It consists of these four simple steps:
- Trim the stem to a length that will fit in your new pot.
- Get rid of any extra leaves beneath the main rosette.
- Dry everything for a couple of days.
- Replant your succulents and cactus in new potting soil.
Step One: Cut
If you have a longer stem to deal with, that will assist it get nicely anchored into your new pot. You may truly cut the stem anywhere and it will start to sprout roots out of the sides and bottom after you replant it. You can just nestle the succulent’s base deep into the earth for replanting, or you can use a stem as short as an inch. To create cuts like these, always use clean, sharp pruning shears. These pruning shears look to be an upgrade of the ones I’ve had for ten years and use every day and adore.
Step Two: Remove Excess Leaves
Remove any leaves that are below that in order to form a wonderful rosette formation, similar to what you presumably had when you initially purchased your succulents. Save those leaves because they may be planted in soil and will each produce a new succulent plant.
Step Three: Dry
Any cuts or cracks you create in a succulent should be left exposed for one to two days. This enables it to sort of scab over and guards against bacterial infections that may happen if the succulent is exposed to any excess moisture. The chances are good that your freshly cut succulents will still dry out without first allowing them to air dry; however, it will take a little longer for the cuts to close up and you run a slight danger of something going wrong. But it’s up to you!
Step Four: Replant
Replanting your succulents into a fresh pot using cactus/succulent potting soil is the last step. This is quite simple. Simply poke a small hole with your finger and put the plant’s stem into the soil. The added benefit is that, while they adjust to their new surroundings, you don’t even need to water them for a week!
Can stretched succulents regrow their original shape?
A succulent cannot return to its original compact height and shape once it has been stretched out. But don’t worry!
Start by using good-quality scissors to trim off the succulent’s top (I adore this pair so much! Definitely worth every cent! Leave 2-3 leaves on the base for at least an inch or two. If you leave a few leaves on the base to absorb sunlight, the base will thrive.
I’ve seen bare stems produce new offshoots, but it takes a lot longer than when I leave a few leaves on the stem. You can trim some of the stem to shorten the cutting if the cutting (the top portion you cut off) is too long for your taste.
Allow the base and the cutting to dry for a few days. You can plant the cutting in soil and start watering it once the cut end has calloused over (totally dried out and appears “scabbed”).
Cuttings do, in my experience, require a little bit more frequent watering than a fully rooted plant. To prevent the stem from becoming too soggy and rotting, use a soil that has a really good drainage system. Here is more information on how to grow succulents from cuttings.
Within a few days, maybe, but most probably within two to three weeks, the cutting should begin to give off roots. You should reduce watering as the roots take hold in order to put the plant on the same “schedule” as fully rooted plants.
Within a few weeks, the base, or original plant, will begin to produce additional offshoots. This plant can still be taken care of in the same manner as before the cut.
The leaves you initially left on the base plant can eventually wilt or drop off. Although highly common, this won’t always occur.
But if they do come off, don’t panic! Without the “parent leaves,” the young rosettes will still be able to develop.
How should leggy succulents be handled?
When cultivated in the right lighting conditions, succulents adore the sun and thrive. However, you’ve probably cultivated or observed a lanky, stretched-out succulent. In the area you have, these lanky or etiolated succulents aren’t getting the proper amount of light.
Not just succulent indoor plants experience this behavior. You may have seen how your plant stretches to reach as close to the sun as it can by bending toward it. As they extend toward the sun, succulents get taller and spread their leaves farther apart.
The compact shape of etiolated succulents won’t return, but you can give them a trim and grow additional succulents from the cuttings.
How to disassemble the plant and begin reproducing it in order to try again is demonstrated in this video by Laura from Garden Answer.
- Clear the foliage. Cut the roots and wholesome leaves from the succulent’s bottom half with pruners or by snapping them off. Get a break that is as spotless as you can to promote new growth. Get rid of your leaf if it tears. Up to a little bit after halfway up, remove leaves. To understand how to cut the stem and transplant it with the remaining rosette at the top, see to step three.
- Dry the leaves. After removal, let the leaves dry for a few days or until the raw ends have calloused.
- Replant the stem. New roots will be able to sprout if the stem is planted farther below where the leaves were removed. Simply clip the stem 1-2 inches from the plant’s base if it is too long for the pot. It’s alright if you have no stem at all. Simply bury the rosette in the ground to prevent it from falling out.
- Prepare to expand. A tray, saucer, or other container containing Espoma’s Organic Cactus mix should have dried leaves on top of it. Avoid burying leaves in the ground. Put the container in a location that will shield it from direct sunlight.
- Spray the ground until it is damp but not soaked. When the soil seems dry to the touch, rehydrate it.
- Wait. There will be new baby roots that appear in about a month.
- Replant. You can replant your propagated succulents once they have established roots. Put them on display in a recycled planter.
- The roots should be examined every six months to determine whether you need to transfer your plants to a larger pot. Espoma’s Cactus can be used to routinely feed your succulents. For optimal results, use liquid plant food.
How can a leggy succulent be made shorter?
- The plant should be cut, leaving approximately an inch or so of stem at the base.
- For a day or two, or longer if your area is humid, leave the stem cuttings in a dry location away from direct sunshine to dry. Launder and seal the wound. To hasten the rooting process, it is optional to dip the cuttings in rooting hormone.
- Put the cuttings in a well-draining potting mix after the cut has healed. Perlite and a cactus mixture are my preferred combinations (1:1 solution). You can find soil and soil amendments here.
- Every few days or whenever the soil gets dry, mist or water the area.
- The stem cuttings usually take two weeks or longer to root.
- Avoid direct sunshine and keep watering every few days or whenever the soil starts to feel dry.
- When the plant reaches maturity, increase sunshine while reducing watering.
The portion of the plant from which the cuttings were taken will keep expanding and generating new growth. Rarely, the base will stop expanding and eventually disappear. However, if this occurs, hopefully you have already grown new plants from the stem cuttings.
Decide where to cut the plant. In order to conveniently put the plant you are cutting into soil and propagate it, you should ideally have at least half an inch of stem on the bottom of the plant.
When you cut the plant, make sure to salvage as many of the roots as possible. These already have roots sprouting, so they will thrive when replanted in soil.
Your Succulent Isn’t Getting Enough Light
All plants require light, but succulents particularly crave it. Your pal may be leggy if you don’t provide a sunny area where they can soak up the light.
Insufficient sunshine causes succulents to develop lengthy stems. They begin to turn and spread out in search of light during a process known as etiolation, which gives them a “leggy appearance with a long stem and smaller, spaced-out leaves.
It can be challenging to determine how much light your plant needs right immediately because every plant is unique. Try transferring the succulent to an area where it will receive more light if you find it starting to grow a long stem without adding more leaves. You might want to think about buying a tiny tabletop grow light if your house doesn’t have a place where the sun shines.
How do I get a bushier succulent?
Any plant’s other buds will be able to grow, sometimes with astonishing vigor, if the top is pruned removed. As a result, the plant becomes bushier as each lower bud develops into a new, smaller shoot. By making a cut slightly above a bud that is oriented in the desired direction, you can control the growth.
Why is my succulent gaining height rather than width?
THE AFFILIATE LINKS IN THIS POST COULD BE USED. FOR DETAILS, PLEASE REFER TO THE DISCLOSURE POLICIES.
Your succulent does it appear different? Are you perplexed as to why it is becoming so stretched-out, tall, and leggy?
Your succulent is experiencing etiolation if it is expanding vertically rather than horizontally. Your succulent needs more light, to put it simply.
Sadly, damage that has already been done cannot be undone. But it can bounce back. Your stretched succulent can be propagated, which will result in more plants. Win!
Let’s examine this stretched Crassula perforata more closely. Find out what caused this to happen and how to solve it.
Visit How to Grow Succulents Indoors to catch up on general care for succulents.
How are lanky plants fixed?
A leggy indoor plant can be pruned to foster the growth of new stems, which will help it regain its former lushness in addition to being moved into more light. Snip just above a node to remove one-third of the length of very long, lanky stems (the point where leaves grow from the stem). If your plant is already producing new shoots from the ground, trimming back gangly stems around it will give the new growth space to absorb sunlight and thrive.
Can I cut my succulent’s stem?
Succulents require more than just sunlight and water to thrive. To encourage healthy growth, some individuals advise cutting a succulent’s leaves, stems, and roots. However, can you get away without trimming your succulents or is trimming truly necessary? Can you cut the leaves, stems, or roots of a succulent first?
A succulent’s roots, stems, and leaves can all be pruned. The major purpose of this is upkeep. Maintaining your plants can help them grow better, resist rot, and live longer. Succulents also require trimming to keep their shape and grow sturdy stems.
When to trim the roots, leaves, or stems, as well as what to do with the clippings, are all covered in this article. You will also learn the proper techniques for planting your clippings to begin cultivating new succulents.
Succulents should they be pruned?
Succulents benefit most from pruning at the start of their growing season, although you can prune them at any time. If you prune around the end of the growing season, new growth might not appear as rapidly, but it will develop gradually and accelerate once they begin to grow vigorously again.
There are numerous succulents that grow best in the summer, but there are also quite a few that grow best in the winter. To determine when your succulents are actively developing, check at this dormancy table.
My succulents are often pruned in the spring, after spending the winter indoors. Typically, they become quite stretched out and lose some of their initial beauty.
I can freshen the arrangement by pruning them without needing to buy new plants. It’s a fantastic approach to grow your garden!
Do succulents need to be in the sun directly?
1. Ensure that your succulents receive adequate light. Depending on the type, succulents need six hours of sunlight each day because they are light-loving plants. You might need to gradually expose newly planted succulents to full sun exposure or give shade with a translucent screen because they can burn in direct sunshine.