Although it may seem contradictory to use water to dry flowers, hydrangeas benefit from a gentle desiccation process that keeps their color and shape (even the stems end up sturdier when dried this way).
Using a pair of pruning shears, cut each blossom on the angled side, leaving a stem length of between 12 and 18 inches. Take off every leaf from the stalk.
Place the Cut Flowers in Water
After that, arrange your freshly cut flowers in a vase, fill it about halfway with water, and set it aside in a cool location away from the sun. Keep in mind that hydrangea dry best when given room to “breathe,” so take care not to overcrowd your vase with stems.
Allow the vase’s water to totally dry out. After this procedure, which typically lasts two to three weeks, your hydrangeas should feel dry to the touch and the stems should simply snap off. They are now prepared for use.
Use Your Dried Hydrangeas
Your dried hydrangeas can be displayed in a variety of artistic ways. Although they look lovely on their own in a vase, you can also incorporate them into seasonal wreaths or use them in window boxes with other dried flowers. Getting hitched in the autumn? Even your bridal floral arrangements can incorporate them.
When should hydrangeas be picked for drying?
Hydrangeas dry best when left on the bush after their prime and are trimmed when they start to naturally dry out at the end of the season. According to Marzec, if you remove your stems too soon, they may shrivel up. He advises waiting until late summer or even early October for late-blooming kinds. Pay particular attention to the petals, which will start to fold under as the colors fade, and the leaves, which start to feel papery and less fresh, she advises. According to Chris Link, co-owner of Nebraska-based online nursery Plant Addicts, the color of the bloom is another important consideration. Most hydrangea blooms begin as one hue, such as green or white, and change to another, such as pink or red, according to him. Simply clip the blossom when it is the desired shade of color, but before it becomes brown.
Cut flowers with stems that are between 12 and 18 inches in length for the greatest displays, and make sure to remove any leaves before drying. Link advises against trimming stems too short on some hydrangeas that bloom on old wood because doing so could affect the flowers of the following year. This would only be concerning if you removed the blooms extremely late in the year because the flowers would probably already be brown by then.
How long does it take for hydrangeas to dry out?
Timing. Yes, the timing of when you cut your hydrangea blooms is the trick. Sounds simple enough, no? It is simple, but it could require some testing, and exploration is enjoyable. Now that you are aware of the technique for perfectly dried hydrangeas, let’s go back and go over the drying procedures.
I can still clearly recall the first time I saw a dried hydrangea bouquet. The bouquet was on my mother’s dining room table when I thought how lovely it was. It was my intention to duplicate that wonderful bouquet. I have been drying hydrangeas from my garden for the past two years. There was a lot of experimentation, with both success and failure.
Timing
The internet offers a wealth of knowledge when it comes to drying hydrangeas. The timing, though, is crucial. Wait until the hydrangea blossoms are barely past their prime or when a change occurs, and exercise patience. Depending on the type of hydrangea you are cultivating, this timing will vary. Try something new. Keep a watchful eye on your plants. Cut a stem when the blossoms first begin to feel and look papery. Cut another stem a week later. Repeat this for a total of four weeks. If your hydrangea plant is heavily flowered, cut many stems at once.
Cutting
Prior you going outside to trim your hydrangea, fill a bucket or pitcher with water. Locate branches from which you may cut a stem that is 12 to 18 inches long. It is preferable to have a stem that is long and flexible than one that is excessively short. After the stem has been cut, remove all the leaves and put the stem in the bucket of water.
‘Little Lime’ Panicle Hydrangea is the main variety of hydrangea I use for drying. It is a little variety of the well-liked Limelight Hydrangea. In the late summer and early October, the lovely green summer blossoms change to pink. I clipped the flowers for my first trial when they were a wonderful shade of green. Sadly, this was ineffective, and the flowers simply drooped. The flowers weren’t dry enough yet because they still had too much moisture. I also failed to notice a crucial cue from the plant. The Little Lime Hydrangea changes from lime to pink in hue. The secret was to wait for this transition to finish before making an attempt to dry.
Drying
There are various ways to dry hydrangeas. I like the water approach since it is simple, the flowers may be displayed while drying, and the blossoms retain their color for a longer amount of time. First, add 2-3 inches of water to a container. The chopped stems should then be submerged in water. Ensure that there is room between each stem and that the blooms are not touching if you are drying many stems. This will facilitate drying by allowing air to flow freely around the flowers. For two to three weeks, put your container somewhere away from drafts and direct sunlight.
You’ll observe that the stems quickly absorb the water in your container. Most of the time, the water is absorbed within two to four days. With this technique, the blossoms are gently dried without being startled. Immediately after the initial water has been absorbed, resist the urge to add more water. If the blooms don’t appear as they should, timing was just off. Try once more.
You could observe some shedding of the blossoms as they dry. This can be a sign that the bloom was prematurely cut.
Examining
Examine your blossoms two weeks after planting. Have the petals of the flowers shrunk or have they remained intact? It was a little too early to clip the stem if some remained whole while others shriveled. Try once more. You can discover the ideal moment to trim your hydrangea stems through trial, and you can also discover the trick to perfectly dried hydrangeas.
Three hydrangeas that were plucked simultaneously are seen in the image below. The lime-colored hydrangea is a Little Limelight, while the blue hydrangea is a Mophead Hydrangea (Hydrangea macrophylla) (Hydrangea paniculata). Right and left hydrangeas dried out beautifully. The blue Mophead hydrangea in the middle didn’t, though. The flowers all collapsed. This reveals that the bloom was not yet prepared to start drying.
Displaying
Here are two bouquets I made using the technique for perfectly dried hydrangeas.
I adore fresh hydrangeas in addition to utilizing dried hydrangeas. You might be interested in reading my post on how to make a simple hydrangea centerpiece for Saint Patrick’s Day.
How are cut hydrangeas preserved?
Bring a pail of fresh water with you when you go into the garden to trim the hydrangea blooms. Place the flowers in the water as soon as they are cut. Older flowers are better for cut hydrangea blossoms since younger flowers may be harder to keep moist. The flowers should spend several hours resting in water in a cool location before arranging.
Additional post-harvest practices are often used by florists and gardeners to lessen the possibility of wilt. The practice of dipping the stem of the hydrangea in boiling water or putting the stem of the hydrangea in alum are two ways to keep hydrangeas fresh.
One of the most common ways to stop wilt is to soak cut hydrangeas in alum. The spice or baking section of most supermarkets will have alum. Simply dunk a tiny portion of the hydrangea stem in the alum powder after cutting it, then place the bloom in a vase. It is anticipated that this procedure will facilitate the intake of water by the blooms.
Many advise putting the hydrangea stem in hot water after cutting if using alum is not a possibility. Spend around 30 seconds submerging the stem’s bottom inch (2.5 cm) in water. The flower should then be taken out and put in a vase with fresh water. Since hydrangeas are poisonous, never perform this method in kitchen containers.
Many hydrangea blooms can be resurrected with a thorough soak if they continue to wilt. To do this, put the flower heads inside a clean bucket that has been filled with water. After letting the flowers soak for a few hours, take them and put them in a vase. The increased water should completely revive the hydrangea blossoms’ freshness.
How may hydrangeas be dried while keeping their color?
You may appreciate the blossoms’ timeless beauty all year long by drying them. Vase drying and silica drying are the two basic techniques for hydrangea flower drying. Silica drying results in more bright color, whereas vase drying is simpler and less expensive. Use the vase-drying technique, which results in blossoms with vintage colours, to keep things straightforward.
Timing is Everything
The key to success is knowing when to cut hydrangea blossoms for drying. Even though you might be tempted to cut blossoms off the plant as they reach their height of color, it’s crucial to let flowers start drying on the plant. The petals of the flowers will start to feel papery and change colors after they have graced your garden for a few weeks. Depending on the environment and soil pH, oakleaf hydrangeas like TaraTM take on traces of coral or rose, and big-leaf hydrangeas like Dear DoloresTM pick up hints of purple, burgundy, or turquoise. It’s time to grab the pruners when you see colors changing and petals becoming less flexible.
Making the Cut
After the dew on the petals has dried in the morning, trim the stems. Cut stems at an angle with sharp shears or pruners, leaving 12 to 18 inches of stem. Cut the leaves off the cuttings, then put them in a bucket of water. Picky because cuttingdrying brings out flaws in the blooms. Select the nicest flowers to dry and leave the others for the garden to enjoy.
Arrange in Vases of Water
What, we dry flowers with water? Even though it might seem counterproductive, drying hydrangeas in water-filled containers helps keep their color. Put cuttings in vases or other transparent containers and add water until the stem is immersed by a few inches. Don’t pack the vases too tightly. Each bloom needs space to keep an open form and adequate airflow to dry. To give each flower enough room, try staggering the stem lengths.
Allow to Dry
Put containers in different rooms of your house so you may enjoy them while they dry. Keep the flowers away from direct sunshine, though. As the flowers dry, let the water naturally evaporate from the containers. Drying time for blooms can be two weeks or longer. If the water in the vase has evaporated but the flowers have not yet dried, you can add extra water.
When the stem snaps easily and the petals feel stiff, the dried flowers are ready to be used. Simple vases filled with dried hydrangeas, wreaths made of dried hydrangeas, and window boxes decorated with dried hydrangeas all look charming. They are ideal for our flexible Golden Rings tabletop setup as well.
Step 1: Remove leaves and place in container.
The bloom should be clipped so that it will fit in the container after being cleared of any extra leaves. Place the flower on top of a thin layer of silica sand in the microwave-safe container.
Step 2: Cover flower with silica sand.
Silica sand should completely encircle the blossom. If the flowers are little, you can group them together in one container as long as the sand completely covers them.
Step 3: Microwave in thirty second intervals.
Put the container and a cup of water in the microwave. In the microwave, heat for 30 second intervals. Observe the blossom till it appears dried. This ought to take two to three minutes, depending on the flower’s density.
Step 4: Check flower and then leave in sand for 24 hours.
Rebury the flower and wait for 24 hours after the petals start to look dry. The flower will be fully dried as a result.
Step 5: Remove from sand and display!
Brush off any additional grains that are adhered to the flower’s petals after removing it from the silica sand. To maintain clean, mist with unscented hairspray. Use your dried flowers to make a craft or display them in your home. Keep out of direct sunshine, similar to air drying, to stop the colors from fading.
The length of time required to microwave-dry flowers varies according on the density of the blossoms. Follow the chart as a guide for these common flowers:
- infant breath
- buttercup
- fern
- feverfew
- heather
- pansy
- aster
- azalea
- student button
- calendula
- daisy
- delphinium
- foxglove
- larkspur
- carnations
- chrysanthemum
- gardenia
- hyacinth
- hydrangea
- marigold
- orchid
- peony
- rose
- snapdragon
- stock
Do I need to chop the dried hydrangea flowers?
Myers advises leaving the dried blossoms on your hydrangeas if you’re looking for an easy way to spice up your winter yard. Bigleaf hydrangeas produce their final rush of flowers in the fall, so to enjoy the dried blossoms all winter long, stop deadheading at that time. To aid in the production of healthy buds in the spring, these can be removed.
How do you use hairspray to dry hydrangeas?
A fantastic technique to keep fresh flowers on display in a home is to dry hydrangeas. Drying flowers—specifically, hydrangeas—is done to eliminate all moisture from the flower petals and stem in order to preserve the bloom for an extended period of time. This can be accomplished by hanging the flowers upside down, putting hairspray on them, or letting the flowers dry naturally. Hydrangeas benefit from drying since it keeps their original color while also protecting the flower petals.
Water drying is a straightforward technique for hydrangea drying. The flowers must be in a vase that is half filled with water in order to use the water approach. Place the vase away from direct sunlight and in a cool place. Till the water starts to evaporate, let the vase stand without touching the flowers. The hydrangeas will have dried naturally when the water level drops.
Spraying the flower petals with hairspray is another simple technique for drying hydrangeas that makes use of a product that many people already have at home. Spray hairspray all over the hydrangeas using either an aerosol can or a pump. Tie the flower stems together to form a bouquet, then place the bouquet in a dry place, like a closet, to dry and become crisp to the touch.