The majority of lilac shrubs bloom each year, but poor trimming can prevent flowers from appearing the following year. When it comes to properly pruning lilac shrubs, time is crucial because the buds for the bush’s blooms the following year are formed quickly after the bush has completed blooming.
After the new buds have formed, pruning your lilacs may result in few or no blooms the following season. It can take several years before you see any flowers if you prune your lilac bushes too aggressively. The best course of action is to deadhead faded flowers and, if required, prune your lilacs immediately following the blooming period.
Why hasn’t my lilac bush bloomed?
A. There are a number of potential causes for your lilac’s failure to blossom. Lack of sufficient sunlight is the main culprit. Lilacs (Syringa) should be planted in an area with at least six hours of direct, bright sunlight per day. They can withstand a wide range of moisture levels as long as they are grown in soil with good drainage.
If your lilac is clipped at the wrong time of year, it might not blossom for another reason. Lilacs bloom in the spring on the growth from the previous year, and soon after, they begin to form the buds for the following year. Within a few weeks of the plant blooming, pruning must be done simultaneously with the removal of the wasted flowers in order to prevent the removal of the buds for the following year. A late freeze can harm flower buds on types that bloom early.
Lilacs have a tendency to mature into overgrown, leggy shrubs with minimal foliage at the bottom. When this occurs, it might be required to prune them to within 12 inches of the ground in order to completely rejuvenate them. When the shrubs are dormant in late winter, this should be done. Lilacs benefit from this repair, although their blooming cycle will be hampered for at least one season. Lilacs can receive a rejuvenation pruning over a two-year period to stop the interruption of bloom cycles. Half of the shrub’s stems should be hard pruned the first year, and the remaining stems the following year.
Lilacs do not consume a lot of food. Excessive fertilisation, particularly nitrogen fertiliser, can frequently promote luxuriant vegetative growth at the expense of flower development. A lilac’s failure to bloom could potentially be due to its proximity to turf that receives frequent fertilisation.
How can you make lilacs blossom once more?
To ensure that yours grows, follow these suggestions:
- Usually, the issue is a lack of sunlight. Each day, the sun should be exposed for at least six hours.
- Nitrogen in excess might be problematic. Lilacs are frequently cultivated in lawns, and nitrogen-rich fertilisers are utilised to make lawns greener.
- Make sure to prune when the season is perfect.
How frequently do lilac bushes bloom?
The late lilac is the leading contender for a long-lasting lilac that will bloom profusely throughout the warmer months of the year (Syringa villosa). As its name suggests, it blooms later than other types and produces fragrant white, pink, rosy lilac, violet, and even crimson blossoms. This lilac bush only has one summer bloom and enjoys direct sunlight.
Consider a reblooming lilac for your garden if you want consistent flowers. Lilacs that rebloom will first bloom in the spring, then rest until summertime when they will blossom once more. After their spring rest, certain types, such as the Bloomerang dark purple, will continue to bloom until the fall. Look for the Josee reblooming lilac (Syringa Josee), which intermittently flowers throughout the summer and into the fall, if you live in a warmer climate.
Is there a season for lilac blooms?
Compared to other lilac trees, bloomerang lilac trees are more compact, reaching a short height of 4-6 feet tall and a spread of 4-6 feet, giving them a pleasing, rounded appearance. Their long, arched branches bear their veined leaves, which are bright green for the majority of the year until turning yellow in the fall.
The characteristic 4-petaled, 4-6 inch deep lilac-purple blooms on bloomerang lilac trees appear starting in May, cease blooming in June, and then return in July through the first frost of the year.
Specifications
With tall, arched branches, a compact and rounded shape, and rich green foliage that turn golden in the fall. Four spread petals, 4-6 inch, lilac-purple flowers that bloom in the spring and later in the summer.
Which month should lilac bushes be pruned?
All lilacs should generally be clipped right away in the spring after they have finished blooming. Lilacs set their flower buds for the following year immediately after the current year’s flowers have faded, therefore trimming later in the summer or fall will result in the removal of most or all of the blossoms for the following year. The larger common lilacs as well as the shorter or more “shrub like” cultivars are all subject to this timing guideline. While the “when” of lilac trimming is rather simple, the “how” is a little more difficult. For the time being, we’ll refer to lilac pruning as either maintenance pruning or rejuvenation pruning to keep things simple.
Should lilacs be Deadheaded?
Dwarf lilacs that resemble ordinary lilacs include the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”). However, they hardly ever need pruning for maintenance, though you can do it sometimes for shape. They can also profit from deadheading, just like other lilac kinds.
The act of manually removing withered blossoms from a plant is known as deadheading. This encourages some plants to continue blooming. But only during the first several years of growth does deadheading seem to make lilacs bloom more effectively.
Within two to five years, young lilac plants should start blooming. Deadheading the spent blooms when the plants are young encourages the plant to focus its energy on developing new buds. It won’t require this stimulation once the plant has grown older, and you’ll probably have so many flowers that the task would take too long.
Your lilac will blossom beautifully some years, and less so other years, just like with any plant. Blooms frequently rely on the climate. You will be rewarded with an abundance of blossoms the next year if you have a beautiful summer during which strong new growth emerges. Less flowers will bloom in a summer with harsh weather. Therefore, if your lilac’s colour changes from one year to the next, don’t get alarmed. The blossoms will come as long as the plant is strong and you continue with maintenance pruning.
How long does a lilac bush live?
Lilacs are renowned for their longevity and hardiness.
Numerous lilac shrubs reach ages of greater than 100. They frequently outlive the residence of the gardener who planted them due to their extended lifespan. As a result, if you’re driving along a country road and come across a few what appear to be random lilac bushes, it was probably a farm or house a century ago.
Try growing lilacs in your garden if you haven’t already. They not only return every year, but they also put on a display for the senses with vibrant blossoms and enticing scents. Lilacs have a lot to offer, and learning about their history demonstrates just how unique these plants are.
How can an aged lilac bush be revived?
The common purple lilac is a hardy, dependable shrub that can grow up to 20 feet tall. Unfortunately, the lower, shady sections of lilac shrubs typically lose their leaves as they get older. Large, overgrown specimens as a result are frequently leggy and ugly. Pruning can restore or rejuvenate old, neglected lilacs. Home gardeners have two alternative pruning techniques to pick from.
Cutting the entire plant back to within 6 to 8 inches of the ground in late winter is one method of renewing a huge, overgrown lilac (March or early April). A significant number of shoots will sprout during the growth season as a result of this aggressive pruning. Select a few sturdy, robust shoots to construct the shrub’s framework, keeping a few of them, and cut off all the others at ground level in the late winter of the next year. To promote branching, head (clip) back the retained shoots to just above a bud.
Cutting back the overgrown shrubs over a three-year period is a second method for pruning mature lilacs. In late January, start the process by digging up and removing one-third of the big, old stems. The following year, trim out half of the remaining old stems (again in late winter). Additionally, trim out some of the recent growth. Keep a few healthy stems that are evenly spaced apart and cut off the rest. In the third year’s late winter, completely remove all of the old wood. It is also necessary to thin the fresh shoots more. This pruning technique should enable you to take pleasure in blossoms every spring because lilac wood must be three years or older before it blooms.
Within a few years, with the right pruning, an old, overgrown lilac can be converted into a robust, appealing shrub. Pruning should be a frequent component of the lilacs’ management regimen after they have been revived. By cutting a few of the oldest branches every three to five years, the shrub can be kept strong and healthy.
(This article, which first published in the Sunday edition of the Lincoln Journal Star Newspaper in February 2005, has since been amended. Consult the Terms of Use for details on how to copy this content and use any images or visuals.)
Should lilacs be pruned?
An old, overgrown lilac was one of the few plants that endured my garden restoration. The fact that it obscured my neighbor’s garage and, more importantly, sported steel-blue double flowers, led me to rescue it. Although the blossoms on this shrub were both lovely and fragrant, it was difficult to appreciate them because there were so few of them. I decided to go with a rejuvenation pruning because I knew there was no reason to give up on this long-neglected plant because lilacs can handle severe pruning.
On stems that are no older than five or six years, the common French lilacs (Syringa vulgaris cvs.) yield the most and the largest flowers. The flowers get fewer, smaller, and farther away as the stems get older. A lilac, however, may reliably produce blossoms for decades with the right trimming. The method you choose will depend on how old your shrub is. Plants are maintained annually to keep them healthy. A more drastic trimming may be necessary for lilacs like mine that have seen better days.
Lilacs should be clipped annually to encourage healthy stem development and strong growth that improves flowering. Cutting sick, deformed, and unproductive stems to the ground constitutes annual pruning. I thin and cut back some stems as well to promote healthy, evenly spaced growth. To prevent them from growing too far away from the centre of the plant, I also pruned a few of the new shoots that emerged from the roots. I left a few inches between each stem to prevent crowding. Since they produce the most, I maintain the pencil-thick shoots that extend all the way to the ends of the branches. Small, twitchy growth is unproductive and won’t blossom. This growth can indicate an excess of aged, unproductive stems or too much shadow. Remove stems as soon as possible after blossoming, or in late winter if you don’t mind losing a few blooms. Cut off stems and shoots at or just below the soil line.
Dwarf lilacs rarely need pruning
Both the “Palibin” Meyer lilac (Syringa meyeri “Palibin”) and the “Miss Kim” Manchurian lilac (Syringa pubescens ssp. patula “Miss Kim”) are twiggy-habiting, somewhat small lilacs. On these types, just deadheading is needed in terms of pruning. You can prune some of the older stems as the plants get older to make place for younger, more robust stems. In contrast to regular lilacs, these plants hardly ever spread out of control. They might never need to be entirely regenerated if you only undertake a tiny amount of trimming every few years.
After the blooms have faded, deadheading, another aspect of annual maintenance, should be carried out as soon as feasible. Just above the two new shoots that slant out from the stem that stopped with the old bloom, the base of the old flower cluster should be cut off. The new shoots will develop throughout the course of the summer, produce flower buds, and culminate in a cluster of flowers the following spring. While not as crucial as the annual thinning, eliminating the old blossoms enables the plant to focus more of its energy on developing robust branches and flower buds. In June, I deadhead and thin my plants as needed.
While performing this yearly maintenance, I occasionally come upon a young, robust shoot that may be getting too tall but is still a good, productive stem and is a candidate for tipping off. I cut the wasted flower’s entire top stem back to one or two side shoots at the desired height rather of just cutting it off at the base. The side shoots that are now near the top of the bush are encouraged to grow vigorously and develop flower buds for the following year by this cut, which also aids in shrinking the shrub.
My own old, overgrown lilacs need more severe pruning. I went outside in the early spring before growth got going to get a good look at the bush. I looked to see if the plant had been grafted before I began chopping. I immediately cut it down to the ground as it hadn’t (for a grafted plant, see the panel below). I recognised that this drastic trimming would result in the plant losing part of its aesthetic appeal for a few years because lilacs bloom on the growth from the previous season. However, I was also aware that the reward—more blossoms and a stronger plant—would be worthwhile.
It’s crucial to nourish the plant after rejuvenation pruning with compost, composted manure, or a balanced chemical fertiliser and to make sure the soil pH is close to neutral, which lilacs appreciate. In the upcoming years, these supplements and some high-quality mulch will help to encourage vigorous new growth and enhanced flowering.
Has your lilac been grafted?
If your lilac has been grafted, check it out before you start making cuts to the stems. Grafting is a method of plant multiplication in which the scion, or branch, of one species is joined to the rootstock, or stem, of another species. This is typically done to enhance a plant’s look or traits. A graft union, where the cultivar’s scion wood joins the rootstock several inches above ground level, should be obvious. An apparent change in the bark from the rootstock to the scion’s bark, as well as a little swelling at the graft union, are things to watch for. If your plant has been grafted, all of your cuttings must be made above the graft union, and you must prevent shoots from the rootstock from developing into new flowering stems. Flowers of the desired shape or colour will not be produced by shoots that emerge from the rootstock.