the temperature and humidity in your home, water succulent leaf cuttings anywhere between two and four times per week. But don’t overwater. While keeping the soil from drying out, soil should be moist but not to the point of having any standing water.
- It’s ideal to have direct, bright light. Your leaf cuttings may become scorched by too much direct sunlight.
5. Produce several leaves.
- You’ll probably experience some casualties when propagating succulents. You have a better chance of successfully growing succulents if you follow the procedures of propagation with numerous leaf cuttings.
- Place a number of leaf cuttings on a tray or large pot filled with potting soil that is lightweight. Here, you can immediately see which leaf cuttings will begin to develop roots and young succulents and are good candidates for propagation and which leaves will begin to shrivel and turn black, making them unsuitable.
6. Be patient and give your leaf cuttings enough time to grow roots, produce offspring, and reproduce.
- Please take note that leaf cuttings that produce babies but no roots are preferable to leaf cuttings that produce babies but no roots.
- You can sigh with relief when you notice that the young succulents or pups are growing. When the pups or babies appear, you can tell that they are able to produce their own food through photosynthesis as well as their own leaf systems. A leaf cutting that only grows roots may never give birth to offspring or may take a very long time to do so.
- You can always pinch or clip off the mother plant leaf once the babies/pups have formed.
7. Plant your just multiplied succulents in pots.
- Allow your babies or puppies to establish strong roots so that you can repot them into any container you want. If you propagated them in your chosen pot, let them there to continue growing.
- While propagated succulents are still in their adolescent years, keep providing them with indirect strong light. Direct sunlight will be too harsh.
- Give your new succulents a nice soak once every two weeks to water them. Don’t overwater once more. Just keep in mind that succulents store water in their leaves and stems, and that too much water around their roots will result in death by root rot.
- Remove the leaf from the mother plant that was used to propagate the plant, if you haven’t done so before. It has probably already started to shrivel up. The mother leaf remnants will ultimately dry out and fall off if you cut it close to the new plant.
*Special remark Some succulents, such as hoya and kalanchoe, cannot be propagated via leaf cuttings but can instead be done using alternative techniques, such as stem cutting. Later, we’ll talk about those.
Folks, that’s all she wrote! Your succulents that you propagated should be well on their way to developing into mature plants. Good fortune!