Take each vine and decide where you want it to be topruned. Always trim the vine 1/4 inch (about 2/3 cm) above each leaf. A node is the spot where the leaf joins the vine, and after you’ve clipped it, your pothos will send out a new vine in that location.
Take care not to leave any vines with no leaves. I’ve discovered that these don’t usually regenerate. It’s probably advisable to remove any leafless vines entirely.
Repeat the technique until each vine has been selectively pruned and the results are pleasing to the eye. You can take tip cuttings on any vines that are excessively long if you just want to undertake a light pruning.
After you’ve pruned your pothos, you can use all of the cuttings you’ve made to reproduce your plant.
Simply trim the vines into smaller portions to make them easier to manage. Remove the bottom leaf to reveal the node, then place it in a vase or propagation station filled with water. That bare node has to be submerged.
Make sure each cutting has at least one leaf. At the nodes, new roots will begin to sprout soon. You can pot the roots after they are about 1 inch (2.5 cm) long.
You can either start a new plant or replant the cuttings back into the container from whence they were taken to create a fuller plant.
How do you take a cutting from a pothos?
Instructions in a Step-by-Step Format
- Cut the stem at a 45-degree angle about 1/2 to one inch below the third leaf.
- The top two leaves can be kept, and the third (lower) leaf can be removed by making a clean cut near the stem.
Will pothos grow back after cutting?
Pothos plants can’t recover their leaves, whether they’ve been removed by you, fallen off due to illness, or been damaged. But don’t panic, the pothos, like other plants, will regrow new leaves.
When should I cut my pothos cuttings?
Placing the cut ends of your stems in water is the initial method of propagating pothos. For roots pothos, use an old glass or jelly jar. Place the pothos cuttings jar in a location that receives plenty of light but not direct sunshine. You can plant the cuttings in soil and maintain them like any other houseplant around a month after the roots appear. However, the longer pothos cuttings are submerged in water, the more difficult it is for them to adapt to soil. Pothos cuttings that have begun to root should be transplanted as soon as possible.
The recommended way of propagating a pothos starts with the same steps as the first. Remove the first leaf above the cut ends from the pothos cuttings. Rooting hormone should be applied to the cut end. Make sure the initial set of root nodes is covered. Set the cuttings in a half-peat moss, half-perlite or sand potting mix. Keep your roots pothos away of direct sunlight and the soil moist. After one month, the roots should have developed, and the new plants should be ready in two or three months.
Can you put pothos cuttings directly into soil?
Pothos plant propagation can be done in either water or soil, but once started, the plant has a hard time transitioning to another media. If you put the cutting in water, the plant should stay in the water as it grows. The same can be said for a cutting that has been propagated in the soil.
Should I cut off damaged pothos leaves?
Trim away any damaged leaves so that the pothos plant can focus more of its energy on healthy new development. Leaves that have yellowed, dried out, or turned brown are doing less work for the plant, forcing the remainder of the plant to work harder to maintain them.
Do you cut above or below the node?
Leaves, buds, and shoots sprout from the stem at the node. You should always trim slightly above a node to avoid ‘die back’ and, as a result, disease. You can even control new stems, leaves, or flowers to form in a desired direction by cutting above a node, as nodes form on opposite sides of a stem. Don’t cut too close to a node because it will be damaged, but don’t leave more than 1cm above the node since you’ll end up with an unattractive stump that won’t grow and will eventually die.
How do you keep pothos from cuttings?
Pothos cuttings in water can be propagated rather easily if you take adequate care of them. Make sure your vine cutting is made precisely below a node, and that any nearby leaves are removed so they don’t drown in the water and inhibit the establishment of new roots.
Place a healthy cutting in a jar of water and place it in indirect sunlight once you have it. Begin fertilizing the water straight away (every a month or so) to ensure that the cutting has enough nutrients to thrive. Apply an all-purpose liquid fertilizer so the plant has rapid access to it, and make sure you use the proper amount so you don’t risk algae from excess nutrients.
How do I make my pothos grow thicker?
Pothos should be pruned frequently to keep it full and prevent it from growing lanky. To assist pothos grow fuller faster, feed it twice a month with a balanced fertilizer and provide adequate lighting and water. Stake your pothos as well to provide support and encourage the development of larger leaves.
If you like a fuller appearance, continue reading for advice on how to give your Pothos a fuller, bushier appearance.
Step 1: Prune Correctly
I have to start pruning my pothos on a regular basis to get it to branch and grow fuller. But it also meant that I had to prune properly.
- Take a few steps back and examine your pothos as a whole. As your plant grows taller, this phase becomes even more critical.
- Make a mark on the vines that you want to cut. Colored elastics or plastic ties can be used. Just be careful not to injure the stems when marking them.
- Only approximately a third of the overall stems and leaves should be pruned. You can prune less, see how your plant develops, and then prune again.
- Clean the blade or shears you’ll be using and make sure they’re sharp so you can make quick, clean cuts.
- Remove any vines that don’t have leaves or are beginning to trail downward.
Step 2: Support Your Pothos
To give my pothos plant extra support, I staked it. You might be wondering how staking the plant is beneficial.
When you stake a trailing plant like a pothos, you’re giving it support and encouraging it to produce bigger, closer-together leaves.
It’s advisable to start staking your devil’s ivy when it’s still young; it’ll help your plant grow fuller in the long run.
What can you use to stake your pothos? For my first pothos, I utilized a bamboo cane; other keen gardeners use moss poles, trellis, or anything similar.
Step 3: Add Fertilizer
When my pothos began to grow leggy, I recognized it might be suffering from a nutrient lack. So I began applying a balanced fertilizer once or twice a month to help address the soil’s nitrogen deficiency.
Because a concentrated dosage of fertilizer can burn your pothos’ roots, follow the manufacturer’s directions for diluting it.
Step 4: Consider Warmth and Humidity
Because they are native to tropical and subtropical locations, tropical plants like the pothos demand warmer weather and humidity.
Your pothos will thrive best if you provide a warmer climate with temperatures between 65 and 85 degrees Fahrenheit and at least 50% humidity.
Step 5: Water Properly
It is recommended that you water your pothos using the soak-and-dry method. I only water my plant when the earth is absolutely dry, then I soak it in water, and then I water it again when the soil is entirely dry.
It’s also vital to examine the soil and pot in which my pothos is planted when watering it properly. All of my pothos are kept in pots with a wide drainage hole on the bottom.
Step 6: Provide Enough Sunlight
Because my first pothos didn’t get enough sunshine, it expanded and looked for it. As a result, the leaf nodes began to stretch out further and wider.
The solution was simple. I simply placed my pothos closer to a window so that it could get about 10-12 hours of sunlight per day.
Do not place your pothos next to a window. If your window faces south or west, it should be a few feet away, while east and north-facing windows should be much more away.
Make sure your plant gets no more than 3-4 hours of direct sunlight per day. The remainder of the day, use filtered light to avoid sunburning your plant’s leaves.