Propagation of Monstera adansonii is not too difficult, like many other vining plants. Both water and soil can be used for this. It won’t grow as much as it would in soil, but you can leave it in water indefinitely if you like.
Monstera adansonii propagation in water
- Use clean scissors to make a cutting with a few leaves from the mother plant, cutting about 1/4 inch below a node, to propagate Monstera adansonii in water (this means the node is included on the cutting). The new roots will emerge from the nodes.
- Leave a few inches of stem bare by removing any bottom leaves.
- Make sure at least one node of the cutting is submerged in the water before placing it in the glass. Inspect the leaves to make sure none are submerged.
- The cutting should be placed where there is plenty of indirect light.
- Make careful to replace the water when it becomes murky and to top it off when you notice the level dropping.
- Within the first week or two, you should notice tiny roots emerging, but it can take a few weeks before you can plant your cutting into soil.
- Transfer the cutting to its permanent pot once the roots are a few inches long. According to my observations, the roots can be transmitted over a distance of two to three inches.
- After putting the cutting in its new pot, give it the same attention and watering that you typically would.
Monstera adansonii propagation in soil (method one)
Repeat the first step above in order to spread Monstera adansonii in soil. Here it is once more:
- Cut a few of leaves off the mother plant using clean scissors, about a quarter-inch below a node (this means the node is included on the cutting). The new roots will emerge from the nodes.
- Leave a few inches of stem bare by removing any bottom leaves.
- Now, bury at least one node of the cutting by placing it directly into moistened soil as opposed to submerging it in water. No leaves should be buried.
- As the roots grow, place the cutting in indirect light that is bright and maintain the soil moist but not damp.
- To further lock in the advantageous humidity, you can cover the top with a transparent plastic bag. Make careful to take the bag out once day to allow for fresh air.
- Be patient; it will take at least a few weeks before the cutting’s root system emerges and you see any new growth.
- You can test the cutting by giving it a very light tug a few weeks later. If you encounter resistance, the roots have established, and you can proceed as you would with any other plant.
Monstera adansonii propagation in soil (method two)
Another way to propagate Monstera adansonii (and other vining plants) is to lay the entire cutting on top of the soil with the nodes all pointing downward into the soil.
Instead of leaving the vine as one continuous vine, you can also break it into smaller portions and do this; just make sure each section has a node.
- If necessary, temporarily “fasten the vine or its portions to the ground using paper clips or bobby pins.
- As the roots grow, place the plant in indirect light that is bright and maintain the soil moist but not soggy.
This will also help the nodes that are in contact with the soil finally take root.
Can Monstera be grown from seed directly in the ground?
Many people think that water propagation is the best or even the sole method for growing a new Monstera deliciosa from a cutting. However, a Monstera cutting can be grown in soil without first establishing the roots in water. Both approaches are effective, though many plant owners pick the approach they believe gives the most benefits.
It is simple to grow Monstera deliciosa from seed in soil. Simply take a healthy Monstera cutting with at least one node, and plant it into potting soil with good drainage. By using soil to root Monstera cuttings instead of water, the subsequent step of transferring the rooted cutting into soil is avoided.
People prefer to grow their plants in soil rather than water for a variety of reasons. Some people might discover that employing soil propagation is a simpler process or that their Monstera produces new growth more quickly. Some people have curious cats that won’t leave a water container alone. Additionally, some owners of indoor plants simply want to experiment with new methods of growing this well-liked plant.
Which is preferable for Monstera Adansonii propagation—soil or water?
No matter which of the nine varieties of Adansonii you have, you can propagate them all using the same method.
Your own preferences and the resources you have available will determine whether you choose to spread your monstera adansonii using water, soil, or moss.
All three techniques are equally successful, however I think growing the adansonii in water is the simplest. I advise rooted your adansonii in water if you’re a newbie.
Select the soil propagation method if you want to multiply your Swiss cheese vine quickly and with the fewest number of steps possible.
And finally, growing a monstera adansonii in moss usually results in a tough plant if you have some experience with aroids and air layering.
Which is preferable for Monstera propagation—soil or water?
Even while Monstera cuttings are generally fairly tolerant of the growing medium, location, and conditions, there are still a few things you may change to boost your chances of success or hasten your progress.
Time of year
It is not necessary to timing when you take a cutting, but keep in mind that winter, when plants are often dormant, may cause your cutting to start more slowly.
Time frame
The first thing to stress is the importance of patience. Some cuttings will immediately take root and quickly produce new leaves. Others may experience a protracted period of inactivity. Spring will frequently revive cuttings that had been dormant.
The best way to determine if your cutting is still in good shape while doing nothing is described below.
Light and warmth
Monstera cuttings thrive in warmth and light, and they will grow the quickest on a warm, sunny windowsill. It has been said that Monstera cuttings should be started with a heat pad, but in my experience, that is not true. A heat pad, however, could perhaps hasten the growth process.
Moisture
If they are in soil, they must also be maintained gently damp but not wet—wet feet are bad for them and will cause them to decay. Once a week, check their soil and, if it feels dry, give it a little water. It is not necessary to place a plastic bag over them, as is occasionally advised.
Size of cutting
More nodes and longer or larger stem sections tend to produce more new growth, including several new stems. Given that Monstera is a vine plant with a single long stem, this is significant. If your cutting produces leaf sprouts on several nodes, each of these will grow into a stem, resulting in bushier growth at a small size.
Growing medium
The benefit of propagating in water in a glass jar is that any new growth is visible right away. However, it is usually advisable to plant larger cuttings directly in the ground if they have leaves and aerial roots.
Water choice
You can use conventional tap water, but if it’s particularly hard, use caution and avoid using water that has been artificially softened. Both rainwater and distilled water are acceptable. If you submerge the majority of the stem part in water, leaves and roots will grow rather happily.
Soil mix
Use a light, freely draining potting compost when young plants and a more hummus-rich mixture as they mature.
Planting stems vertically with just the top inch above the soil is the simplest and most space-efficient approach to pot cuttings in soil.
I was concerned that for new leaves to grow, some stem nodes would need to be above the surface, but that wasn’t the case at all. Under the soil surface, new leaves began to emerge and easily pushed their way to the surface to spread out.
Potting up
If you have many stem cuttings that are housed in the same pot, you should separate them as soon as new growth appears. My own experiences indicate that, if handled correctly, Monstera are fairly resilient and don’t mind being disturbed.
You can bury the entire original stem cutting for a neater appearance rather than having to leave any of it above the soil line.
How long does it take Monstera to bury itself in the ground?
You should plan on giving your Monstera cutting around 6 weeks before planting it in soil so that roots can form.
In order to guarantee a strong root system has established for a better chance of survival, I often advise waiting at least 2-3 months.
However, as long as you change the water frequently, clean the roots, and transfer the cutting into a larger jar as it grows, a Monstera can survive in water for many months (if not years).
It is prepared to be put in soil when a lovely cluster of roots fills your container.
You can plant your Monstera cutting as long as it has five roots that are at least several inches long.
Keep the Roots Clean
Keep an eye on the roots as they grow every week, and don’t be hesitant to cut off any sections that seem unhealthy.
You can clip out roots that appear to be rotting as long as there are numerous healthy-looking roots (white, yellow, light green, and light brown).
These are typically distinguished from the others by being dark, mushy, or significantly more slimy.
How much time does a Monstera cutting require to root in soil?
You followed our advice on propagation first, and now you want to know when to plant your new Monstera. Wait until the longest, whitest, fuzzy roots may branch off into numerous, smaller roots. It is appropriate to bury your Monstera cutting in soil once these little feeder roots have grown to at least 3 inches (8 cm) in length.
Comparing the root volume to the size of the pot you want to put it in will help you determine when your cutting is ready to be planted. For instance, when the root volume of a small Monstera, such as an adansonii, could fit in a 2 inch (5 cm) container, the cutting might be planted (alone or with other cuttings).
I often wait until the roots of a Monstera deliciosa, which has stronger roots, can fill a 3.5 inch (9 cm) pot. I wait till the roots of an albo variegated Monstera deliciosa can fill a 4.5 inch (11 cm) pot. When an albo Monstera cutting is planted, the chance of leaf loss from transplant shock is reduced because the cutting has more roots.
How long does it take for a Monstera cutting to root?
The length of aerial root that is available determines how long it will take a Monstera cutting to root. Additionally, it depends on whether the aerial root was expanding actively prior to the cutting.
Usually, short aerial roots grow into a single, long new root. Longer aerial roots have the ability to begin producing new roots from both the sides and the tip, hastening the rooting process. Without aerial roots, monstera cuttings must develop a new root from within the stem, which takes more time.
A Monstera deliciosa cutting with aerial roots that are actively growing ought to take root quite rapidly. The color and texture of the aerial root can be used to determine its age. It is new if it is flexible and white, light brown, or green in color. It will take a lot longer to begin producing new roots if it is stiff, dark in color, and has a lot of bark flaking off.
The aerial root typically transforms into a white, fluffy true root after a few weeks. The process of delaying feeder roots then requires a few more weeks. From the time the first fuzzy white root appears until your Monstera cutting is prepared for planting, allow a minimum of six weeks.
When a monstera root is in contact with a surface, feeder roots form more quickly. Try to use a short container while growing plants in water so that the root tip will immediately contact the bottom. The root will continue to grow without branching if the water is too deep.
I’ve had success using LiquiDirt to induce quicker root growth once roots have begun to emerge.
Switching straight from water to soil
Once your Monstera has enough roots to make the shift from its propagation medium to soil, remove it. For your roots, the switch from water to soil propagation is a significant one. This transition is more difficult than moving from moss or perlite to soil for propagation.
When you plant a Monstera cutting in soil, part of the roots may dry up or die if there aren’t enough of them. The “water roots” do not have as much fuzzy root hair to absorb water because they are accustomed to being constantly moist. They need some time to develop more fuzz so that they can absorb water from the earth.
Assume that up to one-third of the roots of your Monstera cutting will be harmed or die. You need to make sure that the new plant will be able to survive on the remaining roots.
You won’t harm your Monstera plant if its propagation media has too many roots growing in it. The nutrients in the soil and the microbiome of helpful bacteria that support soil roots are the major things you are losing out on. Your cutting will grow more quickly if you place it in soil.
I make an effort to take too many roots too lightly. I want to ensure that my cuttings survive the switch, even if they develop a little bit more slowly in the interim.
Switching to another medium before soil
Switching from water to soil is fine for low-cost plants. Try using perlite or moss instead of soil for pricey albo Monstera cuttings or any plant you want to be particularly cautious with.
Start propagating in water and continue doing so until your cutting starts to root. After that, while the roots are developing, swap to wet perlite or moss. In a firm medium, roots will branch out more and develop more fuzz. As a result, the plant’s roots are already prepared to absorb water from the soil, which lessens stress during the transition to soil.
Can Monstera live in water forever?
Your Monstera can be kept in water or some alternative media if you don’t want to plant it in soil. While water is sufficient on its own for proliferation, fertilizer is required to keep your Monstera in water over the long term.
Growing Monstera with Hydroponics
You must supply nutrients to the water when growing plants hydroponically for the growth to continue. There are three stages to permanently submerge your Monstera.
First, make frequent water changes. To prevent the growth of mold or algae, rinse the roots and maintain the container tidy.
A N-P-K fertilizer made specifically for hydroponics, like Dyna-Gro Foliage-Pro 9-3-6, should be used next. A nutrition solution is made of of water and fertilizer. To view the most recent pricing on Amazon, click the image or link.