Cutting off the tops of stems that have grown out of control is frequently insufficient when pruning lilacs. It is typically preferable to remove the entire stem. The best way to trim lilacs is with clippers. To avoid spreading and promote later blooms, remove spent blossoms right down to the stems. Three-quarters of the branches should be pruned. Remove any shoots that are emerging from the main trunk and are growing close to the ground. Lilacs within the inner branches may need to be trimmed in order to increase air flow or let more light through.
However, it may be essential to prune the entire bush or tree to approximately 6 or 8 inches (15-20 cm) above the ground if lilac shrubs are already too big or starting to look unpleasant. Remember that it takes around three years for flowers to grow after the entire bush has been removed, so you might have to wait.
When should lilacs that are overgrown be pruned?
Then climb your ladder and trim down all of the branches and the spent lilac flowering heads by a few feet. This will make the bush more even. Remove any unhealthy portions as well by pruning.
After blooming the following year, trim a further third of the oldest branches. And trim back the final group of eldest branches in year three. Your plant will be rejuvenated by the three years of trimming out the old wood. Ideally, you’ll have fresh, bushy growth closer to the ground as well as blossoms that you can cut or smell without using a ladder.
Rhododendrons should have their wasted flowers removed every year once they have faded. Just the flower heads, and not the leaf stalks, should be snapped off. You can revive elderly shrubs that have become spindly by giving them a lot of trimming. In order to avoid interfering with the development of flower buds for the next year, the best time to prune these plants is right after flowering (late spring).
Do lilacs require pruning?
An old, overgrown lilac was one of the few plants that endured my garden restoration. The fact that it obscured my neighbor’s garage and, more importantly, sported steel-blue double flowers, led me to rescue it. Although the blossoms on this shrub were both lovely and fragrant, it was difficult to appreciate them because there were so few of them. I decided to go with a rejuvenation pruning because I knew there was no reason to give up on this long-neglected plant because lilacs can handle severe pruning.
On stems that are no older than five or six years, the common French lilacs (Syringa vulgaris cvs.) yield the most and the largest flowers. The flowers get fewer, smaller, and farther away as the stems get older. A lilac, however, may reliably produce blossoms for decades with the right trimming. The method you choose will depend on how old your shrub is. Plants are maintained annually to keep them healthy. A more drastic trimming may be necessary for lilacs like mine that have seen better days.
Lilacs should be clipped annually to encourage healthy stem development and strong growth that improves flowering. Cutting sick, deformed, and unproductive stems to the ground constitutes annual pruning. I thin and cut back some stems as well to promote healthy, evenly spaced growth. To prevent them from growing too far away from the center of the plant, I also pruned a few of the new shoots that emerged from the roots. I left a few inches between each stem to prevent crowding. Since they produce the most, I maintain the pencil-thick shoots that extend all the way to the ends of the branches. Small, twitchy growth is unproductive and won’t blossom. This growth can indicate an excess of aged, unproductive stems or too much shadow. Remove stems as soon as possible after blossoming, or in late winter if you don’t mind losing a few blooms. Cut off stems and shoots at or just below the soil line.
Dwarf lilacs rarely need pruning
Both the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”) are twiggy-habiting, somewhat small lilacs. On these types, just deadheading is needed in terms of pruning. You can prune some of the older stems as the plants get older to make place for younger, more robust stems. In contrast to regular lilacs, these plants hardly ever spread out of control. They might never need to be entirely regenerated if you only undertake a tiny amount of trimming every few years.
After the blooms have faded, deadheading, another aspect of annual maintenance, should be carried out as soon as feasible. Just above the two new shoots that slant out from the stem that stopped with the old bloom, the base of the old flower cluster should be cut off. The new shoots will develop throughout the course of the summer, produce flower buds, and culminate in a cluster of flowers the following spring. While not as crucial as the annual thinning, eliminating the old blossoms enables the plant to focus more of its energy on developing robust branches and flower buds. In June, I deadhead and thin my plants as needed.
While performing this yearly maintenance, I occasionally come upon a young, robust shoot that may be getting too tall but is still a good, productive stem and is a candidate for tipping off. I cut the wasted flower’s entire top stem back to one or two side shoots at the desired height rather of just cutting it off at the base. The side shoots that are now near the top of the bush are encouraged to grow vigorously and develop flower buds for the following year by this cut, which also aids in shrinking the shrub.
My own old, overgrown lilacs need more severe pruning. I went outside in the early spring before growth got going to get a good look at the bush. I looked to see if the plant had been grafted before I began chopping. I immediately cut it down to the ground as it hadn’t (for a grafted plant, see the panel below). I recognized that this drastic trimming would result in the plant losing part of its aesthetic appeal for a few years because lilacs bloom on the growth from the previous season. However, I was also aware that the reward—more blossoms and a stronger plant—would be worthwhile.
It’s crucial to nourish the plant after rejuvenation pruning with compost, composted manure, or a balanced chemical fertilizer and to make sure the soil pH is close to neutral, which lilacs appreciate. In the upcoming years, these supplements and some high-quality mulch will help to encourage vigorous new growth and enhanced flowering.
Has your lilac been grafted?
If your lilac has been grafted, check it out before you start making cuts to the stems. Grafting is a method of plant multiplication in which the scion, or branch, of one species is joined to the rootstock, or stem, of another species. This is typically done to enhance a plant’s look or traits. A graft union, where the cultivar’s scion wood joins the rootstock several inches above ground level, should be obvious. An apparent change in the bark from the rootstock to the scion’s bark, as well as a little swelling at the graft union, are things to watch for. If your plant has been grafted, all of your cuttings must be made above the graft union, and you must prevent shoots from the rootstock from developing into new flowering stems. Flowers of the desired shape or color will not be produced by shoots that emerge from the rootstock.
How much may a lilac bush be pruned?
Never remove more than one-third of a shrub’s stems in a single pruning season for lilacs. I just cut the branches of the lilac tree down to a manageable height when they started to stray too close to the eaves. After trimming the dead blossoms, I decided to call it a day. A little minor thinning might also be done to promote new growth.
In late winter or early spring, a more vigorous pruning should be performed, perhaps on older shrubs that haven’t been routinely tended to. At this time, you should remove any old wood and damaged stems while keeping the more recent growth. Reduce the aging stems to the ground.
I’ll simply cut any very long sections off the Bloomerang lilac to keep the shrub’s form. Because bloomerangs naturally have a spherical habit, you don’t need to bother about sculpting the bush too much. My plant has been in the garden for a while and is still adorable and manageable.
Can you trim back lilacs to the ground?
The lilac tree will resemble nothing more than a twig in the garden by the end of September. It shouldn’t be reduced to the ground, though. Despite the fact that lilac trees are known for their resilience, it will likely take several years before you see blossoms again because you cut off all the blossoming growth.
If your lilac tree is more mature and unruly, it may require more aggressive pruning and some chopping back; just make sure that it doesn’t take up more than a third of the tree.
Should lilacs be deadheaded?
The removal of spent flowers to encourage new blooming—deadheading—is a crucial part of lilac maintenance. Lilacs should be deadheaded as soon as the flowering is finished to allow the plants to grow robust, healthy buds that will flower vivaciously the following year. According to the University of Minnesota Extension, you can use a hand pruner, but larger plants could require a hedge trimmer. Only the dead blossom should be removed; the plant should still have two leaves.
According to the Chicago Botanic Garden, you should prune lilacs at the same time as you deadhead them since they set the blossoms for the following year quickly after flowering. By doing this, you can prevent damaging or removing the developing buds. Three to four years after planting, you should start pruning lilacs. It might be necessary to trim back overgrown lilacs to just a few inches above the ground. Winter is the ideal time to complete this. In this instance, it will take the shrub one or two growing seasons to start blooming once more.
Does new or old wood produce lilac blooms?
What specifically prevents these traditional plants from blooming? Instead of focusing on just one theory, consider a number of potential causes for this issue, including (in addition to illnesses and pests):
- Pruning when it’s not necessary
- The flower buds die in the cold
- placing your lilacs in the incorrect location
- The shrub in question either isn’t old enough to generate flower buds or is too old to do so.
You’ll see that while reasons one and three point to the gardener having done something incorrect, arguments two and four point to no one having done anything incorrect.
Why does it matter what time of day you prune? Shrubs called lilacs produce flowers on rotting wood. This indicates that the flower buds for the upcoming spring’s blooming season have already been formed on the growth from the previous year. When this growth is pruned, the flower buds and, consequently, the blooms they would have produced, are lost. Because of this, it is recommended that you clip lilac bushes as soon as they finish flowering (before they have set bud for next year).
Click Play to Learn How to Prune Lilacs
Despite being a relatively cold-hardy plant, the common lilac (Syringa vulgaris) can suffer harm if a hard frost or freeze occurs just as the flower buds are about to open. As a result, that year’s flowers are lost. You can’t really stop it, so simply accept the loss and look forward to the blossoming twice as much the next year.
Where you put your lilac shrub matters a lot, just like it does with most other plants. Lilacs require full sunlight and prefer well-drained soil. If you made a mistake when you first put your plants on either of these fronts, you can be paying for it today by your lilac not blooming. However, there is a simple solution to the issue: move your shrub to a more favorable location.
Regarding the fourth reason, be aware that although though these bushes have a long lifespan, they do tend to produce fewer flowers as time passes. Implementing a rejuvenation pruning on your lilacs will solve this issue (do not expect immediate results, though). Sometimes, though, the converse is true: your plant may be too young to bloom. Allow some time.
How can an aged lilac bush be revived?
The common purple lilac is a hardy, dependable shrub that can grow up to 20 feet tall. Unfortunately, the lower, shady sections of lilac shrubs typically lose their leaves as they get older. Large, overgrown specimens as a result are frequently leggy and ugly. Pruning can restore or rejuvenate old, neglected lilacs. Home gardeners have two alternative pruning techniques to pick from.
Cutting the entire plant back to within 6 to 8 inches of the ground in late winter is one method of renewing a huge, overgrown lilac (March or early April). A significant number of shoots will sprout during the growth season as a result of this aggressive pruning. Select a few sturdy, robust shoots to construct the shrub’s framework, keeping a few of them, and cut off all the others at ground level in the late winter of the next year. To promote branching, head (clip) back the retained shoots to just above a bud.
Cutting back the overgrown shrubs over a three-year period is a second method for pruning mature lilacs. In late January, start the process by digging up and removing one-third of the big, old stems. The following year, trim out half of the remaining old stems (again in late winter). Additionally, trim out some of the recent growth. Keep a few healthy stems that are evenly spaced apart and cut off the rest. In the third year’s late winter, completely remove all of the old wood. It is also necessary to thin the fresh shoots more. This pruning technique should enable you to take pleasure in blossoms every spring because lilac wood must be three years or older before it blooms.
Within a few years, with the right pruning, an old, overgrown lilac can be converted into a robust, appealing shrub. Pruning should be a frequent component of the lilacs’ management regimen after they have been revived. By cutting a few of the oldest branches every three to five years, the shrub can be kept strong and healthy.
(This article, which first published in the Sunday edition of the Lincoln Journal Star Newspaper in February 2005, has since been amended. Consult the Terms of Use for details on how to copy this content and use any images or visuals.)