Lilacs are a nostalgic flower for many individuals. On our property in Kansas, my mother planted a lot of lilac bushes. As I played, the aroma spread across the yard. In order for our children to share the same exquisite recollection of the aroma and flower, my husband and I made it a priority to plant a lilac in our garden when we first started our family.
I’ve tried, and have failed, through the years to bring this flower’s bounty into my house. Even though I had the flowers in a spotless vase filled with new water, they would begin to wilt an hour after I brought them inside. I have figured out how to make the blooms last as long as possible by trial and error:
As you trim blooms, have a pail half-full of fresh, chilled water nearby. Choose a chilly morning or evening to pick flowers. Lilacs bloom very sporadically after being harvested, so look for stems with at least 75 percent of their flowers open. Next, remove all of the leaves to prevent the plant from exerting extra energy to keep them moist. Put stems in the liquid. Allow the flowers to absorb water in the bucket for at least an hour by placing it in a cool, dark location.
Recut the stem ends next with powerful clippers, then make 1-2 inch vertical slices up the stem. Take hold of the sliced stem’s one side and twist it backward. Reintroduce the chopped stems to the water in the bucket right away. For an additional hour or two, let the stems soak up extra water in a cool, dark location. After that, the lilacs will survive three to four days and be ready for arranging.
Is cutting lilac flowers acceptable?
When I went to get the hose a few years back, I saw that my lilac bush had a ton of branches ripped off of it. I accused my poor hubby of using the pruners too aggressively. I quickly learned, though, that the mother squirrel who was painstakingly constructing her nest was responsible for the hack job. She would run to my chimney after tearing off one or two branches (but that’s another story entirely). The lilac has been thriving, which is comforting to me as I was concerned it wouldn’t return the next spring. One of my favorite springtime scents is lilac. When they are in bloom and swaying in the breeze as I work outside on my deck, I inhale deeply. Lilacs should be pruned once their fragrant blossoms have faded. I so decided to provide some advice!
Once the blooms have opened and faded, a lilac bush is ready for pruning. Shrubs that bloom in the spring should be clipped as soon as they finish blooming. Because flower buds for the following year develop on this year’s wood, delaying the task until later in the season runs the danger of removing next year’s blooms, as I did with an untamed forsythia in the past.
When and how should lilacs be pruned?
All lilacs should generally be clipped right away in the spring after they have finished blooming. Since lilacs set next year’s flower buds right after the current year’s flowers have faded, pruning later in the summer or fall will result in cutting off many or all of next year’s flowers. While the “when of pruning lilacs is fairly straightforward, the “how gets a little trickier. To keep things simple for now, we’ll think of lilac pruning as either maintenance pruning or rejuvenation pruning. This rule of timing applies to the larger common lilacs as well as the cultivars that are shorter or more “shrub like.
Where should a lilac stem be cut?
Cutting off the tops of stems that have grown out of control is frequently insufficient when pruning lilacs. It is typically preferable to remove the entire stem. The best way to trim lilacs is with clippers. To avoid spreading and promote later blooms, remove spent blossoms right down to the stems. Three-quarters of the branches should be pruned. Remove any shoots that are emerging from the main trunk and are growing close to the ground. Lilacs within the inner branches may need to be trimmed in order to increase air flow or let more light through.
However, it may be essential to prune the entire bush or tree to approximately 6 or 8 inches (15-20 cm) above the ground if lilac shrubs are already too big or starting to look unpleasant. Remember that it takes around three years for flowers to grow after the entire bush has been removed, so you might have to wait.
When do lilacs need to be cut back?
A lilac shrub needs to be pruned every year once it has reached the age of two. Early summer is ideal for cutting grass because the flowers have already flowered and withered. Here are some tips for taking care of lilac shrubs and trees.
Lilacs produce the flower buds for the following season in the early summer, right after their blooms have faded. You run the danger of removing the budding buds if you delay trimming until later in the growing season.
This also holds true for lilacs that bloom twice a year, like Bloomerang Purple. After the bush’s initial bloom, you can prune it to promote new growth and more flowers in the second bloom, which occurs in early fall.
Lilacs eventually only bloom at the tips of their highest branches if allowed to develop naturally. Lilac bushes can be revitalized and made more visually appealing by pruning to maintain a balance between older stems and young blossoming branches.
Pruning a lilac shrub involves a number of techniques:
- First, remove any weaker branches and any dead, broken, or diseased stems. Branches should also be trimmed to avoid rubbing or crossing.
- Old stems that are thicker than two inches should be cut off. This controls the height of your lilac plant and promotes the development of new shoots. It is best to thoroughly remove the stems.
- Control sucker emergence. Suckers are fresh branches that sprout from the plant’s base. The main branches can be replaced by a few robust suckers, but any lesser suckers should be removed at the soil line to prevent them from robbing the plant of nutrients.
Last but not least, here are some general guidelines for pruning lilacs:
- Lilac bushes that are mature should only be pruned to a height of 6 to 8 feet.
- Aim for 10 to 12 primary stems, each of which should be between 1 and 2 inches thick.
- Never remove more than one-third of the bush with pruning.
- Older stems and fresh blossoming shoots should be balanced.
Does the lilac bush suffer when it is cut?
An old, overgrown lilac was one of the few plants that endured my garden restoration. The fact that it obscured my neighbor’s garage and, more importantly, sported steel-blue double flowers, led me to rescue it. Although the blossoms on this shrub were both lovely and fragrant, it was difficult to appreciate them because there were so few of them. I decided to go with a rejuvenation pruning because I knew there was no reason to give up on this long-neglected plant because lilacs can handle severe pruning.
On stems that are no older than five or six years, the common French lilacs (Syringa vulgaris cvs.) yield the most and the largest flowers. The flowers get fewer, smaller, and farther away as the stems get older. A lilac, however, may reliably produce blossoms for decades with the right trimming. The method you choose will depend on how old your shrub is. Plants are maintained annually to keep them healthy. A more drastic trimming may be necessary for lilacs like mine that have seen better days.
Lilacs should be clipped annually to encourage healthy stem development and strong growth that improves flowering. Cutting sick, deformed, and unproductive stems to the ground constitutes annual pruning. I thin and cut back some stems as well to promote healthy, evenly spaced growth. To prevent them from growing too far away from the center of the plant, I also pruned a few of the new shoots that emerged from the roots. I left a few inches between each stem to prevent crowding. Since they produce the most, I maintain the pencil-thick shoots that extend all the way to the ends of the branches. Small, twitchy growth is unproductive and won’t blossom. This growth can indicate an excess of aged, unproductive stems or too much shadow. Remove stems as soon as possible after blossoming, or in late winter if you don’t mind losing a few blooms. Cut off stems and shoots at or just below the soil line.
Dwarf lilacs rarely need pruning
Both the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”) are twiggy-habiting, somewhat small lilacs. On these types, just deadheading is needed in terms of pruning. You can prune some of the older stems as the plants get older to make place for younger, more robust stems. In contrast to regular lilacs, these plants hardly ever spread out of control. They might never need to be entirely regenerated if you only undertake a tiny amount of trimming every few years.
After the blooms have faded, deadheading, another aspect of annual maintenance, should be carried out as soon as feasible. Just above the two new shoots that slant out from the stem that stopped with the old bloom, the base of the old flower cluster should be cut off. The new shoots will develop throughout the course of the summer, produce flower buds, and culminate in a cluster of flowers the following spring. While not as crucial as the annual thinning, eliminating the old blossoms enables the plant to focus more of its energy on developing robust branches and flower buds. In June, I deadhead and thin my plants as needed.
While performing this yearly maintenance, I occasionally come upon a young, robust shoot that may be getting too tall but is still a good, productive stem and is a candidate for tipping off. I cut the wasted flower’s entire top stem back to one or two side shoots at the desired height rather of just cutting it off at the base. The side shoots that are now near the top of the bush are encouraged to grow vigorously and develop flower buds for the following year by this cut, which also aids in shrinking the shrub.
My own old, overgrown lilacs need more severe pruning. I went outside in the early spring before growth got going to get a good look at the bush. I looked to see if the plant had been grafted before I began chopping. I immediately cut it down to the ground as it hadn’t (for a grafted plant, see the panel below). I recognized that this drastic trimming would result in the plant losing part of its aesthetic appeal for a few years because lilacs bloom on the growth from the previous season. However, I was also aware that the reward—more blossoms and a stronger plant—would be worthwhile.
It’s crucial to nourish the plant after rejuvenation pruning with compost, composted manure, or a balanced chemical fertilizer and to make sure the soil pH is close to neutral, which lilacs appreciate. In the upcoming years, these supplements and some high-quality mulch will help to encourage vigorous new growth and enhanced flowering.
Has your lilac been grafted?
If your lilac has been grafted, check it out before you start making cuts to the stems. Grafting is a method of plant multiplication in which the scion, or branch, of one species is joined to the rootstock, or stem, of another species. This is typically done to enhance a plant’s look or traits. A graft union, where the cultivar’s scion wood joins the rootstock several inches above ground level, should be obvious. An apparent change in the bark from the rootstock to the scion’s bark, as well as a little swelling at the graft union, are things to watch for. If your plant has been grafted, all of your cuttings must be made above the graft union, and you must prevent shoots from the rootstock from developing into new flowering stems. Flowers of the desired shape or color will not be produced by shoots that emerge from the rootstock.
Can I prune my lilac shrub all the way back?
Older lilacs only bloom on the tallest branches and can have stems as thick as small trees. Fortunately, rejuvenation pruning can bring back a lilac that has been dead for around three years. There are two options available to you.
Using the “third” method is a less harsh way to pull an out-of-control lilac back into shape. For three years in a row, completely remove a third of the oldest branches from the tree. The thickest stems should be removed first. Pruning overgrown lilacs is simplest in the early spring before the branches start to leaf out, even if you’ll lose some blossoms for the current season. Your overgrown lilac should consist primarily of new shoots after three years of consistent pruning. After the plant starts to bloom all over, you may start doing routine maintenance pruning.
You can take the dramatic action of pruning back the entire plant to 6 to 8 inches above the ground in the early spring if you don’t like the way your old lilac looks or you just want a quicker solution. To encourage new development, fertilize the plant with compost or a balanced fertilizer. Throughout the growing season, new shoots will appear; allow them to continue to develop over the summer. The following spring, start cutting the spindly growth while keeping the healthiest shoots and keeping an eye on the plant’s shape. By pruning the remaining shoots to just above a bud, you can promote branching. After this, continue with routine maintenance pruning.