Choose a suitable location on your succulent to make the cut. Make a quick, even cut through the succulent’s stem with your pruning shears to separate a cutting. Make sure that there is around 1 inch of stem exposed on the cutting before planting. The bottom leaves of the cutting might need to be removed for this.
Let the Cutting Callous
It is not possible to immediately put the cutting in the ground after it has been taken. Allow the “damaged” stem of the cutting to callous over for 24 hours by setting the cutting aside in a dry place. The stem should be healed and not seem to be “wet” in any regions after 24 hours. It’s now time to plant the cutting.
Plant the Cutting
Put a succulent mix or well-draining soil in a small terracotta or plastic planter. Make a tiny hole in the middle of the soil, and after placing the succulent cutting’s stem there carefully, firm the earth up around it. To prevent rot, make sure the cutting’s lowest leaf is perched just above the surrounding soil.
After planting, avoid watering the cutting. Give the newly planted succulent cutting two or three weeks in a spot with bright, indirect sun.
Begin Watering Once Roots Sprout
It’s crucial to hold off on watering a fresh succulent cutting until the roots have formed, unlike when propagating other plants. Since succulents don’t need much water to begin with, watering a cutting before it has roots might cause the cutting to decompose under the soil very rapidly. Succulent cuttings may go quite a while without water, so don’t worry!
Give the cutting’s top a little push to check for roots after letting it sit for two to three weeks. If there is any resistance, the cutting can now be watered because the roots have started to form. Once the cutting has grown roots, it might need to be watered more frequently than usual succulents until it becomes established. Make sure the top inch of the soil dries out between waterings to prevent overwatering.
Patience, Patience, Patience!
Be patient while you take care of your new plant because succulent cuttings grow slowly. But after a few months after planting, you should start to see fresh growth.
Growing succulent cuttings can be gradually put back into stronger lighting as they become older, eventually reaching the full sun conditions that most succulents enjoy. Remember that succulent cuttings are susceptible to death from excessive affection. Once the soil dries out, they simply require light watering because they thrive on neglect.
Gather Your Succulents To Plant
For this video, we’ll be planting a variety of succulent species using both cuttings and discarded leaves. Amass the materials you want to plant. You can either utilize fallen leaves or cut cuttings from an established plant. If you can’t locate cuttings anywhere else, you can usually find them online and at most florists. Although these are also available on Amazon, I got mine from a vendor on Etsy.
Prepare your succulents for planting.
The most crucial step in this method is preparing your succulents. Make sure you have enough stem to plant in the ground so it can support the plant. Any excess leaves at the stem’s base should be removed. It’s good to leave approximately an inch of the stem exposed for larger cuttings, and you can use less for smaller cuttings.
After that, examine the base of your cutting. The plants ought to have a “callous” on them, which denotes that the plant’s base has dried out. You should wait a few days before planting freshly cut succulents because this forms a few days after the succulent is cut. By letting the cut end dry more quickly on a paper towel or paper bag, you can hasten this process.
Succulents are wonderful because you can also plant their leaves, so hold onto the ones you pulled off the stem. Verify your succulents for any bad components. Any area of the plant that is dark contains rot, which can spread to other areas and ultimately destroy the plant. Simply cutting it will allow you to get rid of the rotten parts.
Mix your soil.
If you aren’t using a pre-made succulent soil mix, you’ll need to prepare your soil so that it will drain effectively and support the growth of your succulent plants. To make the soil drain well, I combine one part potting soil with one part sand. In order to help larger plants become more firmly rooted in the ground, I also prefer to have a supply of tiny rocks nearby.
To fill a pot or tray, pour your soil mixture. I’m repurposing an old baking pan that I can’t bake in as a planting tray.
Plant!
We’ve reached the enjoyable part now! Make a little, inch-deep hole in the ground. After inserting your cutting, fill up the depression with soil.
Make careful to space your cuttings, if you’re planting more than one, roughly 2-3″ apart.
Ensure that your plants receive adequate water. Although succulents don’t often require much water, you may need to water them every 2-4 days while they are developing their roots, depending on how dry the soil becomes. It’s normal for the leaves to initially appear a little dried out because the plant is using its reserves of stored energy to develop new roots. New growth should begin to appear in around four weeks. Change to weekly watering or watering only when the soil is dry once the plants have set their roots and have started to grow.
Admire and Show Off Your Work!
Well done! Show off your incredible craftsmanship and green thumb to all of your friends! These plants will be prepared for repotting if you desire once they have developed roots and begun to grow, which should take around 3 to 6 weeks. They make wonderful Christmas gifts for friends and coworkers when planted in a tiny Mason jar or vibrant pot!
Can succulent cuttings be planted directly in the ground?
What is there to love other than a succulent? Obviously, a full garden of succulents! Fortunately for us, it’s simple to propagate a variety of these resilient, vibrant plants at home. We can’t wait to see succulents growing all year long in containers around the house and garden; there are various easy ways to reproduce them.
Propagating by Division: Plants that have gotten too leggy perform best with this method, which produces new succulents from cuttings. Start by delicately removing any leaves that may be attached to the stem below the rosette; be sure to preserve the leaf’s base while you do so. After all the leaves have been eliminated, cut the rosette with shears, leaving a brief stem intact. The cuttings should be let to dry in an empty tray for a few days until the raw ends have calloused. The cuttings can then be rooted in either water or soil.
Soil: After the stems have calloused, set the cuttings on top of a shallow tray filled with well-draining cactus/succulent soil. From the base of the cuttings, roots and little plants will start to emerge in a few weeks. Once the roots start to show, water sparingly once a week; take care not to overwater. The parent leaf will eventually wither; carefully remove it while taking care not to harm the young roots. Your propagated succulents can be replanted once they have established roots. As soon as the plants are established, keep them out of direct sunlight.
Water: After the stem has calloused, place a cutting with the end barely visible above the water’s surface on the lip of a glass or jar filled with water. Pick a sunny location for your glass. The incision will eventually produce roots that extend toward the water. Once roots have sprouted, your new succulent can either be replanted in succulent potting soil or allowed to remain submerged in water as illustrated above.
Offsets are little plants that develop at the base of the main specimen, and many species of succulents, such as aloe, hens and chicks, and some cacti, will generate them. Check for root growth after an offset has developed for two to three weeks before carefully twisting, cutting, or using a sharp knife to separate it from the main stem. Be cautious to prevent destroying any already-formed roots. Follow the directions above for propagating in soil or water, letting the offsets dry, establish roots, and then repot when they have had time to callus any exposed regions. Removing offsets has the added benefit of enhancing the health of your current succulents and redirecting energy into the growth of the primary plant.
How should a succulent cutting be replanted?
Any room with adequate lighting gains dimension and color from succulents. The best part is that once you have one succulent, you may generate your own baby succulents by growing numerous additional plants from cuttings.
Everything you need to know about growing succulents from cuttings, including how frequently to water them, the best soil, and indoor growing techniques, is provided here.
Here’s how
Step 1: Carefully separate a leaf from the main stem where it is fastened. The leaf should separate completely and cleanly. Alternately, you might neatly chop off a piece of the stem.
Step 2: After 2-3 days, until a callus forms over the end of the cutting or leaf, place it in a bright area.
Step 3: Once produced, you may either lay flat on the ground and watch it grow or plant it directly into the ground (callus first). When erratic weather knocks off leaves, new puppies often emerge from the discarded leaves in this manner.
Step 4: In a container that is protected from the elements but has a fresh airflow, submerge the cutting or leaf’s root in 1 centimeter of water. Create a lattice with rubber bands if you’re using leaves to help them stand upright.
Step 5) Hold off till roots and young succulents appear. Small, pink strands will appear to be the roots.
Step 6) After the roots reach a length of 1-2 cm, remove the plant from the water and place it in a container with drainage holes and succulent potting soil. Drink water as needed.
Where to plant succulents
Succulents prefer full sun and can be grown indoors as well as outside in terrariums and pots. Keep them in a bright area with plenty of light, and consult the plant label for the best growing conditions.
Succulents may grow in almost any type of container. Make sure the container has adequate drainage and area for the roots to spread, and choose a specialty potting soil, frequently offered as a succulent and cactus mix. Check out this article to learn how to grow them in fun places like old frames, shells, bowls, and other containers besides just pots.
What should you do if your succulents multiply?
As it is simpler than using leaves or stem cuttings, the majority of succulent parents prefer to propagate their offspring via offsets. Offsets make for incredibly simple and straightforward propagation, making it ideal for individuals who don’t want to wait for the plant to develop leaves. Succulents like the Haworthia are ideal for this technique.
It is strongly advised to hold off until the offsets are around half the size of the parent plant to make sure they have the nutrients they need to live after being cut off from the parent plant. In order to find the rooted offset from the parent plant, you might want to start by thinking about removing the plant from its container. This is also an opportunity to repot the plant and check the root structure. Then, just twist the offset to remove it from the mother succulent’s roots. If some roots are torn, it won’t matter because the offset will have an opportunity to build its own roots. After removing the offsets successfully, allow them to dry for one to one day. After they have dried out, put them in cactus soil that drains well and water them thoroughly.
Cutting off the offset’s stem or plucking offsets from the parent plant with roots are two ways to propagate from offsets. Therefore, scroll up to read our instructions on how to take a correct cutting if you want to try doing it using stem cuttings. Use only sterilized pruning implements at all times. Place your cuttings in a well-drained potting mix after allowing them to dry completely. Within a few weeks, roots ought to develop.
Maintaining the offsets is really easy. To prevent etiolation or sunburn, you should give them a few hours of morning sunlight or afternoon shade. One piece of advice is to only water them thoroughly when the soil is absolutely dry.
And voilà! That is how you successfully develop your own succulent garden and propagate your succulents. Not too difficult, am I right? To determine the ideal amount of light and water that works for your succulents and encourages new development, we suggest you to experiment with a variety of leaves and stem cuttings. Tell us how your propagation process is going!
Watch this little video to learn how to avoid four mistakes while cultivating succulents.
You may read more about propagating succulents in the following articles:
Why aren’t the roots on my succulent cuttings forming?
You recently purchased some gorgeous succulent cuttings from a nursery in your neighborhood, or even better, online with free shipping. The cuttings you purchased are incredibly lovely, and you can’t wait to see them take root, develop, and flourish just as you anticipate!
Sadly, weeks have passed and your succulent cuttings haven’t even the least bit rooted! Now that the succulent cuttings appear dried up, wrinkled, or dying, you’re probably wondering why they aren’t taking root.
Be kind to yourself because this is something that occurs frequently. Rooting succulent cuttings is a challenge for many succulent growers, especially beginners. Especially if you recently purchased these cuttings and they aren’t rooted, it might be really discouraging.
Your succulent cuttings not rooting for a variety of reasons. It can be the result of overwatering, underwatering, insufficient sunlight, a lack of nutrients, improper soil use, or improper potting.
Not to worry! By the time you finish reading this article, you’ll understand exactly why your succulent cuttings aren’t rooted and how to fix the problem.
How can you root succulents the quickest?
So, you may be wondering how to quickly propagate succulents. I can relate to both the joy and frustration of watching a new plant develop.
Since I’ve been growing succulents for a few years, allow me to give you some advice on how to quickly propagate your succulents as well as some alternative techniques you can try.
Stem cuttings are the simplest and quickest method of propagating succulents. If the plant is a fresh cutting from the mother plant, it will already have a strong foundation from which to build its new root system. Another instance is when you cut off the succulent’s top portion because it has been stretched out significantly (etiolation), this stem will likewise give rise to numerous new plantlings (pups). Due to its existing root system, the plant will also have a great possibility of producing more offset and growing quickly.
Always check that the stem cuttings are a respectable size for the plant’s typical size.
According to my experience, I always want to make sure that the succulent has a lot of nodes where the leaves attach to the stem and a lot of leaves in its stem. Once the succulent is put in soil, these stem nodes will form roots, and the leaves will serve as the succulent’s water source until its root system matures.