How To Make A Succulent Corsage

Make a rectangle that is narrower than the wrist’s width. You will adhere your flowers to this. Create a second rectangle by cutting it slightly smaller than the first one.

Select the imitation corsage’s two primary flowers (round rosettes), which will serve as the centerpiece. Roses should be cut flush at the bottom of the bloom, resulting in a flat bottom side, after being removed from their stems.

Start around the primary flowers with lesser blossoms. Nothing needs to be glued down just yet.

Once you’re satisfied with the arrangement of the flowers, you can join the stems of the accent flowers. Basically, create a flowering stem with two ends. These don’t have to match exactly. After that, use green flowery tape to bind the middle of the double-ended floral stem.

Before hot gluing anything down, lay them on the larger rectangle to choose exactly where you want them to go. If necessary, now is the moment to trim your felt down.

Use your glue gun to adhere everything on the felt at this point. The double-ended flower should first be glued in place. Let that dry so that it becomes secure. The circular roses that serve as the primary focal point are then glued in place.

Where the corsage appears to be missing pieces, fill them in. To add as filler, you can trim larger floral stems and foliage. Place it on the corsage after adding a drop of adhesive on the ends.

Add the hair tie to secure the cosage to the wrist once you are satisfied with how it looks and the glue has dried. The corsage should be adhered to the hair tie so that it rests vertically against the wrist. In other words, adhere the hair tie such that it is horizontally positioned on the rectangle. Add the second rectangle on top of the hair tie after the first rectangle’s glue has dried so that the hair tie is sandwiched between the two pieces of felt. This will increase security and provide the best level of comfort for wearing the corsage.

Walmart had everything I required. I didn’t need to buy the glue sticks, hot glue gun, or felt because I already have those things. Because I had a lot of excess materials, I utilized some of the extra florals in their hair as small accents and still had extras. I was astonished to learn that each corsage cost about $3 to produce. That is far better than the $20 for a wrist corsage of fresh flowers!

Visit your neighborhood DOLLAR TREE to make this DIY even more affordable. Depending on the season, they have an excellent assortment of flowers.


The breadth of one of my daughter’s wrists was less than the rectangle I cut. I adhered my flowers on this. I then cut a second rectangle, somewhat smaller than the first.


Choose two primary flowers to serve as the centerpiece. I used these lovely spherical roses, which cost approximately $3 per stem and could be obtained at my neighborhood Walmart. For a corsage, use two main flowers, whereas for a boutonniere, use just one main flower. I removed the stems from the round rose flower heads and cut them flush at the base of the flower so that the bottom side was flat.

Lay Out The Flowers 3.

The flowers that surrounding the primary flowers were first layered. To get the flowers where I wanted them to go, it took me a little while. I combined baby’s breath, lavender, and a bouquet of spring flowers. Do not be afraid to trim them up here and there; I had to. As a result, your corsage won’t get enormous. As you can see in the photo below, I had to shorten the lavender stems in order for them to not be as lengthy. I was careful not to remove too much as I worked.


I joined the stems of the accent flowers. I essentially created flowering stems with two ends. In order to prevent the corsage from being unbalanced, I made an effort to make them somewhat comparable in length and width. I made sure to include baby’s breath on each end, but I didn’t make them similar. Instead, I used different accent flowers on each end. Then, to keep the floral stem’s two ends together, I wrapped green floral tape around their midsection.


Before I started gluing anything down, I placed them on the larger rectangle to determine precisely where I wanted to place them. If necessary, now is the moment to trim your felt down.


I adhered everything on the felt using my glue gun at that point. I started by adhering the handmade, double-ended floral stem. So that it becomes secure, let that dry. Then I used glue to attach the circular roses that serve as the centerpiece.


Close the gaps. More accent flowers were placed where I felt the corsage was lacking once the roses were put down and the glue had time to dry. This spring bunch I selected had the most exquisite delicate lambs ear-like leaves, which I cut off as needed. These leaves were scattered over the area where I believed they would look best. I did this with the baby’s breath as well, attaching some to the sides of the roses. I made sure to confirm again that I liked that positioning before I glued them down. You only need a tiny drop of glue for these tiny parts.


I turned it over and attached a strong hair tie once I was satisfied with the way it looked and the glue had dried. My hair tie was actually tied incorrectly as I was filming this instructional. I advise gluing the hair tie on such that the corsage rests vertically against the wrist for maximum comfort. Therefore, you should fasten your hair tie such that it lies horizontally on the rectangle. After the first rectangle has dried, adhere the second rectangle on top of the hair tie, sandwiching the hair tie between the two pieces of felt. By doing this, it will be extremely secure and challenging for the elastic to come undone.

I sincerely hope you enjoyed this simple instruction. As with every one of my postings, don’t be afraid to ask questions if you have any.

How are succulent bouquets preserved?

If you are pruning your own succulents for your distinctive bouquet, be careful not to crush the stems as you cut. Your succulents will remain robust and able to quickly absorb water as a result. Succulents don’t need as much water as other flowers, but if they are carefully cut for the arrangement, they will last longer.

It’s simple and essential to put a bouquet of succulents in a vase with water to keep them alive for a long time. They will stand taller and fade more slowly if they are grouped with carnations as opposed to other blooms like roses and sunflowers. Although the succulent cuttings may ultimately dry out, there is a way to preserve your lovely succulents indefinitely. The easiest flowers to grow from spare cuttings are succulents.

What materials are required to build a boutonniere?


  • Ribbon Shears
  • Floral shears
  • 5/8 to 1 width ribbon.
  • Decorative Tape.
  • Floral Stem Wire, 18 Gauge.
  • Plant Life & Flowers.

How can a fake succulent wedding bouquet be created?

Trim the flower’s leaves and stems in step 1. Leave some of the vegetation in place to fill in the gaps.

Wire the flowers in step two. Under the bloom, insert the wire through the thick area of the stem. Reach at least halfway down the stem and pull it through until both sides are equal. Around the stem, wind the wire. The flowers are supported by this, and you have a little bit more flexibility over how they are arranged.

Tape stems in step three. With your thumb, hold the floral tape in place at the top of the stem. Next, twist the flower while pulling the roll of tape. If you don’t pull it tight as you wrap it, it won’t stay very well. Avoid the temptation to replace the flowery tape with duct tape. Your final product will appreciate it.

Step 5: Create succulent stems out of wire and tape. Apply the same procedure you used for the roses to this. Be cautious because succulents, especially the smaller ones, are more delicate than they appear. We suffered some casualties. Sad and damaged succulents.

Step 6: Begin creating your arrangement from the center outward. Place your largest or most prominent flowers first, then begin adding the remaining flowers. To keep it together, wrap the base (about half of a bouquet) in wire and tape. Don’t use duct tape, once more.

Step 8: Tie stems together with wire and tape, leaving a few inches open at the bottom so you may submerge the bouquet in water.

Step 9 is to wrap it with ribbon and secure it with lovely pins. If you don’t already have a “something blue,” make one of them blue.

The members of #Thisistucson endorse it. Your assistance enables our team to continue bringing you stories that engage you with the neighborhood. Enroll right away.

How long will a bouquet of succulents last?

Durable: Growing succulents from seed is the simplest method, and all you need is one leaf. One can take their bouquet and plant an entire garden to recall a memorable day. Additionally, a succulent arrangement won’t wilt or dry out throughout the day.

How far in advance can you prepare a corsage of fresh flowers?

It’s a good idea to have your boutonniere and corsage delivered one or two days prior to your event if you want them to stay fresh. If it has been less than 24 hours, you may refrigerate them.