Lilac plants don’t require a lot of food or fertilizer. A 10-10-10 fertilizer mixture applied yearly in the early spring is what we advise. (The amounts of nitrogen, phosphorus, and potassium, or NPK as they are popularly known, are represented by the digits 10-10-10 in the formula.) Early spring fertilization of lilacs with a high phosphorus solution encourages blossoming.
Coffee grounds and grass clippings are also excellent sources of nitrogen. Use in moderation since an excess of nitrogen in the soil can lead to subpar blooms. The ideal soil conditions for lilacs are slightly alkaline (6.5–7.0 pH), wet, and well-drained. The soil may become more alkaline by adding bone meal to it. Use Miracle-Gro Shake ‘n Feed Flowering Trees & Shrubs Plant Food in the spring if you decide to feed your plant. Last but not least, lilac plants dislike acidic soil. Epsom salts can be used to encourage blossoming while the plant is dormant.
Can you grow lilacs with Miracle Grow?
3. Take the plant out of its pot and place it in the hole. Make sure the top of the root ball is about an inch or more above the soil surface.
4. Apply the soil mixture all the way around the root ball, pressing it down firmly.
5. Take a long drink.
6. Mulch the area you just planted to a depth of 2 inches, being careful not to pile mulch up against the base of the plant. This will help keep the soil moist and prevent weeds from sprouting by denying them access to sunlight.
How to Water Lilacs
After planting, monitor your plants frequently, and water them once or twice a week, or anytime the top inch of soil becomes dry. While watering, count to 10 to make sure you’re providing each lilac plant with enough moisture. (If the plant becomes too dry, the leaves will start to droop.) You can reduce watering to every other week once plants have been planted and have had a few months to establish themselves. Lilacs won’t require additional water during the second growing season or later unless there hasn’t been rain in your location for a month or more.
How to Feed Lilacs
Lilacs should be fed Miracle-Gro Shake ‘n Feed Flowering Trees & Shrubs Plant Food after they have bloomed in the spring to encourage the development of robust roots. This plant food is jam-packed with nutrients for your plants, including kelp, earthworm castings, feather meal, and bone meal. These ingredients nourish soil bacteria, which in turn break down organic matter into nutrients for your plants.
How to Help Prevent Disease Problems with Lilacs
Powdery mildew is the main problem with lilacs, especially common lilacs. What’s the best approach to prevent this? Purchase and plant lilac cultivars that resist powdery mildew (check the plant tag or online description). Lilacs benefit from being planted in areas with good airflow. This fungus disease won’t respond to spraying, and it will finally go away on its own.
How to Deadhead Lilacs
Be sure to deadhead young lilacs as they start to bloom (this could take a few years!). Deadheading involves clipping off faded flowers at the base as soon as they start to droop and fade. In response, the plant will use more energy developing new flower buds for the upcoming spring.
How to Prune Lilacs
Although the newer, smaller lilac kinds require less trimming than the enormous conventional lilacs, all lilacs will grow more effectively and bear more flowers with regular pruning. Here are a few possibilities:
- Cut an older lilac shrub to 8 inches above the ground in late winter (March or April), then let it grow out if it isn’t flowering despite receiving plenty of sunlight. The following March, choose 8 to 10 of the best-looking stems, and reduce them by half. Trim the remainder to the ground. The following year, new blossoms should appear.
- Selectively prune 1/3 of the branches all the way back to the ground each year to revive shrubs that aren’t flowering well instead of chopping the shrub all the way down.
- Cut back branches to reduce size as soon as the shrub’s flowering has finished.
Are lilacs suited for coffee grounds?
Use only a small amount of coffee grounds and grass clippings in your compost; they are good sources of nitrogen. The soil receives potassium from banana peels.
A lilac bush needs fertilizer, right?
Lilac bushes respond well to fertilizer made from bone meal. This is as a result of increased soil alkalinity. It is a simple natural plant food that the lilac may consume.
Lilac fertilization isn’t necessarily required until the first and second years after planting. To sweeten the soil and prevent too much acidity, they could be fertilized with superphosphate and limestone when they are planted.
You can exclude standard fertilizer mixtures if the soil has the right balance and has a lot of organic matter. The only bushes that will truly benefit from annual feeding are those planted in poor soil. When you do feed the plants, use a 5-10-10 ratio. Around the plant’s root zone, distribute 1 cup (237 ml) of granular food evenly, and then water the soil.
How is a lilac bush regenerated?
The common purple lilac is a hardy, dependable shrub that can grow up to 20 feet tall. Unfortunately, the lower, shady sections of lilac shrubs typically lose their leaves as they get older. Large, overgrown specimens as a result are frequently leggy and ugly. Pruning can restore or rejuvenate old, neglected lilacs. Home gardeners have two alternative pruning techniques to pick from.
Cutting the entire plant back to within 6 to 8 inches of the ground in late winter is one method of renewing a huge, overgrown lilac (March or early April). A significant number of shoots will sprout during the growth season as a result of this aggressive pruning. Select a few sturdy, robust shoots to construct the shrub’s framework, keeping a few of them, and cut off all the others at ground level in the late winter of the next year. To promote branching, head (clip) back the retained shoots to just above a bud.
Cutting back the overgrown shrubs over a three-year period is a second method for pruning mature lilacs. In late January, start the process by digging up and removing one-third of the big, old stems. The following year, trim out half of the remaining old stems (again in late winter). Additionally, trim out some of the recent growth. Keep a few healthy stems that are evenly spaced apart and cut off the rest. In the third year’s late winter, completely remove all of the old wood. It is also necessary to thin the fresh shoots more. This pruning technique should enable you to take pleasure in blossoms every spring because lilac wood must be three years or older before it blooms.
Within a few years, with the right pruning, an old, overgrown lilac can be converted into a robust, appealing shrub. Pruning should be a frequent component of the lilacs’ management regimen after they have been revived. By cutting a few of the oldest branches every three to five years, the shrub can be kept strong and healthy.
(This article, which first published in the Sunday edition of the Lincoln Journal Star Newspaper in February 2005, has since been amended. Consult the Terms of Use for details on how to copy this content and use any images or visuals.)
How are lilac Fullers made?
Cutting off the tops of stems that have grown out of control is frequently insufficient when pruning lilacs. It is typically preferable to remove the entire stem. The best way to trim lilacs is with clippers. To avoid spreading and promote later blooms, remove spent blossoms right down to the stems. Three-quarters of the branches should be pruned. Remove any shoots that are emerging from the main trunk and are growing close to the ground. Lilacs within the inner branches may need to be trimmed in order to increase air flow or let more light through.
However, it may be essential to prune the entire bush or tree to approximately 6 or 8 inches (15-20 cm) above the ground if lilac shrubs are already too big or starting to look unpleasant. Remember that it takes around three years for flowers to grow after the entire bush has been removed, so you might have to wait.
How are lilacs kept in good health?
An old, overgrown lilac was one of the few plants that endured my garden restoration. The fact that it obscured my neighbor’s garage and, more importantly, sported steel-blue double flowers, led me to rescue it. Although the blossoms on this shrub were both lovely and fragrant, it was difficult to appreciate them because there were so few of them. I decided to go with a rejuvenation pruning because I knew there was no reason to give up on this long-neglected plant because lilacs can handle severe pruning.
On stems that are no older than five or six years, the common French lilacs (Syringa vulgaris cvs.) yield the most and the largest flowers. The flowers get fewer, smaller, and farther away as the stems get older. A lilac, however, may reliably produce blossoms for decades with the right trimming. The method you choose will depend on how old your shrub is. Plants are maintained annually to keep them healthy. A more drastic trimming may be necessary for lilacs like mine that have seen better days.
Lilacs should be clipped annually to encourage healthy stem development and strong growth that improves flowering. Cutting sick, deformed, and unproductive stems to the ground constitutes annual pruning. I thin and cut back some stems as well to promote healthy, evenly spaced growth. To prevent them from growing too far away from the center of the plant, I also pruned a few of the new shoots that emerged from the roots. I left a few inches between each stem to prevent crowding. Since they produce the most, I maintain the pencil-thick shoots that extend all the way to the ends of the branches. Small, twitchy growth is unproductive and won’t blossom. This growth can indicate an excess of aged, unproductive stems or too much shadow. Remove stems as soon as possible after blossoming, or in late winter if you don’t mind losing a few blooms. Cut off stems and shoots at or just below the soil line.
Dwarf lilacs rarely need pruning
Both the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”) are twiggy-habiting, somewhat small lilacs. On these types, just deadheading is needed in terms of pruning. You can prune some of the older stems as the plants get older to make place for younger, more robust stems. In contrast to regular lilacs, these plants hardly ever spread out of control. They might never need to be entirely regenerated if you only undertake a tiny amount of trimming every few years.
After the blooms have faded, deadheading, another aspect of annual maintenance, should be carried out as soon as feasible. Just above the two new shoots that slant out from the stem that stopped with the old bloom, the base of the old flower cluster should be cut off. The new shoots will develop throughout the course of the summer, produce flower buds, and culminate in a cluster of flowers the following spring. While not as crucial as the annual thinning, eliminating the old blossoms enables the plant to focus more of its energy on developing robust branches and flower buds. In June, I deadhead and thin my plants as needed.
While performing this yearly maintenance, I occasionally come upon a young, robust shoot that may be getting too tall but is still a good, productive stem and is a candidate for tipping off. I cut the wasted flower’s entire top stem back to one or two side shoots at the desired height rather of just cutting it off at the base. The side shoots that are now near the top of the bush are encouraged to grow vigorously and develop flower buds for the following year by this cut, which also aids in shrinking the shrub.
My own old, overgrown lilacs need more severe pruning. I went outside in the early spring before growth got going to get a good look at the bush. I looked to see if the plant had been grafted before I began chopping. I immediately cut it down to the ground as it hadn’t (for a grafted plant, see the panel below). I recognized that this drastic trimming would result in the plant losing part of its aesthetic appeal for a few years because lilacs bloom on the growth from the previous season. However, I was also aware that the reward—more blossoms and a stronger plant—would be worthwhile.
It’s crucial to nourish the plant after rejuvenation pruning with compost, composted manure, or a balanced chemical fertilizer and to make sure the soil pH is close to neutral, which lilacs appreciate. In the upcoming years, these supplements and some high-quality mulch will help to encourage vigorous new growth and enhanced flowering.
Has your lilac been grafted?
If your lilac has been grafted, check it out before you start making cuts to the stems. Grafting is a method of plant multiplication in which the scion, or branch, of one species is joined to the rootstock, or stem, of another species. This is typically done to enhance a plant’s look or traits. A graft union, where the cultivar’s scion wood joins the rootstock several inches above ground level, should be obvious. An apparent change in the bark from the rootstock to the scion’s bark, as well as a little swelling at the graft union, are things to watch for. If your plant has been grafted, all of your cuttings must be made above the graft union, and you must prevent shoots from the rootstock from developing into new flowering stems. Flowers of the desired shape or color will not be produced by shoots that emerge from the rootstock.
Does a lilac shrub love acid?
Lilacs prefer soil with a pH between 6.5 and 7.0, which ranges from slightly acidic to slightly alkaline. If the pH is either too high or too low, the bushes may suffer because the nutrients they require from the soil may not be easily available.
A lilac bush can you overwater it?
A traditional flower garden, outdoor space, or decorative pot should all contain lilac plants as they are a staple flowering shrub. Zones 3 through 8 are suitable for growing these fragrant shrubs, and they require very little maintenance. Lilacs need at least 6 hours per day of direct sunlight to produce their best flowers. Lilacs benefit from regular watering after initial planting, throughout active growth seasons (spring), and during prolonged dry spells. Lilacs are fairly drought tolerant once they are established.
It is advised to water your lilac plant once every 10 to 14 days from spring till blooming is finished. The ideal irrigation for lilacs is deep, infrequent watering. Make sure the planting space or container has good drainage. These plants don’t appreciate having their feet wet and won’t bloom if they are overwatered. By saturating air pockets with water and reducing soil oxygen levels, excessive water can strangle the lilac tree’s roots. The first indication that the lilac is overwatered is the plant wiggling.