Yes, I am aware that using water to dry hydrangeas seems a little backwards, but I assure you that it is the simplest method. Thus, this is what you do:
- Cut:
- Cut the quantity of hydrangeas you intend to dry or incorporate into your current cut flower design.
- Make them 12 to 18 long. Once I get all the stems together, I normally make the initial cut longer than that and depending on where it would preserve the shrub in good condition.
- De-Leaf:
- Simply move your hand down the stem, pulling off the leaves as you go, by grasping it at the top just below the bloom. I suppose you could go up, but if you do, you run the risk of picking up too much speed and damaging the bloom as well.
- I frequently conduct my de-leafing in the garden, leaving the leaves to act as natural compost in my beds. If you do it inside, though, stripping your stems directly over a garbage can will make cleanup much simpler.
- Fill a vase with:
- Simply arrange your hydrangeas like you would any other flower arrangement, which will require some trial and error in placement if you want to enjoy them before they dry—I don’t know why you wouldn’t.
- I typically hold each stalk in one hand while moving the others such that the flowers with the straightest upward faces are in the center and the smaller and/or droopier ones are on the sides. I then make my final selection, keeping them all at the same level, after gauging their height in relation to the vase.
- The bottoms of your stems should then be pounded with a hammer to aid in their water absorption, however I’ve never tried it; feel free to.
- Just before placing flowers in the vase, I twist tie or rubber band the stems to secure them in place.
- Adjust the arrangement of the blossoms after placing them in a tall vase strong enough to hold the length of the stems.
- Insert Water:
- I’d advise adding the water before the flowers if your faucet doesn’t extend with a hose. Do it either way if you have one of those posh faucets.
- Usually, I would fill the vase about half and three quarters full, making sure that all of the stems were submerged completely.
- Dry:
- You might have to keep adding water until the flowers are completely dry, depending on how the blooms were when you started the drying process. If not, I’ve seen that they wilt and then dry wilted, which isn’t very attractive.
- Therefore, maintain watering if the flowers are still quite supple. You can stop watering them once they have dried out and feel and look like paper.
- You can enjoy your lovely dried flower arrangement for many years once a few weeks have passed. On our mantel, we really have a pair that has been there for about 9 years.
- Spray:
- When your hydrangeas are completely dry, mist them with hairspray aerosol (sorry, aerosol spray just works better than the pump spray kind…it just does).
- I used to believe that this was done to coat the blooms in order to keep their color for a little while longer. But now I believe it’s only to keep the florets together, making it less likely that they will fall off when you brush up against them and make a big mess.
How are dried hydrangea blooms kept fresh?
Put the flowers in a vase with an inch or two of water, and remove all of the leaves off the stem (or at least the portion of the stem that will be immersed). Place the vase away from direct sunlight in a cool location. The water in the vase will aid in slowing the drying process, which will improve the preservation of the bloom. They will be fully dried and endure forever once the water has been removed.
The preserved hydrangea heads can be touched to determine how dry they are. They must feel like paper.
Due to the fragility of dried hydrangea flowers, it is frequently preferable to make your craft or dried flower arrangement before they dry. With this hydrangea wreath, I did exactly that. I used partially dried flowers to make the wreath, then I let the door dry completely. View the wreath’s instructions here.
How can you preserve the color of dried hydrangea flowers?
You may appreciate the blossoms’ timeless beauty all year long by drying them. Vase drying and silica drying are the two basic techniques for hydrangea flower drying. Silica drying results in more bright color, whereas vase drying is simpler and less expensive. Use the vase-drying technique, which results in blossoms with vintage colours, to keep things straightforward.
Timing is Everything
The key to success is knowing when to cut hydrangea blossoms for drying. Even though you might be tempted to cut blossoms off the plant as they reach their height of color, it’s crucial to let flowers start drying on the plant. The petals of the flowers will start to feel papery and change colors after they have graced your garden for a few weeks. Depending on the environment and soil pH, oakleaf hydrangeas like TaraTM take on traces of coral or rose, and big-leaf hydrangeas like Dear DoloresTM pick up hints of purple, burgundy, or turquoise. It’s time to grab the pruners when you see colors changing and petals becoming less flexible.
Making the Cut
After the dew on the petals has dried in the morning, trim the stems. Cut stems at an angle with sharp shears or pruners, leaving 12 to 18 inches of stem. Cut the leaves off the cuttings, then put them in a bucket of water. Picky because cuttingdrying brings out flaws in the blooms. Select the nicest flowers to dry and leave the others for the garden to enjoy.
Arrange in Vases of Water
What, we dry flowers with water? Even though it might seem counterproductive, drying hydrangeas in water-filled containers helps keep their color. Put cuttings in vases or other transparent containers and add water until the stem is immersed by a few inches. Don’t pack the vases too tightly. Each bloom needs space to keep an open form and adequate airflow to dry. To give each flower enough room, try staggering the stem lengths.
Allow to Dry
Put containers in different rooms of your house so you may enjoy them while they dry. Keep the flowers away from direct sunshine, though. As the flowers dry, let the water naturally evaporate from the containers. Drying time for blooms can be two weeks or longer. If the water in the vase has evaporated but the flowers have not yet dried, you can add extra water.
When the stem snaps easily and the petals feel stiff, the dried flowers are ready to be used. Simple vases filled with dried hydrangeas, wreaths made of dried hydrangeas, and window boxes decorated with dried hydrangeas all look charming. They are ideal for our flexible Golden Rings tabletop setup as well.
Build out wreath with dried hydrangeas
I started by gathering all of my dried hydrangeas and putting them together into a wreath. I attached the flowers on a grapevine wreath that I purchased from a craft store as the base. I made two hydrangea wreaths from of my large collection of dried hydrangea blossoms: one large wreath from blue hydrangea blooms and one mini wreath from green Annabelle hydrangea blooms. All those flowers were produced in one season because once hydrangeas are established, they are incredibly fruitful.
It wasn’t difficult at all to attach the dried hydrangea blossoms to the grapevine foundation. Simply forcing the stems through the vines typically keeps them in place rather well. In addition to plugging in the dried flowers, I also pruned some excessively protruding little vine bits to safeguard the dried flowers.
After approximately filling in each of the hydrangea flower heads one by one to complete the circle, I filled in any significant vacant spaces to ensure enough covering. I use some hot glue to attach the flower stems to the grapevine wreath that don’t stay there very well.
If you like, you may wrap them in florist wire like in this post, but I was too lazy to do that and I knew I would leave it hanging on the wall when the project was finished. Whether or whether your grapevine wreath can hold the stems well and how much they’ll be handled once finished will determine how much you want to secure the flowers.
Spray dried hydrangea wreath with flower dye
After that, I colored the hydrangeas using a floral spray. The floral spray is a clear flower dye that gives flowers a very natural-looking appearance. The majority of flowers fade with time, therefore I used this spray to keep my wreath’s color consistent for a very long period while also enhancing the original flower and making it somewhat more brilliant.
I used the hue hydrangea blue, which is ideal for the flower I chose. Since the base color of my Annabelle wreath was lime green, I also used fresh green flower dye.
Fill in accent flowers
The next step is to add filler flowers, which is also why I didn’t mind if my first layer of hydrangea blossoms had a few minor gaps. I used billy balls and strawflowers from my yard to make this wreath. I wouldn’t even bother spraying either flower because they are known for having an endless lifespan.
After the hydrangea layer, I simply drizzle them evenly over the wreath, aiming to fill up any holes I may have. I use a hot glue gun to add a bead of glue to the end of some of the flowers’ extremely thin stems before inserting them into the wreath. In this manner, I was able to fasten them to the wreath without risking damage by pressing them in too firmly.
My advice for making a DIY flower wreath that looks good is to work your way down in size, so I started with the hydrangeas before switching to strawflowers and then craspedia. Another piece of advice is to change the quantity of several flower varieties. As an illustration, I used twice as many strawflowers as craspedia. The wreath will have more depth and interest if done this manner.
Applying a coat of UV protectant spray can prevent the flowers’ color from fading if you intend to hang your DIY wreath in a location with strong light. Although it is optional, this step can be useful if you want your dried flowers to maintain their brilliant color.
Due to the size of the green wreath with preserved Annabelle hydrangeas, I only utilized billy balls as accent flowers. Once I’ve preserved additional blooms, I might trickle in some little blossoms in the future.
Attach ribbon or string for hanging
I simply tie a rope to the back of the wreath once the flower-building portion is complete so I can hang it in my house! The use of a ribbon is yet another adorable concept. It strikes me as a fantastic idea to give this wreath more color and texture.
Mine is in the hallway leading to my living room. I believe it complements my gold mirror frame rather well.
That concludes the instructions for making this dried hydrangea wreath. I’m very happy with the way this project turned out, and every time I pass by it, it makes me feel better. I hope you get some fantastic dried hydrangea decorating ideas from this post!