Cuttings can be grown in a temporary pot while they develop roots, or you can just plant them in a permanent container. In either case, you’ll need a pot with a drainage hole that’s big enough to give each cutting 2 to 3 inches of space.
To shield your succulents from standing water and root rot, fill the container with a grittier, well-draining soil. Cactus/succulent potting soil is typically available at garden centers. Alternatively, you can create your own by mixing 3 parts potting soil with 2 parts coarse, salt-free sand and 1 part perlite or pumice.
Plant the Cuttings
Insert the cut end of a stem 1 to 2 inches into the ground. If the succulent has leaves, you might need to remove a few of them to reveal the stem’s base. The lowest leaves shouldn’t contact the soil; they should rest just above it. To help the cutting stand straight, softly compact the dirt around it.
Remove any necessary leaves from stemmed succulents to expose 1 to 2 inches of stem for planting.
Pick the Right Location
Choose an area with enough of airflow, bright indirect light (not direct outdoor sun), and succulents that are still young. Cuttings require sunshine to develop new roots, but direct sunlight might cause them to quickly dry up. On indoor succulents, good airflow helps avoid gnat and mealy insect infestations.
Water
Cuttings require constant hydration until they can form roots, unlike mature succulents. Water the soil just enough to prevent it from drying up, but not too much that there is standing water. Actual frequency varies depending on humidity and temperature but is often 2-4 times each week.
Care for Rooted Succulents
A very slight pull will reveal whether a cutting has roots after 4-6 weeks. Change to deeper, less frequent watering for succulents with roots. Water just once the soil is completely dry, which takes about 2-4 times each month. If necessary, repot the succulent and relocate it gradually to the right lighting. Don’t increase light exposure for 1-2 weeks to give the plant time to adjust. Maintain your succulent’s care, and in the upcoming months, keep an eye out for above-ground development.
Do the succulent leaves need to be exposed to the sun while being propagated?
Taking an active, healthy leaf from a mature succulent plant and utilizing it to establish a new plant is known as “propagating with leaf cuttings.” Because the leaves of succulents with fleshy, plump leaves, like echeveria, are simple to snap off cleanly, this method of propagation works well with them.
While some leaves may simply pop off with a little tug, others could necessitate the use of a sharp knife. Take a healthy leaf from the plant’s base with clean hands or a sterile knife, making sure to remove the full, undamaged leaf.
After being removed, allow the leaf to recover for about four days in a warm, well-lit area so that the wound can callus over. When the leaf has calloused, prepare a fresh planter with soil, fill it with water, and set the callused leaf on top of the soil for multiplication.
When the earth is dry, spritz your leaves with a spray bottle. Keep them warm, in a room with lots of light, but out of direct sunlight. They must be kept warm and moist.
Little roots and leaves will start to emerge after around three weeks! A succulent may need a few months to grow large enough to be replanted (photos above are after about 8 weeks). When the leaf eventually turns brown and falls off, you’ll know it’s time. This indicates that the succulent no longer requires the leaf because it has consumed all of its nutrients.
How long does it take for cuttings of succulents to take root?
Succulents can be propagated in water, but doing so goes against the ideal growing circumstances for these plants. Start your leaves and cuttings in shallow planting trays or tiny containers packed with potting soil for the best outcomes. Succulents can be grown in individual containers without having to transplant them right away.
Follow these easy steps once planting day arrives and your leaf or stem cuttings have callused:
1. Get your planting trays or containers ready. Use a coarse, quick-draining potting mix made for succulents and cacti and gently moisten it. 2 Make planting holes with a little stick.
2. Add a little RootBoost Rooting Hormone to a serving dish. When pouring, only utilize what you’ll need and discard the remainder.
3. Cut one piece at a time. Wet the cutting stem or leaf base before dipping it into the dish of rooting hormone. Completely round the stem or leaf base. Get rid of any extra rooting powder by shaking.
4. Carefully tuck leaves or stems into the rooting powder so it doesn’t fall out. The potting mix should then be carefully pressed around the cuttings.
- Insert the base at an angle just below the soil line to accommodate leaves. Put curled leaves in an upwards-curving position. (On that side, the new tiny plant grows.)
- Insert the bottom half of the stem into the potting mix so that it covers at least two bare nodes when taking stem cuttings.
5. Wait until roots start to form before watering. Once the dirt has dried, give it a good watering before repeating the process. The majority of succulent leaf and stem cuttings should root in two to three weeks, while rooting times might vary greatly. The fastest-rooting cuttings are those from stem tips.
6. After the roots have taken hold, transplant your new succulents from trays to tiny containers. Use the same kind of potting soil as you did previously. Be careful not to disrupt young, delicate roots.
Gather Your Succulents To Plant
For this video, we’ll be planting a variety of succulent species using both cuttings and discarded leaves. Amass the materials you want to plant. You can either utilize fallen leaves or cut cuttings from an established plant. If you can’t locate cuttings anywhere else, you can usually find them online and at most florists. Although these are also available on Amazon, I got mine from a vendor on Etsy.
Prepare your succulents for planting.
The most crucial step in this method is preparing your succulents. Make sure you have enough stem to plant in the ground so it can support the plant. Any excess leaves at the stem’s base should be removed. It’s good to leave approximately an inch of the stem exposed for larger cuttings, and you can use less for smaller cuttings.
After that, examine the base of your cutting. The plants ought to have a “callous” on them, which denotes that the plant’s base has dried out. You should wait a few days before planting freshly cut succulents because this forms a few days after the succulent is cut. By letting the cut end dry more quickly on a paper towel or paper bag, you can hasten this process.
Succulents are wonderful because you can also plant their leaves, so hold onto the ones you pulled off the stem. Verify your succulents for any bad components. Any area of the plant that is dark contains rot, which can spread to other areas and ultimately destroy the plant. Simply cutting it will allow you to get rid of the rotten parts.
Mix your soil.
If you aren’t using a pre-made succulent soil mix, you’ll need to prepare your soil so that it will drain effectively and support the growth of your succulent plants. I mix one part potting soil with one part sand, which allows the soil to drain well. In order to help larger plants become more firmly rooted in the ground, I also prefer to have a supply of tiny rocks nearby.
To fill a pot or tray, pour your soil mixture. I’m repurposing an old baking pan that I can’t bake in as a planting tray.
Plant!
We’ve reached the enjoyable part now! Make a little, inch-deep hole in the ground. After inserting your cutting, fill up the depression with soil.
Make careful to space your cuttings, if you’re planting more than one, roughly 2-3″ apart.
Ensure that your plants receive adequate water. Although succulents don’t often require much water, you may need to water them every 2-4 days while they are developing their roots, depending on how dry the soil becomes. It’s normal for the leaves to initially appear a little dried out because the plant is using its reserves of stored energy to develop new roots. New growth should begin to appear in around four weeks. Change to weekly watering or watering only when the soil is dry once the plants have set their roots and have started to grow.
Admire and Show Off Your Work!
Well done! Show off your incredible craftsmanship and green thumb to all of your friends! These plants will be prepared for repotting if you desire once they have developed roots and begun to grow, which should take around 3 to 6 weeks. They make wonderful Christmas gifts for friends and coworkers when planted in a tiny Mason jar or vibrant pot!
Why isn’t the cutting of my succulent rooted?
You recently purchased some gorgeous succulent cuttings from a nursery in your neighborhood, or even better, online with free shipping. The cuttings you purchased are incredibly lovely, and you can’t wait to see them take root, develop, and flourish just as you anticipate!
Sadly, weeks have passed and your succulent cuttings haven’t even the least bit rooted! Now that the succulent cuttings appear dried up, wrinkled, or dying, you’re probably wondering why they aren’t taking root.
Be kind to yourself because this is something that occurs frequently. Rooting succulent cuttings is a challenge for many succulent growers, especially beginners. Especially if you recently purchased these cuttings and they aren’t rooted, it might be really discouraging.
Your succulent cuttings not rooting for a variety of reasons. It can be the result of overwatering, underwatering, insufficient sunlight, a lack of nutrients, improper soil use, or improper potting.
Not to worry! By the time you finish reading this article, you’ll understand exactly why your succulent cuttings aren’t rooted and how to fix the problem.
Why are the cuttings of my succulents dying?
Cuttings from succulent stems won’t take root if
- Before being planted in soil, the cuttings weren’t given a chance to scab or dry out.
- Either the growing medium has insufficient drainage or the improper sort of soil was employed.
- Overwatering or an extended period of damp soil led to decay before roots could take root.
- The stems dried out and eventually died off due to underwatering or very dry soil.
- The soil dries out too quickly and burns stem cuttings before roots have a chance to form due to excessive heat or sun exposure.
- propagating in the incorrect time of year or when dormant.
The majority of people should typically start noticing rooting in three to six weeks. If by then you haven’t noticed any roots forming, it might be because of one or more of the aforementioned factors.
Are there Succulent Species that Won’t Propagate Through Stems?
Stem cuttings can be used to multiply the majority of succulents. There are some species that cannot be multiplied by stems, including:
- Agaves
- Aloes
- Hens with chicks, or Sempervivums
- Haworthias
Instead of using leaf or stem cuttings for reproduction, the majority of the aforementioned species produce pups or offsets.
Does the length of the stem cuttings matter?
The stem cuttings’ length or size don’t really matter. Getting cuttings from a healthy plant and during its active growing season is very important. In this manner, you can be sure to achieve more success more quickly.
Why is it unlawful to propagate some succulents?
With a plant patent, you have just purchased the right to utilize that plant. It is not permitted for you to spread it in any form.
You can’t actually take cuttings, trim your patented plant, or propagate it asexually, believe it or not.
However, boosting sexual reproduction, or pollination, would actually increase your earnings.
You see, when plants A and B sexually reproduce, they don’t create more of either plant. It produces plant C.
That is significant in the horticultural industry as well! You have consumed every single gala apple that has ever come from the “same” tree. The original gala tree supplied the branches that were used to graft gala apples onto other apple plants. Because it was pollinated by a blossom that wasn’t a gala apple, if you ever planted a seed from a gala apple it would grow into something similar but distinct from a gala.
All of that may seem convoluted, but the simple version is that pollination results in a completely new plant (which you could patent if you so desired!).