All lilacs should generally be clipped right away in the spring after they have finished blooming. Lilacs set their flower buds for the following year immediately after the current year’s flowers have faded, therefore trimming later in the summer or fall will result in the removal of most or all of the blossoms for the following year. The larger common lilacs as well as the shorter or more “shrub like” cultivars are all subject to this timing guideline. While the “when” of lilac trimming is rather simple, the “how” is a little more difficult. For the time being, we’ll refer to lilac pruning as either maintenance pruning or rejuvenation pruning to keep things simple.
Can lilacs be severely pruned?
A: There are a number of potential causes for your lilac’s failure to bloom. The two most frequent culprits are insufficient sunlight and poor pruning. Lilacs (Syringa) should be planted in an area with at least six hours of direct, bright sunlight per day. They can withstand a wide range of moisture levels as long as they are grown in soil with good drainage. If your lilac is clipped at the wrong time of year, it might not blossom for another reason. Lilacs bloom in the spring on the growth from the previous year, and soon after, they begin to form the buds for the following year. Within a couple of weeks of the plant blooming, pruning must be done in order to prevent the removal of the buds for the next year. You can softly clip young lilacs to keep them in check, within boundaries, and flowering profusely. In order to revitalize older plants and increase flower production, a rigorous pruning almost to the ground may be necessary. A late freeze can harm flower buds on types that bloom early.
Lilacs have a tendency to mature into overgrown, leggy shrubs with minimal foliage at the bottom. When this occurs, it might be required to prune them to within 12 inches of the ground in order to completely rejuvenate them. When the shrubs are dormant in late winter, this should be done. Lilacs benefit from this repair, although their blooming cycle will be hampered for at least one season. Lilacs can receive a rejuvenation pruning over a two-year period to stop the interruption of bloom cycles. One year, hard prune half of the shrub’s stems; the following year, hard prune the remaining stems.
Lilacs do not consume a lot of food. Excessive fertilization, particularly nitrogen fertilizer, can frequently promote luxuriant vegetative growth at the expense of flower development. The number of blossoms won’t increase with fertilization. A lilac’s failure to bloom could potentially be due to its proximity to turf that receives frequent fertilization.
How much can you prune back lilacs?
Cutting no more than a third of the stems from a shrub should be the general guideline when pruning it. While a result, the plant will continue to thrive and grow new stems as the old ones bloom. Your aim is to grow a lilac bush with between eight and twelve stems, all between one and two inches in diameter, and of varying ages.
Prune Unsightly Features
Pruning should start with the removal of diseased, dead, and pencil-thin suckers and twiggy growth. Trim these all the way to the ground. These stems are typically handled by pruning shears or loppers.
Remove Any Stems Thicker Than 2 Inches in Diameter
By routinely removing entire old stems, you can keep your lilac from growing too tall. Removing only the tops of lengthy stems might cause the plant to take on an unusual, unnatural shape. A pruning saw could be essential for stems that are quite large. It can be difficult to handle thick lilac stalks.
Prune Remaining New Stems
Pruning the remaining new stems to an outward-facing bud will encourage your lilac to fill out more and develop a shrubby appearance. This entails trimming just past buds that point away from the plant’s core. A denser shrub will result from this technique’s increased branching.
Do lilacs require pruning?
An old, overgrown lilac was one of the few plants that endured my garden restoration. The fact that it obscured my neighbor’s garage and, more importantly, sported steel-blue double flowers, led me to rescue it. Although the blossoms on this shrub were both lovely and fragrant, it was difficult to appreciate them because there were so few of them. I decided to go with a rejuvenation pruning because I knew there was no reason to give up on this long-neglected plant because lilacs can handle severe pruning.
On stems that are no older than five or six years, the common French lilacs (Syringa vulgaris cvs.) yield the most and the largest flowers. The flowers get fewer, smaller, and farther away as the stems get older. A lilac, however, may reliably produce blossoms for decades with the right trimming. The method you choose will depend on how old your shrub is. Plants are maintained annually to keep them healthy. A more drastic trimming may be necessary for lilacs like mine that have seen better days.
Lilacs should be clipped annually to encourage healthy stem development and strong growth that improves flowering. Cutting sick, deformed, and unproductive stems to the ground constitutes annual pruning. I thin and cut back some stems as well to promote healthy, evenly spaced growth. To prevent them from growing too far away from the center of the plant, I also pruned a few of the new shoots that emerged from the roots. I left a few inches between each stem to prevent crowding. Since they produce the most, I maintain the pencil-thick shoots that extend all the way to the ends of the branches. Small, twitchy growth is unproductive and won’t blossom. This growth can indicate an excess of aged, unproductive stems or too much shadow. Remove stems as soon as possible after blossoming, or in late winter if you don’t mind losing a few blooms. Cut off stems and shoots at or just below the soil line.
Dwarf lilacs rarely need pruning
Both the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”) are twiggy-habiting, somewhat small lilacs. On these types, just deadheading is needed in terms of pruning. You can prune some of the older stems as the plants get older to make place for younger, more robust stems. In contrast to regular lilacs, these plants hardly ever spread out of control. They might never need to be entirely regenerated if you only undertake a tiny amount of trimming every few years.
After the blooms have faded, deadheading, another aspect of annual maintenance, should be carried out as soon as feasible. Just above the two new shoots that slant out from the stem that stopped with the old bloom, the base of the old flower cluster should be cut off. The new shoots will develop throughout the course of the summer, produce flower buds, and culminate in a cluster of flowers the following spring. While not as crucial as the annual thinning, eliminating the old blossoms enables the plant to focus more of its energy on developing robust branches and flower buds. In June, I deadhead and thin my plants as needed.
While performing this yearly maintenance, I occasionally come upon a young, robust shoot that may be getting too tall but is still a good, productive stem and is a candidate for tipping off. I cut the wasted flower’s entire top stem back to one or two side shoots at the desired height rather of just cutting it off at the base. The side shoots that are now near the top of the bush are encouraged to grow vigorously and develop flower buds for the following year by this cut, which also aids in shrinking the shrub.
My own old, overgrown lilacs need more severe pruning. I went outside in the early spring before growth got going to get a good look at the bush. I looked to see if the plant had been grafted before I began chopping. I immediately cut it down to the ground as it hadn’t (for a grafted plant, see the panel below). I recognized that this drastic trimming would result in the plant losing part of its aesthetic appeal for a few years because lilacs bloom on the growth from the previous season. However, I was also aware that the reward—more blossoms and a stronger plant—would be worthwhile.
It’s crucial to nourish the plant after rejuvenation pruning with compost, composted manure, or a balanced chemical fertilizer and to make sure the soil pH is close to neutral, which lilacs appreciate. In the upcoming years, these supplements and some high-quality mulch will help to encourage vigorous new growth and enhanced flowering.
Has your lilac been grafted?
If your lilac has been grafted, check it out before you start making cuts to the stems. Grafting is a method of plant multiplication in which the scion, or branch, of one species is joined to the rootstock, or stem, of another species. This is typically done to enhance a plant’s look or traits. A graft union, where the cultivar’s scion wood joins the rootstock several inches above ground level, should be obvious. An apparent change in the bark from the rootstock to the scion’s bark, as well as a little swelling at the graft union, are things to watch for. If your plant has been grafted, all of your cuttings must be made above the graft union, and you must prevent shoots from the rootstock from developing into new flowering stems. Flowers of the desired shape or color will not be produced by shoots that emerge from the rootstock.
How can I trim a lilac shrub that has gotten too large?
Similar to the lilac, heavy pruning needs to be done over a number of years. Remove any dead, spindly, dying, or ill-looking wood first. At the base, remove roughly a third of the tallest, oldest branches. The remaining branches should then be cut back by at least a foot. Over the following two years, repeat the same action.
Azaleas and rhododendrons prefer somewhat acidic soils. The optimal time to fertilize in the spring is right after flowering. Though slightly more expensive than chemical fertilizers, organic fertilizers release their nutrients gradually and require less frequent application. After July 15, refrain from fertilizing to prevent the plant from going into full dormancy before winter. Use of lime or alkaline fertilizers should be avoided.
In the summer, rhododendrons and azaleas require a lot of water due to their shallow, fibrous root systems. Make careful to thoroughly hydrate them. You will require water all year long if they are planted beneath wide eave overhangs. Avoid going too deep when hoeing or raking around the plants. Mulches can be used to control weeds, maintain more consistent soil temperatures, and save moisture. Examples of such mulches include sawdust, bark dust, peat moss, straw, or other organic materials.
The garden is busy at the moment. These days, your vegetable garden can contain just about anything. Don’t put it off! Plant more lettuce, carrots, beets, potatoes, peas, cucumbers, squash, pumpkins, melons, dill, basil seedlings, and brassicas. Also plant more beans, tomato and pepper plants, and more lettuce.
Is it possible to remove lilac bushes to the ground?
The lilac tree will resemble nothing more than a twig in the garden by the end of September. It shouldn’t be reduced to the ground, though. Despite the fact that lilac trees are known for their resilience, it will likely take several years before you see blossoms again because you cut off all the blossoming growth.
If your lilac tree is more mature and unruly, it may require more aggressive pruning and some chopping back; just make sure that it doesn’t take up more than a third of the tree.
What distinguishes a lilac bush from a lilac tree?
Lilac bushes (also known as shrubs) are characterized by their numerous woody stems that emerge from the plant’s base. In contrast, the trunk of the majority of lilac trees is the only woody stem. However, your neighborhood garden center might also sell shrub lilacs that have been grafted onto a single stem to give them the appearance of miniature trees.
The choice between a lilac tree and a lilac bush is typically determined by the amount of space available. Lilac bushes come in a range of sizes and can be placed in more compact areas of a garden. A lilac tree requires space to reach heights of 20 feet and widths of 15 feet. Both require sunlight to bloom well.
How are lilac bushes pruned for the winter?
Cutting off the tops of stems that have grown out of control is frequently insufficient when pruning lilacs. It is typically preferable to remove the entire stem. The best way to trim lilacs is with clippers. To avoid spreading and promote later blooms, remove spent blossoms right down to the stems. Three-quarters of the branches should be pruned. Remove any shoots that are emerging from the main trunk and are growing close to the ground. Lilacs within the inner branches may need to be trimmed in order to increase air flow or let more light through.
However, it may be essential to prune the entire bush or tree to approximately 6 or 8 inches (15-20 cm) above the ground if lilac shrubs are already too big or starting to look unpleasant. Remember that it takes around three years for flowers to grow after the entire bush has been removed, so you might have to wait.
Does new or old wood produce lilac blooms?
What specifically prevents these traditional plants from blooming? Instead of focusing on just one theory, consider a number of potential causes for this issue, including (in addition to illnesses and pests):
- Pruning when it’s not necessary
- The flower buds die in the cold
- placing your lilacs in the incorrect location
- The shrub in question either isn’t old enough to generate flower buds or is too old to do so.
You’ll see that while reasons one and three point to the gardener having done something incorrect, arguments two and four point to no one having done anything incorrect.
Why does it matter what time of day you prune? Shrubs called lilacs produce flowers on rotting wood. This indicates that the flower buds for the upcoming spring’s blooming season have already been formed on the growth from the previous year. When this growth is pruned, the flower buds and, consequently, the blooms they would have produced, are lost. Because of this, it is recommended that you clip lilac bushes as soon as they finish flowering (before they have set bud for next year).
Click Play to Learn How to Prune Lilacs
Despite being a relatively cold-hardy plant, the common lilac (Syringa vulgaris) can suffer harm if a hard frost or freeze occurs just as the flower buds are about to open. As a result, that year’s flowers are lost. You can’t really stop it, so simply accept the loss and look forward to the blossoming twice as much the next year.
Where you put your lilac shrub matters a lot, just like it does with most other plants. Lilacs require full sunlight and prefer well-drained soil. If you made a mistake when you first put your plants on either of these fronts, you can be paying for it today by your lilac not blooming. However, there is a simple solution to the issue: move your shrub to a more favorable location.
Regarding the fourth reason, be aware that although though these bushes have a long lifespan, they do tend to produce fewer flowers as time passes. Implementing a rejuvenation pruning on your lilacs will solve this issue (do not expect immediate results, though). Sometimes, though, the converse is true: your plant may be too young to bloom. Allow some time.