- slicing shears
- gardening mitts (for handling spiny varieties)
- a little trowel
- potting soil for cacti and succulents
- jars with sufficient drainage holes
Remove Some Leaves or Behead
Take a few leaves at random from your succulent plant, gently twisting each one off the stem without breaking it.
These can be cut off the bottom of the stem, which will be discarded, when it begins to grow lanky.
To remove a specific leaf from a plant, such as a Christmas cactus, you might need to use scissors.
If you’re “beheading,” cut the stem of the plant head cleanly with your scissors or clippers about an inch below the lower leaves.
Plant
When roots start to form, either choose a site in your garden that is ideal for planting or fill well-draining containers of your choosing with potting material.
Sunshine and well-drained soil are ideal for succulent growth. They get paler in the absence of sunlight, and they decompose in excess moisture.
When the sun is less powerful, such as in the early morning or late afternoon, plant in a sunny location.
To lift the cuttings above the edge of your container or garden surface, pile dirt higher. To stabilize the roots, gently tamp the earth down; do not water.
Water and Feed
It’s time to buy a succulent/cactus food at this stage, such as Miracle-Gro Succulent Plant Food, which is sold on Amazon. administer as directed by the manufacturer.
Succulents can also be propagated via cuttings that are placed on top of potting soil and allowed to callus off so they can root themselves in the soil.
What about propagating leaf cuttings?
Some soft succulents will re-root from leaves, though it is typically more difficult. Pick thick, healthy leaves that are close to the base. Take off the leaves and allow them to dry for 4 to 7 days inside or in the shade. once the calloused cut cease,
Plant the leaves cut side down, vertically, in a bed of loose soil. Watch for new growth over the next months and water as you would a stem cutting.
Can I plant cuttings outdoors?
Because of the more unpredictable climatic circumstances, repotting cuttings outside is difficult. You can try planting a clipping of a succulent outside during the growing season if you live in the appropriate hardiness zone. Choose a spot that gets some sun, either direct or indirect. Observe the aforementioned recommendations and pay close attention to moisture levels. Be mindful that not all cuttings will thrive.
Do I need to fertilize?
There is no need for fertilizer, and using too much will harm young or unrooted succulents. In the spring growing season, mature, rooted succulents may withstand low-nitrogen, slow-release fertilizer.
How long does the propagation process take for succulents?
Succulents can be propagated in water, but doing so goes against the ideal growing circumstances for these plants. Start your leaves and cuttings in shallow planting trays or tiny containers packed with potting soil for the best outcomes. Succulents can be grown in individual containers without having to transplant them right away.
Follow these easy steps once planting day arrives and your leaf or stem cuttings have callused:
1. Get your planting trays or containers ready. Use a coarse, quick-draining potting mix made for succulents and cacti and gently moisten it. 2 Make planting holes with a little stick.
2. Add a little RootBoost Rooting Hormone to a serving dish. When pouring, only utilize what you’ll need and discard the remainder.
3. Cut one piece at a time. Wet the cutting stem or leaf base before dipping it into the dish of rooting hormone. Completely round the stem or leaf base. Get rid of any extra rooting powder by shaking.
4. Carefully tuck leaves or stems into the rooting powder so it doesn’t fall out. The potting mix should then be carefully pressed around the cuttings.
- Insert the base at an angle just below the soil line to accommodate leaves. Put curled leaves in an upwards-curving position. (On that side, the new tiny plant grows.)
- Insert the bottom half of the stem into the potting mix so that it covers at least two bare nodes when taking stem cuttings.
5. Wait until roots start to form before watering. Once the dirt has dried, give it a good watering before repeating the process. The majority of succulent leaf and stem cuttings should root in two to three weeks, while rooting times might vary greatly. The fastest-rooting cuttings are those from stem tips.
6. After the roots have taken hold, transplant your new succulents from trays to tiny containers. Use the same kind of potting soil as you did previously. Be careful not to disrupt young, delicate roots.
Can succulents be grown from seed straight in the ground?
Fill a shallow tray with succulent soil (I like to add in some perlite or pumice) and lay the callused leaves on top to propagate your succulent leaves directly in or on soil.
They can also be planted in the ground with the calloused end down. Simply put, this wouldn’t allow you to observe the roots develop.
Water infrequently or not at all until roots begin to grow. The leaves will almost always rot if there is too much water at this time.
I spray a small amount of water just in front of the leaves after placing them on top of the soil. Just enough moisture to make the roots feel comfortable.
When roots or young succulents begin to emerge, spray the leaf cuttings to hydrate the roots. Avoid getting the actual leaves wet. To prevent the roots from drying out, repeat this procedure every few days or so.
Succulent cuttings should be kept in strong light, but until the new plants are more established, direct sun should be avoided.
Transfer them now into their individual pots. Make sure not to overly damage the roots. Keep the young succulents above the dirt and merely cover the roots with soil.
Avoid plucking up the leaves repeatedly to inspect their roots! Although it’s tempting, try to restrain yourself. The young roots can be damaged and stressed out if they are disturbed. The roots will frequently wilt and shrivel up as a result.
My succulent is already chopped, may I transplant it?
Because succulents are such hardy plants, you can actually plant a piece of one and it will develop into a new plant. It may sound like a horror film or the premise of an upcoming science fiction drama on Netflix, but it’s truly possible to regenerate something new from a severed limb. Even if one of its branches is cut off, they will still manage to survive.
Yes, you can prune or cut off a section of a succulent and plant it elsewhere. The clipped succulent piece will adapt to its new home and develop into a full-fledged succulent with the right growing circumstances.
If you want to learn more about pruning succulents, keep reading. It’s like getting numerous plants for the price of one if you get the technique down!
Propagate succulent stems above water
Succulents can indeed be grown hydroponically, but you should use caution when doing so. Remove the lowest leaves from your mother plant by making a clean cut. After that, take a water jar and wrap it with plastic wrap. Make a few holes in it, and with the stem never actually touching the water, insert the exposed nodes about half an inch above the water. Whenever the water evaporates, top it off. Your roots should begin to expand in two to three weeks.
Propagate succulents on a wet paper towel
Leaving succulents on a paper towel is another approach to grow them. For a few days, let the ends of your succulent leaf cuttings dry out on a piece of paper towel on a tray. Spray water on the paper towel after a few days, then do it again after a few days. You should begin to notice roots and pups after a few weeks. Some gardeners will additionally cover the paper towel with a clear lid with holes or plastic wrap. You can eventually move your succulents into soil using both the jar and paper towel methods. Just remember that not all of your cuttings might grow successfully because the roots might be shocked by being transplanted into a different media.
Since succulents have so many fleshy leaves and may grow rapidly, you’ll always have room to experiment even if not all of your plants produce roots and pups. You’ll be able to share your succulents sooner than you think if you use leaf cuttings, new cactus soil, bright indirect light, and sporadic spritzes of water.
How are succulent babies created?
Succulents can also grow from solitary leaves. Succulent cultivars with fleshy, plump leaves that are simple to remove function well with this technique. Leaf propagation spares less of the “mother” plant and each leaf can create numerous little plants, even though it will take much longer to produce a full-sized plant. Getting a quality leaf cutting is crucial, much like with stem cuttings. Although they must split from the plant at the base of the stem, leaves can be wiggled off of a plant. Kremblas advises caution, saying, “Be sure to reach all the way down to where the leaf joins the stem, as a broken leaf will not propagate.” And make sure to select a leaf that is firm, plump, and limp-free.
Leaf cuttings should be allowed to callus and need partial sun to grow, just like stem cuttings. Leaf cuttings should be placed on top of a thin layer of succulent potting soil (not buried), and they should be misted with water to keep them wet. The leaf cuttings will start to grow little “pup” plants in about three weeks. The mother leaves will start to wilt and drop off after eight weeks, at which point your pups are ready to be planted.
How frequently should you water succulents in propagation?
Succulents may be multiplied, giving you more of what you love. In order to share succulents with friends or because your plants have grown lanky and unsightly, you may need to propagate succulents. Whatever your motivations, we have a tried-and-true method for propagating succulents successfully.
Easy Steps for Propagating a Succulent by Leaf Cutting
1. Cut the desired number of leaves off the stem of the succulent you want to multiply.
- Where the leaf meets the succulent stem, make a precise snap. Your propagation will go more quickly and easily as a result.
- For propagation, take many leaf cuttings (see #5).
2. Allow the succulent leaf’s broken end to callus over, mend, and/or dry out.
- While a week is a fantastic amount of time, you can get away with 2-3 days for small succulent leaves and 4-5 days for larger succulent leaves while you wait for the leaves to heal.
- The succulent leaves you want to multiply should be placed on a sunny window sill to dry. The sun’s rays expose the leaves, strengthening them with nutrients as well.
- When natural sunshine is unavailable, LED grow lights are a choice.
3. Place a succulent leaf directly on the soil in a container or on a tray of soil.
- You should touch the earth with the healed portion of the leaf you are propagating, but not bury it deeply. From there, the newly propagated succulent will grow, and in order to survive, it requires light and space to breathe.
- Although it would take a lot longer to spread, you could let the leaf develop without soil.
4. Provide water and light to your succulent leaf cuttings for successful propagation.
- Depending on the temperature and humidity in your home, water succulent leaf cuttings anywhere between two and four times per week. But don’t overwater. While keeping the soil from drying out, soil should be moist but not to the point of having any standing water.
- It’s ideal to have direct, bright light. Your leaf cuttings may become scorched by too much direct sunlight.
5. Produce several leaves.
- You’ll probably experience some casualties when propagating succulents. You have a better chance of successfully growing succulents if you follow the procedures of propagation with numerous leaf cuttings.
- Place a number of leaf cuttings on a tray or large pot filled with potting soil that is lightweight. Here, you can immediately see which leaf cuttings will begin to develop roots and young succulents and are good candidates for propagation and which leaves will begin to shrivel and turn black, making them unsuitable.
6. Be patient and give your leaf cuttings enough time to grow roots, produce offspring, and reproduce.
- Please take note that leaf cuttings that produce babies but no roots are preferable to leaf cuttings that produce babies but no roots.
- You can sigh with relief when you notice that the young succulents or pups are growing. When the pups or babies appear, you can tell that they are able to produce their own food through photosynthesis as well as their own leaf systems. A leaf cutting that only grows roots may never give birth to offspring or may take a very long time to do so.
- You can always pinch or clip off the mother plant leaf once the babies/pups have formed.
7. Plant your just multiplied succulents in pots.
- Allow your babies or puppies to establish strong roots so that you can repot them into any container you want. If you propagated them in your chosen pot, let them there to continue growing.
- While propagated succulents are still in their adolescent years, keep providing them with indirect strong light. Direct sunlight will be too harsh.
- Give your new succulents a nice soak once every two weeks to water them. Don’t overwater once more. Just keep in mind that succulents store water in their leaves and stems, and that too much water around their roots will result in death by root rot.
- Remove the leaf from the mother plant that was used to propagate the plant, if you haven’t done so before. It has probably already started to shrivel up. The mother leaf remnants will ultimately dry out and fall off if you cut it close to the new plant.
*Special remark Some succulents, such as hoya and kalanchoe, cannot be propagated via leaf cuttings but can instead be done using alternative techniques, such as stem cutting. Later, we’ll talk about those.
Folks, that’s all she wrote! Your succulents that you propagated should be well on their way to developing into mature plants. Good fortune!